Synthesis and characterization of thin film nanocomposite forward osmosis membrane with hydrophilic nanocomposite support to reduce internal concentration polarization

Amorphous SiO2 NP-Incorporated Poly(vinylidene fluoride) Electrospun Nanofiber Membrane for High Flux Forward Osmosis Desalination

Novel amorphous silica nanoparticle-incorporated poly(vinylidine fluoride) electrospun nanofiber mats are introduced as effective membranes for forward osmosis desalination technology. The influence of the inorganic nanoparticle content on water flux and salt rejection was investigated by preparing electrospun membranes with 0, 0.5, 1, 2, and 5 wt % SiO2 nanoparticles. A laboratory-scale forward osmosis cell was utilized to validate the performance of the introduced membranes using fresh water as a feed and different brines as draw solution (0.5, 1, 1.5, and 2 M NaCl). The results indicated that the membrane embedding 0.5 wt % displays constant salt rejection of 99.7% and water flux of 83 L m(-2) h(-1) with 2 M NaCl draw solution. Moreover, this formulation displayed the lowest structural parameter (S = 29.7 μm), which represents approximately 69% reduction compared to the pristine membrane. Moreover, this study emphasizes the capability of the electrospinning process in synthesizing effective membranes as the observed water flux and average salt rejection of the pristine poly(vinylidine fluoride) membrane was 32 L m(-2) h(-1) (at 2 M NaCl draw solution) and 99%, respectively. On the other hand, increasing the inorganic nanoparticles to 5 wt % showed negative influence on the salt rejection as the observed salt flux was 1651 mol m(-2) h(-1). Besides the aforementioned distinct performance, studies of the mechanical properties, porosity, and wettability concluded that the introduced membranes are effective for forward osmosis desalination technology.

Hydrophilic Mineral Coating of Membrane Substrate for Reducing Internal Concentration Polarization (ICP) in Forward Osmosis

Internal concentration polarization (ICP) is a major issue in forward osmosis (FO) as it can significantly reduce the water flux in FO operations. It is known that a hydrophilic substrate and a smaller membrane structure parameter (S) are effective against ICP. This paper reports the development of a thin film composite (TFC) FO membrane with a hydrophilic mineral (CaCO3)-coated polyethersulfone (PES)-based substrate. The CaCO3 coating was applied continuously and uniformly on the membrane pore surfaces throughout the TFC substrate. Due to the intrinsic hydrophilicity of the CaCO3 coating, the substrate hydrophilicity was significantly increased and the membrane S parameter was reduced to as low as the current best of cellulose-based membranes but without the mechanical fragility of the latter. As a result, the ICP of the TFC-FO membrane could be significantly reduced to yield a remarkable increase in water flux without the loss of membrane selectivity.

The impact of MOF feasibility to improve the desalination performance and antifouling properties of FO membranes

In this study, a hydrophilic metal–organic framework (MOF) was applied to improve the performance of a cellulosic membrane for forward osmosis (FO) desalination application.

Layered double hydroxide/graphene oxide hybrid incorporated polysulfone substrate for thin-film nanocomposite forward osmosis membranes

Herein, we report the use of a layered double hydroxide/graphene oxide (LDH/GO) hybrid as a nanofiller for a polysulfone (PSf) substrate in the fabrication of a thin film nanocomposite (TFN) forward osmosis (FO) membrane.

Alginate fouling reduction of functionalized carbon nanotube blended cellulose acetate membrane in forward osmosis

Functionalized multi-walled carbon nanotube blended cellulose acetate (fCNT-CA) membranes were synthesized for forward osmosis (FO) through phase inversion. The membranes were characterized through SEM, FTIR, and water contact angle measurement. AFM was utilized to investigate alginate fouling mechanism on the membrane. It reveals that the fCNT contributes to advance alginate fouling resistance in FO (57% less normalized water flux decline for 1% fCNT-CA membrane was observed than that for bare CA membrane), due to enhanced electrostatic repulsion between the membrane and the alginate foulant. Furthermore, it was found that the fCNT-CA membranes became more hydrophilic due to carboxylic groups in functionalized carbon nanotube, resulting in approximately 50% higher water-permeated flux than bare CA membrane. This study presents not only the fabrication of fCNT-CA membrane and its application to FO, but also the quantification of the beneficial role of fCNT with respect to alginate fouling in FO.

Application of nano TiO2 modified hollow fiber membranes in algal membrane bioreactors for high-density algae cultivation and wastewater polishing

Polyvinylidene fluoride (PVDF) hollow fiber membranes with nano-TiO2 (5% of PVDF by mass, average size = 25 nm) additives were fabricated and applied for high-density algae (Chlorella vulgaris) cultivation. At the average light intensity of 121 μmol/m(2)/s, the algal membrane bioreactors (A-MBR) operated at a hydraulic retention time of 0.5d and an average solids retention time of 25d had an average algae biomass concentration of 2350 ± 74 mg/L (in COD units) and algal biomass production rate of 6.5 ± 0.1g/m(2)/d. The A-MBRs removed an average of 78% of phosphorus from the wastewater at the initial total phosphorus concentrations ranging from 3.5 to 8.6 mg/L. The nano TiO2-embedded membranes had improved surface hydrophilicity with its total resistance about 50% lower than that of the control. This study demonstrated that PVDF/TiO2 nanocomposite membranes had a better antifouling property for high-density algae cultivation and wastewater polishing.

A new nanocomposite forward osmosis membrane custom-designed for treating shale gas wastewater

Managing the wastewater discharged from oil and shale gas fields is a big challenge, because this kind of wastewater is normally polluted by high contents of both oils and salts. Conventional pressure-driven membranes experience little success for treating this wastewater because of either severe membrane fouling or incapability of desalination. In this study, we designed a new nanocomposite forward osmosis (FO) membrane for accomplishing simultaneous oil/water separation and desalination. This nanocomposite FO membrane is composed of an oil-repelling and salt-rejecting hydrogel selective layer on top of a graphene oxide (GO) nanosheets infused polymeric support layer. The hydrogel selective layer demonstrates strong underwater oleophobicity that leads to superior anti-fouling capability under various oil/water emulsions, and the infused GO in support layer can significantly mitigate internal concentration polarization (ICP) through reducing FO membrane structural parameter by as much as 20%. Compared with commercial FO membrane, this new FO membrane demonstrates more than three times higher water flux, higher removals for oil and salts (>99.9% for oil and >99.7% for multivalent ions) and significantly lower fouling tendency when investigated with simulated shale gas wastewater. These combined merits will endorse this new FO membrane with wide applications in treating highly saline and oily wastewaters.

A review on polyamide thin film nanocomposite (TFN) membranes: History, applications, challenges and approaches

This review focuses on the development of polyamide (PA) thin film nanocomposite (TFN) membranes for various aqueous media-based separation processes such as nanofiltration, reverse osmosis and forward osmosis since the concept of TFN was introduced in year 2007. Although the total number of published TFN articles falls far short of the articles of the well-known thin film composite (TFC) membranes, its growth rate is significant, particularly since 2012. Generally, by incorporating an appropriate amount of nanofiller into a thin selective PA layer of a composite membrane, one could produce TFN membranes with enhanced separation characteristics as compared to the conventional TFC membrane. For certain cases, the resulting TFN membranes demonstrate not only excellent antifouling resistance and/or greater antibacterial effect, but also possibly overcome the trade-off effect between water permeability and solute selectivity. Furthermore, this review attempts to give the readers insights into the difficulties of incorporating inorganic nanomaterials into the organic PA layer whose thickness usually falls in a range of several-hundred nanometers. It is also intended to show new possible approaches to overcome these challenges in TFN membrane fabrication.

Preparation and Characterization of Chitosan Thin Films on Mixed-Matrix Membranes for Complete Removal of Chromium

Herein we present a new approach for the complete removal of Cr(VI) species, through reduction of Cr(VI) to Cr(III), followed by adsorption of Cr(III). Reduction of chromium from water is an important challenge, as Cr(IV) is one of the most toxic substances emitted from industrial processes. Chitosan (CS) thin films were developed on plain polysulfone (PSf) and PSf/TiO2 membrane substrates by a temperature-induced technique using polyvinyl alcohol as a binder. Structure property elucidation was carried out by X-ray diffraction, microscopy, spectroscopy, contact angle measurement, and water uptake studies. The increase in hydrophilicity followed the order: PSf < PSf/TiO2 < PSf/TiO2/CS membranes. Use of this thin-film composite membrane for chromium removal was investigated with regards to the effects of light and pH. The observations reveal 100 % reduction of Cr(VI) to Cr(III) through electrons and protons donated from OH and NH2 groups of the CS layer; the reduced Cr(III) species are adsorbed onto the CS layer via complexation to give chromium-free water.

Synthesis and characterization of novel thin film nanocomposite reverse osmosis membranes with improved organic fouling properties for water desalination

Incorporation of HNTs into PA layer improved not only the structural and separation characteristics of composite membrane but also its antifouling properties.