Influence of etching mode on bonding performance of self-adhesive flowable resin composites to bovine teeth

This study aimed to evaluate the bonding performance of self-adhesive flowable resin composites (SARs) to bovine teeth. Three SARs, one experimental, and two commercially available products, were used. The study parameters were shear bond strength (SBS), microleakage, and scanning electron microscopy (SEM) evaluation of bonding interfaces. The SBS of the materials was 14.1-15.1 MPa to enamel, 22.2-23.2 MPa to etched enamel, and 7.4-10.7 MPa to dentin. Specimens with pre-etching showed lower microleakage scores than those without pre-etching. SEM images of the interfaces of the materials showed excellent adaptation regardless of the substrate or etching mode. The study results indicate that enamel pre-etching can improve the bonding performance of SARs.

Evaluation of bonding performance and multi-ion release of S-PRG fillercontaining self-adhesive resin composite

The bonding performance of a surface pre-reacted glass ionomer (S-PRG) filler-containing self-adhesive flowable resin composites to enamel and dentin were evaluated using a tensile bond test with thermal cycling. Also, the quantities of various ions released from the materials were measured using ICP atomic emission spectrometry and a fluoride ion electrode. The initial bond strengths of the materials were approximately 6 MPa, and decreased after thermal cycling. The S-PRG filler-containing self-adhesive flowable resin composites materials exhibited much higher ion release compared with the commercial self-adhesive flowable resin composite possibly due to different acidic monomers contained. It was suggested that the S-PRG filler containing self-adhesive flowable resin composites should be limited as a lining material or to restore small cavities in non-stress bearing areas.

Use of new scratch test and tensile test for evaluation of bond strength of selfadhesive flowable resin composite for repair of artificial tooth erosion

The purpose of this study was to use a new scratch test and tensile test to evaluate the bond strength between artificial erosive enamel or dentin and self-adhesive resin composites as a coating material. Coronal enamel or dentin surface was exposed to an erosive cycle (artificial saliva [AS], pH:7.0 for 6.5 h and acidic carbonated beverages for 5 min, alternated 3 times per day) for the eroded-surface or stored in AS for the remineralized-surface. Two self-adhesive flowable resin composites, Fusio and LLB-CR6 (prototype), and a conventional flowable resin composite, BEAUTIFIL FLOW with self-etching primer system, Clearfil Mega Bond, were applied to enamel or dentin surfaces; and then the bond strengths were measured. For the eroded-surface, there were no significant differences in bonding strength among all materials, as assessed by the new scratch test. Thus, these self-adhesive flowable resin composites might be useful for coating materials on acid-eroded tooth surfaces.