The negative impact of HBV/HCV coinfection on cirrhosis and its consequences

BACKGROUND

Hepatitis B virus (HBV)/hepatitis C virus (HCV) confection has been rarely studied in nonasian series.

AIM

To compare the characteristics of HBV/HCV coinfected patients to those of HBV- or HCV-monoinfected patients in the ANRS CO22 HEPATHER cohort study.

PATIENTS AND METHODS

Of the 20 936 included patients, 95 had HBV/HCV coinfection (hepatitis B surface antigen, anti-HCV antibody and HCV RNA positive) and were matched with 375 HBV- and 380 HCV-monoinfected patients on age, gender and time since HBV or HCV diagnosis.

RESULTS

F3-F4 fibrosis was more frequent in coinfected patients (58%) than in HBV- (32%, P < .0001), but similar in HCV-monoinfected patients (52%, P = .3142). Decompensated cirrhosis was more frequent in coinfected patients (11%) than in HBV- (2%, P = .0002) or HCV- (4%, P = .0275) monoinfected patients. Past excessive alcohol use was more frequent in coinfected patients (26%) than in HBV (12%, P = .0011), but similar in HCV monoinfected patients (32%, P = .2868). Coinfected patients had a higher proportion with arterial hypertension (42%) than HBV- (26%) or HCV-monoinfected patients (25%) (P < .003). Multivariable analysis confirmed the association between F3-F4 fibrosis and HCV infection in HBV-infected patients (OR = 3.84, 95% CI 1.99-7.43) and the association between decompensated cirrhosis and coinfection in HBV infected (OR = 5.58, 95% CI 1.42-22.0) or HCV infected patients (OR = 3.02, 95% CI 1.22-7.44).

CONCLUSIONS

HCV coinfection harmfully affects liver fibrosis in HBV patients, while decompensated cirrhosis is increased in coinfected patients compared with HBV- or HCV-monoinfected patients. HCV treatment is as safe and effective in coinfected as monoinfected patients and should be considered following the same rules as HCV monoinfected patients.

Regional health workforce monitoring as governance innovation: a German model to coordinate sectoral demand, skill mix and mobility

BACKGROUND

As health workforce policy is gaining momentum, data sources and monitoring systems have significantly improved in the European Union and internationally. Yet data remain poorly connected to policy-making and implementation and often do not adequately support integrated approaches. This brings the importance of governance and the need for innovation into play.

CASE

The present case study introduces a regional health workforce monitor in the German Federal State of Rhineland-Palatinate and seeks to explore the capacity of monitoring to innovate health workforce governance. The monitor applies an approach from the European Network on Regional Labour Market Monitoring to the health workforce. The novel aspect of this model is an integrated, procedural approach that promotes a 'learning system' of governance based on three interconnected pillars: mixed methods and bottom-up data collection, strong stakeholder involvement with complex communication tools and shared decision- and policy-making. Selected empirical examples illustrate the approach and the tools focusing on two aspects: the connection between sectoral, occupational and mobility data to analyse skill/qualification mixes and the supply-demand matches and the connection between monitoring and stakeholder-driven policy.

CONCLUSION

Regional health workforce monitoring can promote effective governance in high-income countries like Germany with overall high density of health workers but maldistribution of staff and skills. The regional stakeholder networks are cost-effective and easily accessible and might therefore be appealing also to low- and middle-income countries.

Lack of electron microscopy hinders correct renal biopsy diagnosis: A study from India

Electron microscopy (EM) is performed routinely on all native kidney biopsies in the western world. However, in India, it is not regularly performed due to non-availability and financial constraints. The aim of this prospective study was to evaluate the usefulness of routinely performing EM on native kidney biopsies. In order to eliminate selection bias, all consecutive native kidney biopsies were included in this study, provided they had adequate tissue for light, immunofluorescence (IF), and EM. The biopsies were reported on the basis of light and IF microscopy. EM was performed on each case by another pathologist who also independently reviewed the light microscopic slides and IF images. The findings were then reviewed to assess how the ultrastructural features contributed to the primary diagnosis and assigned to one of the following categories: 1. Crucial for diagnosis, 2. Important contribution, or 3. Not required. Of the 115 cases evaluated, EM was crucial in 12% of the cases. In 20% of the cases, it provided important confirmatory information and in the remaining 68% cases, EM was not considered required. This study supports the use of EM as a routine diagnostic tool in the evaluation of native kidney biopsies. There is an urgent need for availability and accessibility of EM in our country.

Ultrasound Guided Needle Biopsy of Skeletal Muscle in Neuromuscular Disease

Guided by ultrasonography percutaneous needle biopsy of skeletal muscle was performed in 24 patients, using the one hand held Biopty system and a 2 mm Tru-Cut needle. The specimens were graded with regard to diagnostic quality and utility and almost all specimens (96%) were of highest quality. The use of ultrasonography was helpful in selecting a suitable area for the biopsy and vascular structures could be avoided. The procedure was well tolerated and easy to perform, and no complications were recorded.

Investigating the long-term effect of subchronic phencyclidine-treatment on novel object recognition and the association between the gut microbiota and behavior in the animal model of schizophrenia

Subchronic phencyclidine (subPCP) treatment induces schizophrenic-like behavior in rodents, including cognitive deficits and increased locomotor sensitivity towards acute administration of PCP. Evidence is accumulating that the gut microbiota (GM) influences behavior through modulation of the microbiota-gut-brain axis, and hence, part of the variation within this animal model may derive from variation in the GM. The aims of this study was to investigate first, the duration of subPCP-induced cognitive impairment in the novel object recognition test, and second, the possible effect of subchronic PCP-treatment on the GM, and the association between the GM and the behavioral parameters. The association was further investigated by antibiotic reduction of the GM. Male Lister Hooded rats were dosed twice daily i.p. with either 5mg/kg PCP or sterile isotonic saline for seven days followed by a seven-day washout period. Rats were tested in the novel object recognition and the locomotor activity assays immediately after, three weeks after, or six weeks after washout, and the fecal GM was analyzed by high throughput sequencing. Antibiotic- and control-treated rats were tested in the same manner following washout. In conclusion, subPCP-treatment impaired novel object recognition up to three weeks after washout, whereas locomotor sensitivity was increased for at least six weeks after washout. Differences in the core gut microbiome immediately after washout suggested subPCP treatment to alter the GM. GM profiles correlated to memory performance. Administration of ampicillin abolished the subPCP-induced memory deficit. It thus seems reasonable to speculate that the GM influences memory performance, contributing to variation within the model.

The all-fiber cladding-pumped Yb-doped gain-switched laser

Gain-switching is an alternative pulsing technique of fiber lasers, which is power scalable and has a low complexity. From a linear stability analysis of rate equations the relaxation oscillation period is derived and from it, the pulse duration is defined. Good agreement between the measured pulse duration and the theoretical prediction is found over a wide range of parameters. In particular we investigate the influence of an often present length of passive fiber in the cavity and show that it introduces a finite minimum in the achievable pulse duration. This minimum pulse duration is shown to occur at longer active fibers length with increased passive length of fiber in the cavity. The peak power is observed to depend linearly on the absorbed pump power and be independent of the passive fiber length. Given these conclusions, the pulse energy, duration, and peak power can be estimated with good precision.

Gain-switched all-fiber laser with narrow bandwidth

Gain-switching of a CW fiber laser is a simple and cost-effective approach to generate pulses using an all-fiber system. We report on the construction of a narrow bandwidth (below 0.1 nm) gain-switched fiber laser and optimize the pulse energy and pulse duration under this constraint. The extracted pulse energy is 20 μJ in a duration of 135 ns at 7 kHz. The bandwidth increases for a higher pump pulse energy and repetition rate, and this sets the limit of the output pulse energy. A single power amplifier is added to raise the peak power to the kW-level and the pulse energy to 230 μJ while keeping the bandwidth below 0.1 nm. This allows frequency doubling in a periodically poled lithium tantalate crystal with a reasonable conversion efficiency.

Deep-blue supercontinnum sources with optimum taper profiles--verification of GAM

We use an asymmetric 2 m draw-tower photonic crystal fiber taper to demonstrate that the taper profile needs careful optimisation if you want to develop a supercontinuum light source with as much power as possible in the blue edge of the spectrum. In particular we show, that for a given taper length, the downtapering should be as long as possible. We argue how this may be explained by the concept of group-acceleration mismatch (GAM) and we confirm the results using conventional symmetrical short tapers made on a taper station, which have varying downtapering lengths.

Gain-switched CW fiber laser for improved supercontinuum generation in a PCF

We demonstrate supercontinuum generation in a PCF pumped by a gain-switched high-power continuous wave (CW) fiber laser. The pulses generated by gain-switching have a peak power of more than 700 W, a duration around 200 ns, and a repetition rate of 200 kHz giving a high average power of almost 30 W. By coupling such a pulse train into a commercial nonlinear photonic crystal fiber, a supercontinuum is generated with a spectrum spanning from 500 to 2250 nm, a total output power of 12 W, and an infrared flatness of 6 dB over a bandwidth of more than 1000 nm with a power density above 5 dBm/nm (3 mW/nm). This is considerably broader than when operating the same system under CW conditions. The presented approach is attractive due to the high power, power scalability, and reduced system complexity compared to picosecond-pumped supercontinuum sources.

Leukocyte chemotactic factor 2 (LECT2)-associated renal amyloidosis: a case series

BACKGROUND

Renal amyloidosis is characterized by the pathologic deposition within glomeruli and/or interstitium of congophilic fibrils, most often composed of either immunoglobulin light chains or serum amyloid A-related protein and, less commonly, mutated forms of apolipoproteins AI or AII, lysozyme, fibrinogen, gelsolin, or transthyretin.

STUDY DESIGN

Case series.

SETTING & PARTICIPANTS

10 patients with renal amyloidosis who had an amyloidogenic protein that was not identified using routine immunohistochemistry.

OUTCOMES

Clinical, pathologic, biochemical, and genetic characteristics.

MEASUREMENTS

Tandem mass spectrometry was used to analyze fibrils extracted from sections of formalin-fixed paraffin-embedded amyloid-containing kidney biopsy specimen blocks.

RESULTS

Chemical analyses showed peptides corresponding to the carboxy-terminal portion of the leukocyte chemotactic factor 2 (LECT2) molecule. In addition, deposits were immunostained using an anti-human LECT2 monoclonal antibody. Plasma specimens were available from 2 individuals for whom LECT2 concentration in these samples was within the reference range. Additionally, in 4 of the cases analyzed at the molecular level, isolation of genomic DNA and polymerase chain reaction amplification of LECT2-encoding exons showed no mutations. However, all were homozygous for the G allele encoding valine at position 40 in the mature protein, a finding confirmed using restriction enzyme analysis of the polymorphic site.

LIMITATIONS

Causality is not addressed.

CONCLUSIONS

Based on our studies, we posit that LECT2-associated renal amyloidosis represents a unique and perhaps not uncommon disease, especially in Mexican Americans. The pathogenesis, extent, and prognosis remain to be determined.

Recent and future warm extreme events and high-mountain slope stability

The number of large slope failures in some high-mountain regions such as the European Alps has increased during the past two to three decades. There is concern that recent climate change is driving this increase in slope failures, thus possibly further exacerbating the hazard in the future. Although the effects of a gradual temperature rise on glaciers and permafrost have been extensively studied, the impacts of short-term, unusually warm temperature increases on slope stability in high mountains remain largely unexplored. We describe several large slope failures in rock and ice in recent years in Alaska, New Zealand and the European Alps, and analyse weather patterns in the days and weeks before the failures. Although we did not find one general temperature pattern, all the failures were preceded by unusually warm periods; some happened immediately after temperatures suddenly dropped to freezing. We assessed the frequency of warm extremes in the future by analysing eight regional climate models from the recently completed European Union programme ENSEMBLES for the central Swiss Alps. The models show an increase in the higher frequency of high-temperature events for the period 2001-2050 compared with a 1951-2000 reference period. Warm events lasting 5, 10 and 30 days are projected to increase by about 1.5-4 times by 2050 and in some models by up to 10 times. Warm extremes can trigger large landslides in temperature-sensitive high mountains by enhancing the production of water by melt of snow and ice, and by rapid thaw. Although these processes reduce slope strength, they must be considered within the local geological, glaciological and topographic context of a slope.