Charge Density Waves in Graphite: Towards the Magnetic Ultraquantum Limit

Graphite is a model system for the study of three-dimensional electrons and holes in the magnetic quantum limit, in which the charges are confined to the lowest Landau levels. We report magneto-transport measurements in pulsed magnetic fields up to 60 T, which resolve the collapse of two charge density wave states in two, electron and hole, Landau levels at 52.3 and 54.2 T, respectively. We report evidence for a commensurate charge density wave at 47.1 T in the electron Landau level, and discuss the likely nature of the density wave instabilities over the full field range. The theoretical modeling of our results predicts that the ultraquantum limit is entered above 73.5 T. This state is an insulator, and we discuss its correspondence to the "metallic" state reported earlier. We propose that this (interaction-induced) insulating phase supports surface states that carry no charge or spin within the planes, but does, however, support charge transport out of plane.

NMR signature of one-dimensional behavior of 3He in nanopores

We have performed thermodynamic and NMR relaxation time measurements of 3He adsorbed in the pores of the mesoporous molecular sieve MCM-41 at temperatures down to 1.7 K and at a range of frequencies up to 240 kHz. The MCM-41 substrate comprises a uniform array of quasi-1D straight pores with a diameter of 2.3 nm. We preplated the pores with a monolayer of 4He to achieve an effective diameter of 1.6 nm at low temperatures. We made NMR measurements as a function of line density and frequency to investigate the spin dynamics and the effect of dimensionality. We observed T(1) is proportional to ω1/2, which is characteristic of one-dimensional diffusion. At these temperatures this arises from a classical size effect in the narrow pores. Our results demonstrate the possibility to study the spin dynamics of a 1D Tomonaga-Luttinger liquid at lower temperatures, where the 3He liquid will constitute a quantum 1D system.

Spear-anvil point-contact spectroscopy in pulsed magnetic fields

We describe a new design and experimental technique for point-contact spectroscopy in non-destructive pulsed magnetic fields up to 70 T. Point-contact spectroscopy uses a quasi-dc four-point measurement of the current and voltage across a spear-anvil point-contact. The contact resistance could be adjusted over three orders of magnitude by a built-in fine pitch threaded screw. The first measurements using this set-up were performed on both single-crystalline and exfoliated graphite samples in a 150 ms, pulse length 70 T coil at 4.2 K and reproduced the well known point-contact spectrum of graphite and showed evidence for a developing high field excitation above 35 T, the onset field of the charge-density wave instability in graphite.

Selenomethionine content of candidate reference materials

Selenium has been identified as an antioxidant of importance in the diet. Accurate determination of its chemical forms depends on the availability of suitable reference materials (RMs). Two candidate reference materials for determination of selenomethionine (Semet) in food-related materials, a standard wheat gluten sample (NIST RM 8418 Wheat Gluten) and a commercial selenium enriched yeast, have been examined by use of a gas chromatography-isotope dilution mass spectrometry (IDMS) procedure, after treatment of the matrix with 0.1 mol L(-1) hydrochloric acid containing stannous chloride, addition of CNBr, and extraction with chloroform. This procedure results in cleavage of the CH3Se group to form volatile CH3SeCN. Addition of isotopically enriched 74Semet to an analytical sample enables estimation of the naturally occurring protein-bound 80Semet by IDMS without a protein-digestion process. We found that the Wheat Gluten RM contains a significant amount of Semet as a portion of its assigned value of 2.58 microg Se(total g(-1). Commercial selenium yeast tablets are labeled as containing an elevated level of "organic selenium", usually as Semet. The sample we investigated contained 210 microg Se(total) g(-1) sample as determined separately by IDMS, measuring elemental selenium after digestion. 73% of this total (153 +/- 21 microg Se(semet) g(-1); n = 23) was present as Semet. Thus, these two materials contain significant amounts of their total selenium content as Semet and would be good candidates for further study and characterization as reference materials for determining this important food component. The CNBr reaction used will also enable the determination of Se-(methyl)selenocysteine, the biological role of which is of recent interest. In addition to matrix RMs for Semet, it is important to have standard materials of the pure substance. We have examined a sample of a candidate standard material of selenomethionine being prepared by the USP. It was confirmed that this material is pure selenomethionine.