Quantification of perfluorinated compounds in atmospheric particulate shows potential connection with environmental event

A method of quantification of perfluorinated compounds (PFCs) from atmospheric particulate matter (APM) is described. A single step pretreatment method, selective pressurized liquid extraction (SPLE), was developed to reduce the high matrix background and avoid contamination from commonly used multiple sample pretreatment steps. An effective sorbent was selected to purify the PFCs during SPLE, followed by liquid chromatography-tandem mass spectrometry (LC-MS/MS), for quantification of PFCs. Conditions affecting the SPLE efficiency, including temperature, static extraction time, and number of extraction cycles used, were studied. The optimum conditions were found to be 120°C, 10 min, and 3 cycles, respectively. LC-MS/MS method was developed to obtain the optimal sensitivity specific to PFCs. The method detection limits (MDLs) were 0.006 to 0.48 ng/g for the PFCs studied and the linear response range was from 0.1 to 100 ng/g. To ensure accurate values were obtained, each step of the experiment was evaluated and controlled to prevent contamination. The optimized method was tested by performing spiking experiments in natural particulate matter matrices and good rates of recovery and reproducibility were obtained for all target compounds. Finally, the method was successfully used to measure 16 PFCs in the APM samples collected in Beijing over five years from 2015 to 2019. It is observed that some PFCs follow the trend of total PFC changes, and can be attributed to the environment influencing events and policy enforcement, while others don't seem to change as much with time of the year or from year to year.

Optimization of a new selective pressurized liquid extraction methodology for determining organic pollutants in wild boar livers

In this study, a new selective pressurised liquid extraction (SPLE) methodology was optimised for determining about 70 organic pollutants (OPs) including organochlorine (OCPs), organophosphate (OPPs) and pyrethroid (PYRs) pesticides, polychlorinated biphenyls (PCBs), polybromodiphenyl ethers (PBDEs), as well as, polycyclic aromatic hydrocarbons (PAHs) in wild boar liver samples considering the temperature, pressure and time of contact between the solvent and the matrix as influential variables. Clean-up of extracts was performed by solid-phase extraction (SPE) using EZ-POP cartridges. Detection of OPs was carried out by gas chromatography (GC) coupled to tandem mass spectrometry (QqQ-MS/MS). This new approach offers:•

A new non-time consuming SPLE methodology for determining about 70 OPs in wild boar.

•

Recoveries achieved ranged between 74 to 119 % with RSD less than 20 %.

•

Detection and quantification limits in the low to mid pg/g range.

Selective pressurized liquid extraction of plant secondary metabolites: Convallaria majalis L. as a case

A fast and efficient selective pressurized liquid extraction (sPLE) method was developed to extract secondary metabolites from complex plant matrix. Convallaria majalis L., a plant producing toxic steroids, was used as proof-of-concept. The method was optimized in the aspects of preheating, dispersant, extraction temperature and solvent, and the use of C18 as in-cell cleanup sorbent. Eight authentic natural steroids with diverse sugar moieties and hydrophobicities were selected as reference analytes and spiked to 0.1 g dried leaves. The extraction performance was evaluated based on the analytes' stability, recovery, matrix effect in the electrospray interface and the level of co-extractives. With the optimal method, the extraction was finished in 10 min. A colorless extract was obtained with recoveries ranging from 63% to 107% and absolute matrix effects ranging from 3% to 27%. The optimized method was validated by extracting 0.1 g, 0.2 g and 0.4 g spiked plant samples; method accuracy and precision were assessed by recoveries and relative standard deviations of the combined extraction-analysis workflow. The method was also tested on soil samples and indicated its suitability for measuring secondary metabolites in multiple environmental matrices. To our knowledge, this is the first time sPLE has been reported to extract plant secondary metabolites from a complex plant matrix, with satisfactory recoveries and low matrix effects. This is also the first time (s)PLE has been reported to extract plant secondary metabolites from soil. We envision the method be coupled with liquid chromatography-electrospray ionization-high resolution mass spectrometry in a standard metabolomics workflow to facilitate plant metabolomics studies.

Trace-level determination of sweeteners in sewage sludge using selective pressurized liquid extraction and liquid chromatography-tandem mass spectrometry

The occurrence of sweeteners in the environment has become a matter of concern due to the possibility of adverse effects on human health and wildlife species. One of the routes by which sweeteners enter the environment is through sewage sludge. Therefore, a method was developed with a selective-pressurized liquid extraction (S-PLE) followed by liquid chromatography-tandem mass spectrometry for the simultaneous determination of eight sweeteners in sewage sludge. The chromatographic separation was achieved in less than ten minutes using an amide polar-embedded reversed-phase column. Due to the high matrix effect present in the sample, an extensive study was conducted in order to overcome this issue, with C18 in-cell and solid-phase extraction (Oasis HLB) as a clean-up method. S-PLE/SPE recoveries at two levels of concentration (50μg/kg and 1000μg/kg in dry weight (d.w.), n=5) were higher than 61%. Repeatability and reproducibility at the same concentrations (%RSD, n=5) were lower than 11% and 16%, respectively. The limits of detection were 10μg/kg (d.w) for all compounds, except for cyclamate (5μg/kg (d.w.)). The method was successfully applied to sewage sludge samples from three sewage treatment plants located in Catalonia (Spain). Of the eight compounds, five were determined in all of the samples analysed, with acesulfame and saccharine being recorded at the highest concentrations of up to 481μg/kg and 591μg/kg (d.w.), respectively.

Determination of polychlorinated biphenyls in soil and sediment by selective pressurized liquid extraction with immunochemical detection

A selective pressurized liquid extraction (SPLE) method was developed for a streamlined sample preparation/cleanup to determine Aroclors and coplanar polychlorinated biphenyls (PCBs) in soil and sediment. The SPLE was coupled with an enzyme-linked immunosorbent assay (ELISA) for an effective analytical approach for environmental monitoring. Sediment or soil samples were extracted with alumina, 10% AgNO3 in silica, and sulfuric acid impregnated silica with dichloromethane at 100°C and 2000 psi. The SPLE offered simultaneous extraction and cleanup of the PCBs and Aroclors, eliminating the need for a post-extraction cleanup prior to ELISA. Two different ELISA methods: (1) an Aroclor ELISA and (2) a coplanar PCB ELISA were evaluated. The Aroclor ELISA utilized a polyclonal antibody (Ab) with Aroclor 1254 as the calibrant and the coplanar PCB ELISA kit used a rabbit coplanar PCB Ab with PCB-126 as the calibrant. Recoveries of Aroclor 1254 in two reference soil samples were 92±2% and 106±5% by off-line coupling of SPLE with ELISA. The average recovery of Aroclor 1254 in spiked soil and sediment samples was 92±17%. Quantitative recoveries of coplanar PCBs (107-117%) in spiked samples were obtained with the combined SPLE-ELISA. The estimated method detection limit was 10 ng g(-1) for Aroclor 1254 and 125 pg g(-1) for PCB-126. Estimated sample throughput for the SPLE-ELISA was about twice that of the stepwise extraction/cleanup needed for gas chromatography (GC) or GC/mass spectrometry (MS) detection. ELISA-derived uncorrected and corrected Aroclor 1254 levels correlated well (r=0.9973 and 0.9996) with the total Aroclor concentrations as measured by GC for samples from five different contaminated sites. ELISA-derived PCB-126 concentrations were higher than the sums of the 12 coplanar PCBs generated by GC/MS with a positive correlation (r=0.9441). Results indicate that the SPLE-ELISA approach can be used for quantitative or qualitative analysis of PCBs in soil and sediments. To our knowledge, this is the first report of an SPLE-ELISA approach not requiring a post-extraction cleanup step for detecting Aroclors and coplanar PCBs in soil and sediment.