Sesamin as a co-initiator for unfilled dental restorations

A natural component, sesamin (SA), was used to replace conventional amine as co-initiator for dental composite. A combination of camphorquinone (CQ) and SA was employed to initiate the photopolymerization of 2-2-bis[4-(2-hydroxy-3-methacryloxyprop-1-oxy)phenyl] propane/triethylene glycol dimethacrylate (70/30wt.%). The kinetics was recorded by real-time Fourier transform infrared spectroscopy. The mechanical properties were measured by dynamic mechanical analysis, the cell toxicity was investigated by MTT assay and a mixture of CQ and ethyl 4-N,N-dimethylaminobenzoate (EDMAB) was used as control in the same photocuring condition. The results indicated that the addition of SA as co-initiator greatly improved the rate of polymerization and final double-bond conversion (DC) when compared with the system initiated by CQ alone. Compared with EDMAB, the final DC of the CQ/SA system (71%) was slightly lower than that of CQ/EDMAB (76%); SA resulted in approximately the same storage modulus at around 37 degrees C, but a slightly higher glass transition temperature. SA produced lower yellowing effect and good in vitro biocompatibility. The water sorption and solubility for two mixtures were very close and within the range of the ISO 4049 specification. These results suggest that SA is an effective alternative co-initiator to conventional amine. The natural compound characteristics of SA make it more promising than amine in dental resin formulations.

Photochemistry of methoxyhydroquinone and methoxy-p-benzoquinone in solution related to the photoyellowing of the lignocellulosics

The photoreactivity of methoxy-p-benzoquinone (MQ) and methoxyhydroquinone (MHQ) in dilute solution (10(-4)-10(-3) M) was studied using continuous irradiation and laser flash photolysis (LFP). The quinone irradiated in degassed tetrahydrofuran (THF) gives MHQ and an adduct with the solvent. Only the formation of hydroquinone is observed in ethanol, and hydroxylation is evidenced in water, whereas the compound is stable in CCl4. The bis-quinone, 4,4'-dimethoxybiphenyl-2,5,2',5'-bisquinone, and the dibenzofurane-quinone, 8-hydroxy-3,7-dimethoxydibenzofuran-1,4-quinone, are formed in the presence of MHQ, whereas the reactivity is low with ethylconiferyl alcohol. When MHQ is irradiated selectively in degassed THF, the formation of MQ and of the bis-hydroquinone, 4,4'-dimethoxy-2,5,2',5'-tetrahydroxy-biphenyl, are observed. The dimer is oxidized photochemically or thermally into the mono- or bis-quinones, the process being accelerated in alkaline medium. The formation of the dimers is strongly favored by the contiguous presence of quinone and hydroquinone. When MHQ is selectively irradiated in the presence of transethylconiferaldehyde (EtC), quinone formation and isomerization of EtC are observed. LFP experiments, performed with a selective excitation of MQ, indicate that the triplet state of the quinone is strongly quenched by MHQ to conduce to a semiquinone radical. The interaction between 3MQ* and MQ is mainly driven by an electron transfer process according to the similar value of the quenching rate constant found with another electron donor compound such as 1,4-dimethoxybenzene. By contrast, no strong quenching of 3EtC* by MHQ was observed. It is proposed that the photochemistry of the couple MQ/MHQ is governed by the formation of encounter complex between either 3MQ* and MHQ or 3MHQ* and MQ. Consequently, the fast part of the photoyellowing of lignocellulosics does not appear to involve the couple MHQ/MQ or MHQ/etherified coniferaldehyde, but more likely a combination of oxidation of the hydroquinone by ground-state oxygen and photohydration of the formed quinone from its triplet state, giving inter-alia more colored o-quinonoid type molecules.