A sub-cc nonlinear piezoelectric energy harvester for powering leadless pacemakers

A miniature nonlinear piezoelectric energy harvester is developed to power state of the art leadless cardiac pacemakers from cardiac motions. The energy harvester is integrated in the leadless pacemaker and is connected to the myocardium. The energy harvester converts myocardial motions to electricity to power leadless pacemakers. The energy is stored in a battery or supercapacitor and is used for pacing. The device is composed of a bimorph piezoelectric beam confined in a gray iron frame. The system is assembled at high temperature and operated at the body temperature. The mismatch in the coefficients of thermal expansion of the beam and the frame causes the beam to buckle in body temperature. This intentional buckling makes the beam unstable and improves the power production and robustness of the device. Having high natural frequency is a major problem in microelectromechanical systems energy harvesters. Considering the small size of the energy harvester, 0.5 cm³, the natural frequency is expected to be high. In our design, the natural frequency is lowered significantly using a buckled beam and a proof mass. Since the beam is buckled, the design is bistable and nonlinear, which could increase the output power. In this article, the device is analytically modeled, and the natural frequencies and mode shapes of the energy harvester are analytically derived. The terms corresponding to geometric nonlinearities are included in the electromechanical coupled governing equations. The simulations show that the device generates sufficient electricity to power leadless pacemakers.

Erectile Dysfunction: An Underestimated Presentation in Patients with Diabetes Mellitus

INTRODUCTION

Erectile dysfunction (ED) is a common complication of diabetes mellitus. ED, like other sexual disorders, is often under-reported and under-diagnosed, as talking about sex is considered a taboo in our society.

METHODOLOGY

All the male patients with diabetes mellitus (with or without active complaints of ED) attending Medicine or Psychiatry OPD of the institute during the study period were enrolled in the study. They were investigated for their body-mass index (BMI), blood sugar and lipid profile; and were assessed on HAM-D, General Health Questionnaire-30, IIEF, sex myth checklist and QOL Instrument for Indian Diabetes Patients (QOLID).

RESULT AND DISCUSSION

In the present study, a total of 138 diabetic patients were assessed, and those with severe ED were found to have poor glycemic control, worse lipid profile, higher body mass index, later age of onset, and longer duration of untreated diabetes as compared to non-ED patients. ED patients also scored higher on depression rating scale, had poorer general health and quality of life (QOL). Early attention to ED in diabetic patients can improve general health and QOL of the sufferers.

CONCLUSION

DM patients with poor glycemic control and advanced age have a higher propensity of developing severe ED, which further deteriorates the already compromised health & QOL.

Experimental investigation of fan-folded piezoelectric energy harvesters for powering pacemakers

This paper studies the fabrication and testing of a magnet free piezoelectric energy harvester (EH) for powering biomedical devices and sensors inside the body. The design for the EH is a fan-folded structure consisting of bimorph piezoelectric beams folding on top of each other. An actual size experimental prototype is fabricated to verify the developed analytical models. The model is verified by matching the analytical results of the tip acceleration frequency response functions (FRF) and voltage FRF with the experimental results. The generated electricity is measured when the EH is excited by the heartbeat. A closed loop shaker system is utilized to reproduce the heartbeat vibrations. Achieving low fundamental natural frequency is a key factor to generate sufficient energy for pacemakers using heartbeat vibrations. It is shown that the natural frequency of the small-scale device is less than 20 Hz due to its unique fan-folded design. The experimental results show that the small-scale EH generates sufficient power for state of the art pacemakers. The 1 cm³ EH with18.4 gr tip mass generates more than16 μW of power from a normal heartbeat waveform. The robustness of the device to the heart rate is also studied by measuring the relation between the power output and the heart rate.

Inclusive search for supersymmetry using razor variables in pp collisions at √s=7 TeV

An inclusive search is presented for new heavy particle pairs produced in √s=7 TeV proton-proton collisions at the LHC using 4.7±0.1 fb(-1) of integrated luminosity. The selected events are analyzed in the 2D razor space of M(R), an event-by-event indicator of the heavy particle mass scale, and R, a dimensionless variable related to the missing transverse energy. The third-generation sector is probed using the event heavy-flavor content. The search is sensitive to generic supersymmetry models with minimal assumptions about the superpartner decay chains. No excess is observed in the number of events beyond that predicted by the standard model. Exclusion limits are derived in the CMSSM framework as well as for simplified models. Within the CMSSM parameter space considered, gluino masses up to 800 GeV and squark masses up to 1.35 TeV are excluded at 95% confidence level depending on the model parameters. The direct production of pairs of top or bottom squarks is excluded for masses as high as 400 GeV.

Search for pair production of third-generation leptoquarks and top squarks in pp collisions at sqrt[s] = 7 TeV

Results are presented from a search for the pair production of third-generation scalar and vector leptoquarks, as well as for top squarks in R-parity-violating supersymmetric models. In either scenario, the new, heavy particle decays into a τ lepton and a b quark. The search is based on a data sample of pp collisions at sqrt[s] = 7 TeV, which is collected by the CMS detector at the LHC and corresponds to an integrated luminosity of 4.8 fb(-1). The number of observed events is found to be in agreement with the standard model prediction, and exclusion limits on mass parameters are obtained at the 95% confidence level. Vector leptoquarks with masses below 760 GeV are excluded and, if the branching fraction of the scalar leptoquark decay to a τ lepton and a b quark is assumed to be unity, third-generation scalar leptoquarks with masses below 525 GeV are ruled out. Top squarks with masses below 453 GeV are excluded for a typical benchmark scenario, and limits on the coupling between the top squark, τ lepton, and b quark, λ(333)(') are obtained. These results are the most stringent for these scenarios to date.

Measurement of the azimuthal anisotropy of neutral pions in Pb-Pb collisions at sqrt[s](NN)] = 2.76 TeV

First measurements of the azimuthal anisotropy of neutral pions produced in Pb-Pb collisions at a center-of-mass energy of sqrt[s(NN)] = 2.76 TeV are presented. The amplitudes of the second Fourier component (v(2)) of the π(0) azimuthal distributions are extracted using an event-plane technique. The values of v(2) are studied as a function of the neutral pion transverse momentum (p(T)) for different classes of collision centrality in the kinematic range 1.6<p(T) <8.0 GeV/c, within the pseudorapidity interval |η|<0.8. The CMS measurements of v(2) (p(T)) are similar to previously reported π(0) azimuthal anisotropy results from sqrt[s(NN)] = 200 GeV Au-Au collisions at RHIC, despite a factor of ∼ 14 increase in the center-of-mass energy. In the momentum range 2.5<p(T)<5.0 GeV/c, the neutral pion anisotropies are found to be smaller than those observed by CMS for inclusive charged particles.

Evidence for associated production of a single top quark and W boson in pp collisions at sqrt[s]=7 TeV

Evidence is presented for the associated production of a single top quark and W boson in pp collisions at sqrt[s]=7  TeV with the CMS experiment at the LHC. The analyzed data correspond to an integrated luminosity of 4.9  fb(-1). The measurement is performed using events with two leptons and a jet originated from a b quark. A multivariate analysis based on kinematic properties is utilized to separate the tt background from the signal. The observed signal has a significance of 4.0σ and corresponds to a cross section of 16(-4)(+5)  pb, in agreement with the standard model expectation of 15.6±0.4(-1.2)(+1.0)  pb.

Study of the Dijet mass spectrum in pp → W+jets events at sqrt[s] = 7 TeV

We report an investigation of the invariant mass spectrum of the two jets with highest transverse momentum in pp → W+2-jet and W+3-jet events to look for resonant enhancement. The data sample corresponds to an integrated luminosity of 5.0 fb(-1) collected with the CMS detector at sqrt[s] = 7 TeV. We find no evidence for the anomalous structure reported by the CDF Collaboration, and establish an upper limit of 5.0 pb at 95% confidence level on the production cross section for a generic Gaussian signal with mass near 150 GeV. Additionally, we exclude two theoretical models that predict a CDF-like dijet resonance near 150 GeV.

Search for supersymmetry at the LHC in events with jets and missing transverse energy

A search for events with jets and missing transverse energy is performed in a data sample of pp collisions collected at √s=7 TeV by the CMS experiment at the LHC. The analyzed data sample corresponds to an integrated luminosity of 1.14 fb(-1). In this search, a kinematic variable α(T) is used as the main discriminator between events with genuine and misreconstructed missing transverse energy. No excess of events over the standard model expectation is found. Exclusion limits in the parameter space of the constrained minimal supersymmetric extension of the standard model are set. In this model, squark masses below 1.1 TeV are excluded at 95% C.L. Gluino masses below 1.1 TeV are also ruled out at 95% C.L. for values of the universal scalar mass parameter below 500 GeV.

Search for B(s)(0) → μ+ μ- and B(0) → μ+ μ- decays in pp collisions at sqrt[s] = 7 TeV

A search for the rare decays B(s)(0) → μ+ μ- and B(0) → μ+ μ- is performed in pp collisions at sqrt[s] = 7 TeV, with a data sample corresponding to an integrated luminosity of 1.14 fb(-1), collected by the CMS experiment at the LHC. In both cases, the number of events observed after all selection requirements is consistent with expectations from background and standard-model signal predictions. The resulting upper limits on the branching fractions are B(B(s)(0) → μ+ μ-) < 1.9 × 10(-8) and B(B(0) → μ+ μ-)<4.6 × 10(-9), at 95% confidence level.

Influence of method of specimen collection on various preanalytical sample quality indicators in EDTA blood collected for cell counting

Improving specimen quality as well as healthcare worker (HCW) safety poses significant concerns for today's laboratories. With an increasing number of diagnostic tests requested, laboratory professionals are faced with challenges to reduce laboratory errors, improve the quality of laboratory results to assure accurate diagnosis and implement initiatives to ensure healthcare worker safety and minimize risk of exposure to bloodborne pathogens. A prior study conducted in 2008 reported that variations in blood collection methods for clinical chemistry assays may affect overall specimen quality. As a follow up, the current study assessed the quality of 22563 patient specimens for cell counting in EDTA blood collection tubes that were obtained with needle and syringe collection (open) using either disposable tubes or re-washed glass vials or with an evacuated blood collection system (closed). Based on the observations, the use of the evacuated blood collection system resulted in better preanalytical specimen quality as compared with needle and syringe collection. The findings also showed an approximately 70-fold reduction in the incidence of clotting as well as fewer instrument-generated flags using the evacuated collection system. In addition, the use of an evacuated collection system for venous blood collection demonstrated lesser chance of blood exposure to healthcare workers.

Performance evaluation of reverse osmosis desalination plants for rural water supply in a developing country--a case study

Performance evaluation of two reverse osmosis (RO) desalination plants (DSP) at villages: Melasirupodhu (30 m3 day(-1)) and Sikkal (50 m3 day(-1)) in Ramanathpuram district, Tamil Nadu (India) were studied so as to bring out the state-of-art of their operation and maintenance (O&M). Detailed information on plant design and engineering, water quality, plant personnel, and cost of O&M was collected for a period of three years after commissioning of the two plants. Feed water was brackish, the TDS varied in the range of 6500-8500 mg L(-1) at Melasirupodhu and 5300-7100 mg L(-1) at Sikkal villages. The product water quality was observed to be gradually deteriorating as the salt rejection by the membranes decreased with time. The salt rejection was 97-99% at the time of commissioning of the plants, and came down to 89-90% at the end of 3 years of operation. Product water TDS soon after installation of the plants was excellent and within desirable limits of BIS. After three years of operation, few parameters exceeded the desirable limits, however, they were found to be within permissible limits of BIS. The analyses of the data showed that both plants were operated only at 30-36% of the design capacity. Plant shut-down due to inadequate and erratic power supply, and plant break-down and inherent delay in repairs due to lack of adequate infrastructure were found to be the major causes for the low utilization of the plants. Consequently the recurring cost of product water production enhanced to Rs. 25.0/m3 at Melasirupodhu and Rs. 17.5 m(-3) at Sikkal, as against the estimated cost of Rs. 15.0/m3 and Rs. 11.0/m3, respectively, as per the design. Over the years, the energy consumption for the product water output increased reflecting higher operational pressures needed with the aging of the membranes.