Investigation of waste incineration of fluorotelomer-based polymers as a potential source of PFOA in the environment

In light of the widespread presence of perfluorooctanoic acid (PFOA) in the environment, a comprehensive laboratory-scale study has developed data requested by the U.S. Environmental Protection Agency (EPA) to determine whether municipal and/or medical waste incineration of commercial fluorotelomer-based polymers (FTBPs) at end of life is a potential source of PFOA that may contribute to environmental and human exposures. The study was divided into two phases (I and II) and conducted in accordance with EPA Good Laboratory Practices (GLPs) as described in the quality assurance project plan (QAPP) for each phase. Phase I testing determined that the PFOA transport efficiency across the thermal reactor system to be used in Phase II was greater than 90%. Operating at 1000°C over 2s residence time with 3.2-6.6mgdscm(-1) hydrogen fluoride (HF), corrected to 7% oxygen (O2), and continuously monitored exhaust oxygen of 13%, Phase II testing of the FTBP composites in this thermal reactor system yielded results demonstrating that waste incineration of fluorotelomer-based polymers does not result in the formation of detectable levels of PFOA under conditions representative of typical municipal waste combustor (MWC) and medical waste incinerator (MWI) operations in the U.S. Therefore, waste incineration of these polymers is not expected to be a source of PFOA in the environment.

Quantitation of a metal deactivator additive by derivatization and gas chromatography--mass spectrometry

The quantitative analysis of phenolic and amine-containing petroleum additives can be challenging. One such compound-N,N'-disalicylidene-1,2-propanediamine, a common metal deactivator additive (MDA)--is thought to inhibit fuel oxidation catalyzed by metals both in the fuel and on surfaces. The ability to measure the concentration of MDA in storage stability tests, thermal-stressing studies, and field samples is important. Quantitating low concentrations of MDA can be difficult because of surface adsorptivity due to the phenol and amine functional groups. This paper describes the shortcomings of direct-injection gas chromatography-mass spectrometry to quantitate MDA as well as a solution to the analytical problem using the common silylation agent BSA to derivatize the MDA. Results demonstrate that the silylation technique is suitable for the determination of MDA concentrations in aviation fuel samples and suggests that the MDA may be readily determined in other petroleum products with a lower detection limit for MDA of 0.5 mg/L. Measurements conducted in heated batch reactors indicate that MDA concentration is reduced as hydrocarbon fuels are stressed. In addition, only free or available MDA is measured by this technique, not MDA that is complexed with metals.

Neurotoxin formation from pilot-scale incineration of synthetic ester turbine lubricants with a triaryl phosphate additive

The high-temperature combustion of synthetic ester turbine engine lubricants has been performed by diluting the lubricant 5, 15, or 25% in diesel fuel and burning the mixture in a pilot-scale boiler facility. The effluent gas from this combustion system was carefully monitored for the formation of a potent neurotoxin, trimethylolpropane phosphate (TMPP). Although TMPP was not detected in the gaseous effluent, elevated levels of the neurotoxin were found in scrapings from the inside of the boiler system. Because of the extreme toxicity of this compound, significant dermal exposure could be a potential risk to incinerator operation and maintenance personnel.