Associating Physical and Photocatalytic Properties of Recyclable and Reusable Blast Furnace Dust Waste

Blast furnace dust waste (BFDW) proved efficient as a photocatalyst for the decolorization of methylene blue (MB) dye in water. Structural analysis unequivocally identified α-Fe2O3 as the predominant phase, constituting approximately 92%, with a porous surface showcasing unique 10-30 nm agglomerated nanoparticles. Chemical and thermal analyses indicated surface-bound water and carbonate molecules, with the main phase's thermal stability up to 900 °C. Electrical conductivity analysis revealed charge transfer resistance values of 616.4 Ω and electrode resistance of 47.8 Ω. The Mott-Schottky analysis identified α-Fe2O3 as an n-type semiconductor with a flat band potential of 0.181 V vs. Ag/AgCl and a donor density of 1.45 × 1015 cm-3. The 2.2 eV optical bandgap and luminescence stem from α-Fe2O3 and weak ferromagnetism arises from structural defects and surface effects. With a 74% photocatalytic efficiency, stable through three photodegradation cycles, BFDW outperforms comparable waste materials in MB degradation mediated by visible light. The elemental trapping experiment exposed hydroxyl radicals (OH•) and superoxide anions (O2-•) as the primary species in the photodegradation process. Consequently, iron oxide-based BFDW emerges as an environmentally friendly alternative for wastewater treatment, underscoring the pivotal role of its unique physical properties in the photocatalytic process.

Evaluating the roughness dynamics of kefir biofilms grown on Amazon cupuaçu juice: a monofractal and multifractal approach

We conducted a comprehensive analysis of the surface microtexture of kefir biofilms grown on Theobroma grandiflorum Shum (cupuaçu) juice using atomic force microscopy. Our goal was to investigate the unique monofractal and multifractal spatial patterns of these biofilms to complement the existing limited literature. The biofilms were prepared dispersing four different concentrations of kefir grains in cupuaçu juice. Our morphological analysis showed that the surface of the obtained biofilms is essentially formed by the presence of cupuaçu fibers and microorganisms like lactobacilli and yeast. The topographic height-based parameter analysis reveals that there is a dependence between surface roughness and the concentration of kefir grains used. The strongly anisotropic well-centralized topographical height distribution of the biofilms also exhibited a quasi-symmetrical and platykurtic pattern. The biofilms exhibit comparable levels of spatial complexity, surface percolation and surface homogeneity, which can be attributed to their similar topographic uniformity. This aspect was further supported by the presence of similar multifractality in the biofilms, suggesting that despite their varying topographic roughness, their vertical growth dynamics follow a similar pattern. Our findings demonstrate that the surface roughness of kefir biofilms cultivated on cupuaçu juice is influenced by the concentration of kefir grains in the precursor solution. However, this dependence follows a consistent pattern across different concentrations. Graphical Abstract.

Advanced nano-texture, optical bandgap, and Urbach energy analysis of NiO/Si heterojunctions

Due to the large number of industrial applications of transparent conductive oxides (TCOs), this study focuses on one of the most important metal oxides. The RF-magnetron sputtering method was used to fabricate NiO thin films on both quartz and silicon substrates at room temperature under flow of Argon and Oxygen. The sputtered samples were annealed in N₂ atmosphere at 400, 500, and 600 °C for 2 hours. Using the AFM micrographs and WSXM 4.0 software, the basic surface parameters, including root mean square roughness, average roughness, kurtosis, skewness, etc., were computed. Advanced surface parameters were obtained by the Shannon entropy through a developed algorithm, and the power spectral density and fractal succolarity were extracted by related methods. Optical properties were studied using a transmittance spectrum to achieve the optical bandgap, absorption coefficient, Urbach energy, and other optical parameters. Photoluminescence properties also showed interesting results in accordance with optical properties. Finally, electrical characterizations and I-V measurements of the NiO/Si heterojunction device demonstrated that it can be used as a good diode device.

Morphological and multifractal properties of Cr thin films deposited onto different substrates

In this study, the morphological properties and micro-roughness of chromium thin film prepared by thermal evaporation technique and confirmed via EDS analysis are examined on different substrates of BK7, Silicon (Si), and glass using atomic force microscope analysis (AFM). Analysis of amplitude parameters, Minkowski functionals, and films' spatial microtexture extracted from AFM analysis showed the difference between glass substrate and the other two (BK7 and Si) substrates for the growth of chromium thin films. In addition, we observed robust signatures of multifractality of the Cr thin films deposited on all substrates we studied. Moreover, we highlight that the Glass substrates displayed the strongest multifractality indicating that such samples present space filling properties distributed over more spatial scales than the samples of BK7 and Si.

Stereometric analysis of Amazon rainforest Anacardium occidentale L. leaves

AFM, profilometry and SEM measurements on both sides of the Anacardium occidentale L. leaf reveal that ultrastructure presented some singularities due to their different morphologies and roughness. The advanced stereometry and power spectrum density of both sides of the Anacardium occidentale L. leaf were carefully studied. We use three different microscopy techniques such as scanning electron microscopy, profilometry, and atomic force microscopy for a complete description of the leaf surface morphology. The morphology of the adaxial and abaxial sides revealed a surface composed of striated cuticles and stomata cells, respectively. The height parameters obtained by profilometry revealed that the abaxial side was rougher. However, both sides presented similar Gaussian height distribution and asymmetry. The advanced stereometric parameters obtained by the topographic maps of AFM revealed that the two sides have some singularities due to their different morphologies and roughness, but with similar microtextures. However, average PSD spectra showed that adaxial and abaxial sides are dominated by relatively low and high spatial frequencies, showing that the microtextures, unlike what was shown in stereometric parameters, are different. These results revealed that leaves surface morphology under different aspects and scales and the quantitative parameters confirmed the different spatial patterns displayed, which can be of great interest for the study of the biological behavior of plants from their leaves.

3D micromorphology evaluation of kefir microbial films loaded with extract of Amazon rainforest fruit Cupuaçu

We performed qualitative and quantitative analysis of surfaces of kefir biofilms loaded with Amazon rainforest fruit extract. Scanning electron microscopy and atomic force microscopy were used to evaluate the micromorphology of the biofilms. The films surface displayed a lower density of microorganisms (∼ 0.061 microorganisms/μm²) for the lowest concentration of fruit extract, however, a greater density (∼0.220 microorganisms/μm²) was observed for the higher concentration. Height stereometric parameters revealed that the biofilms with the highest concentration presented the highest roughness. However, almost all the stereometric parameters related to texture showed no significant difference. Furthermore, the Hurst coefficients of the average power spectrum density were similar for all biofilms. Fractal parameters confirmed that higher concentrations of fruit extract induced a superior topographic irregularity. However, fractal lacunarity does not show any significant difference confirming the similarity of the microtextures. Moreover, fractal succolarity and surface entropy exhibited values that suggested ideal percolation and strong topographic uniformity, respectively, indicating that these films can uniformly adhere to other surfaces. Our results confirm that the stereometric and fractal parameters can be relevant for the surface characterization of microbial films, which can be of great importance to the biomedical field.

Structural evaluation of polymeric microbial films grown on kefir loaded with Maytenus rigida extract

Kefir is a probiotic that has several health promising properties. Its grains can form microbial films on different types of substrates. In the present work, the surface characteristics of kefir biofilms associated with Maytenus rigida Mart. extract were minutely studied. Three different concentrations of plant extract were included in the biofilm forming solutions, where fresh grains of kefir were inoculated. The results showed that the plant extract was successfully incorporated into the exopolysaccharide matrix of the biofilm. The main chemical components found linked to the plant extract were triterpenes. The crystallinity of biofilms increased with the addition of the plant extract. The morphology revealed that at low concentrations of the extract there was a prevalence of lactobacilli, while at high concentrations yeasts were more observed. Adhesion and wettability were higher for biofilm with less extract. These results revealed that a combination of plant extract and kefir's exopolysaccharide could form biofilms with chemical and topographic properties of great interest in regenerative medicine.

Advanced micromorphology study of microbial films grown on Kefir loaded with Açaí extract

In this work, an advanced analysis of the 3D surface microtexture of the microbial films grown on Kefir loaded with Açaí extract was performed. Atomic force microscopy was used to characterize the 3D surface microtexture data in correlation with the stereometric analyses to allow a better understanding of the surface micromorphology consistent with ISO 25178-2: 2012. Two new parameters, fractal succolarity and fractal lacunarity, have been inserted for a quantitative approach to microtexture. The results revealed that the morphology was affected by the increase of the Açaí concentration in biofilms, as well as the fractal succolarity and lacunarity. Adhesive bacteria of the genus Lactobacillus were observed for the lowest concentrations of Açaí. Moreover, it was found that the surface of the biofilms has shown saturation when the concentration has changed from 4 to 6 % of Açaí. These results are of great interest in the characterization of surfaces with promising application like skin dressing.

Encapsulation of Piper aduncum and Piper hispidinervum essential oils in gelatin nanoparticles: a possible sustainable control tool of Aedes aegypti, Tetranychus urticae and Cerataphis lataniae

BACKGROUND

The encapsulated essential oils (EOs) of Piper aduncum L. and Piper hispidinervum C. DC. in gelatin nanoparticles were evaluated against Aedes aegypti Linn., Tetranychus urticae Koch and Cerataphis lataniae Boisd.

RESULTS

Encapsulation efficiency of the EOs was measured for absolute concentrations of 500 µg mL^-1 (79.2 and 72.7%) and 1000 µg mL^-1 (84.5 and 82.2%). The loaded nanoparticles were nearly spherical and well dispersed. The nanoparticles loaded with P. hispidinervum EO had an average size of 100 ± 2 nm, while the nanoparticles containing P. aduncum EO ranged from 175 ± 4 to 220 ± 4 nm. According to zeta potential analysis, the nanoparticles loaded with P. hispidinervum and P. aduncum EOs presented values around -43.5 ± 3 and -37.5 ± 2 mV respectively. The controlled release of EOs was described by the anomalous mechanism of Korsmeyer-Peppas. Both encapsulated EOs reached lethal dosages within 24 h of exposure and total mortality of the tested pests.

CONCLUSION

The present work successfully developed gelatin-based nanoparticles that served as carriers for the EOs of P. aduncum and P. hispidinervum to be applied as a sustainable control tool of A. aegypti, T. urticae and C. lataniae. The developed loaded nanoparticles presented high encapsulation efficiency and EO concentration release higher than lethal dosages. This indicates that it is feasible to use gelatin-based nanoparticles loaded with P. aduncum and P. hispidinervum EOs to control the tested pests. © 2018 Society of Chemical Industry.