Leachability of automotive shredder residues burned in a fluidized bed system

This paper presents the results of the study of a combustible fraction of automotive shredder residues (CASRs) and the corresponding ashes generated by combustion on a fluidized bed pilot with the aim to understand the influence of thermal treatment regarding properties for final disposal, such as landfilling. The chemical composition was evaluated and the leachability behaviour of ashes and CASR was investigated using the three more commonly used tests: the European Standard EN 12457, the US TCLP-EPA 1311 and the Dutch availability test EA NEN 7371. Different results were obtained depending on the specific conditions of the methods employed. It was found that both the CASR and the ashes contained large amounts of toxic metals and other undesirable elements, such as Cl and S. For the CASR, in addition to the leachability of organic matter above the limit set for hazardous materials, the release of heavy metals, either under alkaline and acidic conditions was significant, revealing the serious risks associated to the landfilling practices still being undertaken worldwide. Release of organic matter from ashes was insignificant, but solubility of sulphates increased and chlorides exceed the hazardous limits in the case of fly ashes. Toxic metals were found to leach from the ashes only under acidic conditions, except Pb and Cu which also leached from finer ashes at alkaline pH. Cr also leached from ashes at alkaline pH values. Both the Dutch availability and TCLP revealed much higher leaching intensities than the European Standard due to the acidity of leachants. However, it was found that ashes may be more resistant to acidification because they exhibit much higher acid neutralization capacity (ANC) than the untreated CASR. The study undertaken shows that thermal valorisation of the combustible fraction of ASR may avoid the risks associated with their landfilling; however, care has to be taken with the ashes because they also behave as hazardous residues. Although, the mass reduction provided by thermal treatment may make landfilling less expensive, a more profitable reutilization of the ashes should be developed.

The behaviour of ashes and heavy metals during the co-combustion of sewage sludges in a fluidised bed

Co-combustion tests of dry sewage sludges with coal were performed in a pilot bubbling FBC aiming at the characterization of ashes and determining the behaviour of heavy metals in the process. The tests showed compliance with the regulatory levels as far as heavy metal emissions were concerned. The bottom ashes, which accounted for about 70% of the total ash production, were obtained in a granular form, with diameters ranging from 0.5 to 4 mm. The heavy metals were distributed in ashes obtained from different locations of the installation and their concentrations were found to vary depending on the location of capture. The increase in heavy metals content in bottom ashes was not found to lead to higher leachability and ecotoxicity compared to sewage sludges, suggesting that there could be opportunities for their further use. Mercury suffered vaporisation inside the reactor, thus leaving bottom ashes free of contamination by it. However, there was observed a strong retention of mercury in cyclone ashes due to the presence of unburned carbon which probably acted as an adsorbent. The effluent mercury was also found to be mostly associated with the particulate fraction, being less than 20% emitted in gaseous forms. The results suggested that the combustion of the sewage sludge could successfully be carried out and the amount of unburned carbon leaving the combustor but captured in cyclone was large enough to ensure substantial retention of mercury at low temperatures, hence could contribute to an improvement of the mercury release which still remains an issue of great concern to resolve during combustion of waste materials.