Assessment of Eye Lens Dose Reduction When Using Lateral Lead Shields on the Patient's Head during Neurointerventional Fluoroscopic Procedures and Cone-beam Computed Tomography (CBCT) Scans

The purpose of this study was to evaluate the effect of placing small lead shields on the temple region of the skull to reduce radiation dose to the lens of the eye during interventional fluoroscopically-guided procedures and cone-beam computed tomography (CBCT) scans of the head. EGSnrc Monte-Carlo code was used to determine the eye lens dose reduction when using lateral lead shields for single x-ray projections, CBCT scans with different protocols, and interventional neuroradiology procedures with the Zubal computational head phantom. A clinical C-Arm system was used to take radiographic projections and CBCT scans of anthropomorphic head phantoms without and with lead patches, and the images were compared to assess the effect of the shields. For single lateral projections, a 0.1 (0.3)-mm-thick lead patch reduced the dose to the left-eye lens by 40% to 60% (55% to 80%) from 45° to 90° RAO and to the right-eye lens by around 30% (55%) from 70° to 90° RAO. For different CBCT protocols, the reduction of lens dose with a 0.3-mm-thick lead patch ranged from 20% to 53% at 110 kVp. For CBCT scans of the anthropomorphic phantom, the lead patch introduced streak artifacts that were mainly in the orbital regions but were insignificant in the brain region where most neurointerventional activity occurs. The dose to the patient's eye lens can be reduced considerably by placing small lead shields over the temple region of the head without substantially compromising image quality in neuro-imaging procedures.

Effect of ROI filtering in 3D cone-beam rotational angiography on organ dose and effective dose in cerebral investigations

The assessment of intracranial aneurysms is increasingly performed using three-dimensional cone-beam rotational angiography (3D CBRA). To reduce the dose to the patient during 3D CBRA procedures, filtered region-of-interest imaging (FROI) is presented in literature to be an effective technique as the dose in regions of low interest is reduced, while high image quality is preserved in the ROI. The purpose of this study was to quantify the benefit of FROI imaging during a typical 3D CBRA procedure in a patient's head region. A cone-beam rotational angiography unit (Infinix) was modeled in GMctdospp, an EGSnrc-based Monte Carlo software, which calculates patient dose distributions in rotational computed tomography. Kodak Lanex, a gadolinium compound, was chosen to be the ROI filter material. The adult female ICRP reference phantom was integrated in GMctdospp to calculate organ and effective doses in simulations of FROI-CBRA examinations. During the Monte Carlo simulations, different parameters as the ROI filter thickness, the ROI opening size, the tube voltage, and the isocenter position were varied. The results showed that the reduction in dose clearly depends on these parameters. Comparing the reduction in organ dose in standard 3D CBRA and FROI-CBRA, a maximum reduction of about 60%-80% could be achieved with a small sized ROI filter and about 40%-70% of the dose could be saved using a ROI filter with a large opening. Further we could show that dose reduction strongly depends on filter thickness, the location of the organ in the radiated area, and the position of the isocenter. As a consequence, dose reduction partially differs from theoretically calculated values by a factor up to 1.6. The effective dose could be reduced to a minimum of about 40%. Due to the fact that standard 3D CBRA is only used for the assessment of aneurysms at present and, thus, most of the patient dose originates from the aneurysm treatment (with 2D techniques) itself, the dose reduction effect of ROI filtering in 3D CBRA tends to be much smaller, if the patient dose of a whole aneurysm treatment procedure is considered.