An MRI calorimetry technique to measure tissue ultrasound absorption

An improved method to estimate ultrasonic absorption in agar-based gel phantom using thermocouples and MR thermometry

In this paper, a novel experimental set-up was developed that measures the absorption coefficient. The proposed system was evaluated in an agar-based gel phantom. The new experimental system provides accurate and fast measurement of the rate of temperature change within the phantom. The rate of temperature change was measured using thermocouple and was confirmed using MR thermometry. An ultrasonic transducer with a broad beam was used in order to reduce the conduction effect. The absorption coefficient of the agar-based phantom was 0.26 dB/cm-MHz using 4% agar, 30% evaporated milk and 4% silica. The absorption coefficient increased by increasing the volume of the evaporated milk, and agar. The absorption coefficient increased at low silica concentration (<4%) and then decreased at higher concentration of silica (>4%). By proper selection of evaporated milk, agar and silica concentration, it is possible to achieve similar coefficient like in soft tissues. Acoustic absorption measurement is considered as a difficult measurement in ultrasonics because obtaining the precise temperature change in the focus is challenging. Due to the quick and accurate placement of the thermocouple at the ultrasonic beam, it is possible with the proposed system to perform absorption measurement is less than one minute.

On ultrasound waves guided by bones with coupled soft tissues: a mechanism study and in vitro calibration

The influence of soft tissues coupled with cortical bones on precision of quantitative ultrasound (QUS) has been an issue in the clinical bone assessment in conjunction with the use of ultrasound. In this study, the effect arising from soft tissues on propagation characteristics of guided ultrasound waves in bones was investigated using tubular Sawbones phantoms covered with a layer of mimicked soft tissue of different thicknesses and elastic moduli, and an in vitro porcine femur in terms of the axial transmission measurement. Results revealed that presence of soft tissues can exert significant influence on the propagation of ultrasound waves in bones, leading to reduced propagation velocities and attenuated wave magnitudes compared with the counterparts in a free bone in the absence of soft tissues. However such an effect is not phenomenally dependent on the variations in thickness and elastic modulus of the coupled soft tissues, making it possible to compensate for the coupling effect regardless of the difference in properties of the soft tissues. Based on an in vitro calibration, this study proposed quantitative compensation for the effect of soft tissues on ultrasound waves in bones, facilitating development of high-precision QUS.

MR acoustic radiation force imaging: in vivo comparison to ultrasound motion tracking

MR acoustic radiation force (ARF) imaging was developed for measuring tiSsue elastic properties using focused ultrasound to deliver a localized tissue motion. In this study, an imaging ultrasound transducer was mounted on the focused ultrasound transducer and ultrasound motion tracking was performed simultaneously to MR ARF imaging to validate the measurement results. In vivo studies on rabbit thigh muscle were performed and results showed a general agreement between the two modalities (slope=0.96 and R2=0.67). The temporal information by the ultrasound measurement indicates that the parameters in MR ARF imaging should be optimized according to the tissue type, acoustic power, and envelope and frequency of the ARF modulation.

Treatment monitoring and thermometry for therapeutic focused ultrasound

Therapeutic ultrasound is currently enjoying increasingly widespread clinical use especially for the treatment of cancer of the prostate, liver, kidney, breast, pancreas and bone, as well as for the treatment of uterine fibroids. The optimum method of treatment delivery varies between anatomical sites, but in all cases monitoring of the treatment is crucial if extensive clinical acceptance is to be achieved. Monitoring not only provides the operating clinician with information relating to the effectiveness of treatment, but can also provide an early alert to the onset of adverse effects in normal tissue. This paper reviews invasive and non-invasive monitoring methods that have been applied to assess the extent of treatment during the delivery of therapeutic ultrasound in the laboratory and clinic (follow-up after treatment is not reviewed in detail). The monitoring of temperature and, importantly, the way in which this measurement can be used to estimate the delivered thermal dose, is dealt with as a separate special case. Already therapeutic ultrasound has reached a stage of development where it is possible to attempt real-time feedback during exposure in order to optimize each and every delivery of ultrasound energy. To date, data from MR imaging have shown better agreement with the size of regions of damage than those from diagnostic ultrasound, but novel ultrasonic techniques may redress this balance. Whilst MR currently offers the best method for non-invasive temperature measurement, the ultrasound techniques under development, which could potentially offer more rapid visualisation of results, are discussed.

Tissue thermal conductivity by magnetic resonance thermometry and focused ultrasound heating

PURPOSE

To investigate the combined use of magnetic resonance (MR) temperature imaging and focused ultrasound (FUS) for the noninvasive determination of tissue thermal properties.

MATERIALS AND METHODS

Brief, spatial impulses of temperature elevation were created in tissue using a spherical, air-backed transducer operating at 1.68 MHz and measured using MR temperature imaging in a 1.5-Tesla clinical scanner. A novel technique based on thermal washout is applied in an analysis of the acquired MR temperature images to estimate tissue thermal conductivity and perfusion.

RESULTS

Numerical simulations and experiments in vitro and in vivo demonstrate that thermal conductivity can be measured to within 10% of the true value with MR thermometry at 1.5 Tesla. With the temperature precision available at 1.5 Tesla, however, robust perfusion estimation is feasible only in highly perfused organs or tumors.

CONCLUSION

This study has developed a method for determining tissue thermal properties specific to the patient and organ at the site of interest, and allows repeated application. This capability is relevant in thermal therapy planning of tumor ablation using MR-guided FUS systems.

Temperature dosimetry using MR relaxation characteristics of poly(vinyl alcohol) cryogel (PVA-C)

Hyperthermic therapy is being used for a variety of medical treatments, such as tumor ablation and the enhancement of radiation therapy. Research in this area requires a tool to record the temperature distribution created by a heat source, similar to the dosimetry gels used in radiation therapy to record dose distribution. Poly(vinyl alcohol) cryogel (PVA-C) is presented as a material capable of recording temperature distributions between 45 and 70 degrees C, with less than a 1 degrees C error. An approximately linear, positive relationship between MR relaxation times and applied temperature is demonstrated, with a maximum of 16.3 ms/ degrees C change in T(1) and 10.2 ms/ degrees C in T(2) for a typical PVA-C gel. Applied heat reduces the amount of cross-linking in PVA-C, which is responsible for a predictable change in T(1) and T(2) times. Temperature distributions in PVA-C volumes may be determined by matching MR relaxation times across the volumes to calibration values produced in samples subjected to known temperatures. Factors such as thermotolerance, perfusion effects, and thermal conductivity of PVA-C are addressed for potentially extending this method to modeling thermal doses in tissue.

Nuclear magnetic resonance spectroscopy and imaging in animal research

Nuclear magnetic resonance (NMR) spectroscopy and imaging can be used to investigate, noninvasively, a wide range of biological processes in systems as diverse as protein solutions, single cells, isolated perfused organs, and tissues in vivo. It is also possible to combine different NMR techniques enabling metabolic, anatomical, and physiological information to be obtained in the same experiment. This review provides a simple overview of the basic principles of NMR and outlines both the advantages and disadvantages of NMR spectroscopy and imaging. A few examples of potential applications of NMR spectroscopy and imaging are presented, which demonstrate the range of questions that can be asked using these techniques. The potential impact of using NMR techniques in a biomedical research program on the total number of animals required for specific investigations, as well as the number of animals used in research, are discussed. The article concludes with a personal perspective on the impact of continuing improvements in NMR technology for future applications in animal research.