Voltammetric and EQCM Studies on Selenium(IV) at Mercury, Gold and Glassy Carbon Electrodes in the Presence of Cu(II), Au(III), Pb(II) and Cd(II)

Investigation into the voltammetric behaviour and detection of selenium(IV) at metal electrodes in diverse electrolyte media

The voltammetric behaviour of selenium(IV) was studied at platinum and gold electrodes in sulphuric acid, perchloric acid and potassium chloride media as a basis for its voltammetric detection. The best voltammetric behaviour was recorded at gold electrodes with perchloric acid as the supporting electrolyte. The concomitant presence of metals, such as copper or lead, and of model biomolecules, such as bovine serum albumin, in the solution resulted in a deterioration of the electrochemical response for selenium(IV). Quantitative detection of selenium(IV) by square wave anodic stripping voltammetry at both a millimetre-sized gold disc electrode and a microband electrode array revealed linear responses to selenium concentration in the ranges 5-15 μM and 0.1-10 μM, respectively, with 60s preconcentration. The sensitivities were 6.4 μA μM(-1) cm(-2) and 100 μA μM(-1) cm(-2) at the disc and the microband array, respectively. The detection limit at the microband electrode array was 25 nM, illustrating the potentiality of such microelectrodes for the development of mercury-free analytical methods for the trace detection of selenium(IV).

Ultratrace Determination of Inorganic Selenium without Signal Calibration

To more readily evaluate the complex biogeochemistry of selenium, a flow-through electrochemical method was developed that can accurately determine Se(IV) concentrations in aqueous samples to part-per-trillion levels without signal calibration. Stripping methods were used in conjunction with a high-efficiency, flow-through cell. The cell was designed with a novel gold working electrode that was separated from a porous counter electrode by a Nafion membrane. Because this design permitted exhaustive deposition of selenium from the sample stream as well as efficient coulometric stripping, determinations obeyed Faraday's law over a reasonably wide range of operating conditions. The method had a minimum quantitation limit of approximately 8 ng and a maximum limit of 800 ng for Se(IV). It was reliable for sample volumes as small as 0.5 mL and as high as 20 mL, thereby allowing determinations from part-per-million to just below part-per-billion levels. Interferences from Cu(II) and arsenate were evident, but only when these species were present at concentrations exceeding 10 mg.L-1. Overall, the method had a performance comparable to hydride-generation atomic absorption spectrometry but with less cumbersome equipment and freedom from calibration.