Effects of increasing balloon pressure on mechanism and results of balloon angioplasty for treatment of restenosis after Palmaz-Schatz stent implantation: an angiographic and intravascular ultrasound study

Impact of different re-stenting strategies on expansion of a drug-eluting stent implanted to treat bare-metal stent restenosis

We used intravascular ultrasound (IVUS) to compare the expansion of drug-eluting stents (DES) implanted to treat bare-metal stent (BMS) restenosis after 3 common re-stenting strategies. A total of 80 consecutive BMS restenotic targets were re-stented either directly (n = 30, group 1) or after low-pressure (<8 atm) pre-dilation with an undersize regular balloon (n = 16, group 2) or after high-pressure (>12 atm) pre-dilation with a semicompliant balloon the same or greater diameter as the original BMS diameter (n = 34, group 3). More patients from groups 2 and 3 had diabetes mellitus. The targets in group 1 were more proximal and focal. Lesions from groups 2 and 3 were more severe. The size and deployment pressure of the DESs and the achieved angiographic results were all similar. The post-intervention minimum stent area and the percentage of expansion of DES (minimum stent area/distal reference lumen area x 100%) were, however, both significantly larger in group 3 (6.4 +/- 1.5 mm(2) in group 3 vs 5.6 +/- 1.6 mm(2) in group 1 vs 4.4 +/- 1.4 mm(2) in group 2, p <0.001; and 88 +/- 30% in group 3 vs 74 +/- 14% in group 1 vs 73 +/- 23% in group 2, p = 0.021). A post-intervention minimum stent area <5.0 mm(2) was seen in only 3 lesions in group 3 (8.8%) versus 14 in group 1 (46.7%) and 11 in group 2 (68.8%; adjusted odds ratio 0.11, 95% confidence interval 0.03 to 0.38, p <0.001). Overall, the acute lumen gain was mainly from BMS re-expansion; however, the BMS volume increased the most in group 3 (p <0.001). In conclusion, high-pressure pre-dilation leads to superior post-intervention expansion of DESs implanted to treat BMS restenosis, regardless of the original expansion because of the greater BMS re-expansion.

Current understanding of coronary in-stent restenosis. Pathophysiology, clinical presentation, diagnostic work-up, and management

In-stent restenosis is the limiting entity following coronary stent implantation. It is associated with significant morbidity and cost and thus represents a major clinical and economical problem. Worldwide, approximately 250 000 in-stent restenotic lesions per year have to be dealt with. The pathophysiology of instent restenosis is multifactorial and comprises inflammation, smooth muscle cell migration and proliferation and extracellular matrix formation, all mediated by distinct molecular pathways. Instent restenosis has been recognised as very difficult to manage, with a repeat restenosis rate of 50% regardless of the mechanical angioplasty device used. Much more favourable results were reported for the adjunctive irradiation of the in-stent restenotic lesion, with a consistent reduction of the incidence of repeat in-stent restenosis by 50%. Data from the first clinical trials on drug-eluting stents for the treatment of in-stent restenosis have shown very much promise yielding this strategy likely to become the treatment of choice. This review outlines the histological and molecular findings of the pathophysiology, the epidemiology, the predictors and the diagnostic work-up of in-stent restenosis and puts emphasis on the various treatment options for its prevention and therapy.

An integrated semicompliant balloon ultrasound catheter for quantitative feedback and image guidance during stent deployment

An integrated balloon ultrasound catheter prototype was designed to image from inside the balloon for real-time guidance during stent deployment. It was fabricated using a semicompliant balloon material (polyethylene) and a 20 MHz, 64-element circumferential ultrasound array. A commercial stent, nominally 4.4 mm in diameter and 12 mm in length, was used for a phantom study and placed along the length of the integrated balloon ultrasound catheter. A rubber phantom was created with an elastic modulus of 175 kPa with a 4.36 mm diameter lumen. Real-time balloon pressure measurements were recorded using a digital pressure sensor, and real-time radio-frequency (RF) data were captured as the balloon was inflated. The slope of the area-pressure ratio (APR) was compared to a reference measure of the balloon and stent expanded in water to determine a measure for optimal stent deployment. The results clearly indicate stent deployment at 11.1 atm using this metric. The APR slope could serve as quantitative feedback parameter for guiding stent deployment to reduce arterial injury and subsequent restenosis. After the stent deployment experiment, RF data were captured as the balloon catheter was moved along the length of the stent in pullback mode to confirm successful stent deployment. Ultimately, an integrated balloon ultrasound catheter could serve as a single catheter intervention device by providing real-time intravascular ultrasound (IVUS) imaging and quantitative feedback during stent deployment.

Sirolimus-eluting stent implantation and beta-irradiation for the treatment of in-stent restenotic lesions: comparison of underlying mechanisms of acute gain and late loss as assessed by volumetric intravascular ultrasound

BACKGROUND

The aim of the study was to compare the angioplasty mechanisms of drug (sirolimus)-eluting stent (DES) implantation and vascular brachytherapy (VBT) for the treatment of in-stent restenosis (ISR) as assessed by intravascular ultrasound (IVUS).

METHODS

We performed IVUS in 53 patients (28 DES, 25 VBT) before and after angioplasty of ISR and at 6-month follow-up. Cross-sectional areas of the external elastic membrane, the stent, and the lumen were measured. Plaque + media, peristent plaque, and intimal hyperplasia areas were calculated, respectively.

RESULTS

Clinical and IVUS baseline characteristics did not differ between groups at baseline. After the index procedure, the lumen at the stent site was smaller in the DES group (DES 6.7 +/- 2.0 mm2 vs VBT 7.5 +/- 2.2 mm2, P = .042). Because of less intimal hyperplasia (DES 0.2 +/- 0.5 mm2 vs VBT 0.7 +/- 0.7 mm2, P = .043), the lumen dimensions revealed no difference between groups at follow-up (DES 6.5 +/- 2.3 mm2 vs VBT 6.8 +/- 2.2 mm2, P = .374). At the reference site, the index procedure led to a similar increase of plaque + media (DES 0.9 +/- 0.9 mm2 vs VBT 0.6 +/- 1.2 mm2, P = .150). At follow-up, the plaque + media was significantly smaller in the DES group (DES 8.0 +/- 6.6 mm2 vs VBT 9.9 +/- 7.8 mm2, P = .013).

CONCLUSIONS

Drug-eluting stent for the treatment of ISR more effectively inhibits neointima formation when compared with VBT. Yet insufficient stent expansion might be a reason for device failure and should be avoided. At the reference site, lumen loss by an increased plaque burden, as has been well recognized following VBT, is not present with DES.

Stent restenosis and the use of drug-eluting stents in patients with diabetes mellitus

Stents have become the technique of choice for percutaneous revascularization, but in-stent restenosis has remained a clinical challenge. This brief article summarizes the incidence, patterns, and proposed mechanisms of restenosis and outlines its contemporary management with specific focus on the diabetic patient. It includes a synopsis of the strategy of drug-eluting stents, which is the most recent and major advance in percutaneous coronary intervention.

Angiographic analysis of the angioplasty versus rotational atherectomy for the treatment of diffuse in-stent restenosis trial (ARTIST)

Patients with diffuse in-stent restenoses (ISRs) are at high risk for recurrent restenosis after percutaneous transluminal balloon angioplasty (PTCA). Percutaneous transluminal rotational ablation (PTCR) has proved effective in removing neointimal burden in ISRs. This study compares the acute and long-term results of PTCA and PTCR for the treatment of diffuse ISR in a randomized, multicenter investigation. The primary end point was the comparison of the minimum luminal diameter (MLD) between both groups at 6-month follow-up. Patients with symptomatic, diffuse, or high-grade ISRs were included; 146 patients were randomized to PTCA and 152 patients to PTCR. Diameter stenosis was reduced from 80 +/- 12% to 29 +/- 10% and from 80 +/- 11% to 28 +/- 12%, respectively, and MLD increased from 0.55 +/- 0.3 to 1.9 +/- 0.3 mm in the PTCA group and from 0.54 +/- 0.3 mm to 1.9 +/- 0.4 mm in the PTCR group. Spasm in the treated vessel and an intermittent slow flow phenomenon occurred more often after rotational ablation (17.7% vs 8.6%, p = 0.001; 5.3% vs 0%, p = 0.007). Minimum stenosis diameter at 6-month follow-up was smaller in the PTCR group than in the PTCA group (1.0 +/- 0.6 vs 1.2 +/- 0.6 mm, p = 0.008) and the restenosis rate was higher (64.9% vs 51.2%, p = 0.027). Procedural factors did not influence long-term outcome. In the PTCR group, the restenosis rate increased with decreasing vessel size, whereas this was not seen in the PTCA group. The lesion length and the baseline diameter stenosis were found to be predictive of restenosis with both treatment strategies; however, a residual diameter stenosis of <30% predicted absence of a restenosis only in the PTCR group. Thus, PTCA and PTCR of diffuse ISRs yield comparable acute angiographic results. The recurrence of a restenosis is higher after PTCR than after PTCA.

Mechanism of cutting balloon angioplasty for in-stent restenosis: an intravascular ultrasound study

We investigated by intravascular ultrasound (IVUS) the mechanism of action of cutting balloon (CB) angioplasty in patients with in-stent restenosis. Seventy-one consecutive restenotic lesions of 66 patients were studied by quantitative coronary angiography (QCA) and IVUS before, immediately after, and, in 20 cases, at 24-hr time interval after CB. CB was selected according to 1:1 CB-to-stent ratio and inflated at 8 atm for 60-90 sec. Both IVUS planar and volumetric (Simpson's rule, 25 patients) analysis were carried out. IVUS measurements included external elastic membrane area (EEMA), stent area (SA), minimal lumen area (MLA), and restenosis area (RA). Following CB, QCA analysis showed increase of minimal lumen diameter (1.17 +/- 0.46 vs. 2.45 +/- 0.51 mm; P < 0.0001) and decrease of diameter stenosis (64% +/- 13% vs. 21% +/- 9%; P < 0.0001). IVUS measurements showed a significant increase of MLA (2.18 +/- 0.80 vs. 7.31 +/- 1.8 mm(2); P < 0.0001), SA (9.62 +/- 2.6 vs. 10.7 +/- 2.75 mm(2); P < 0.0001), and EEMA (17.27 +/- 5 vs. 18.1 +/- 5 mm(2); P < 0.0001) and a decrease of RA (7.43 +/- 2.63 vs. 3.45 +/- 1.39 mm(2); P < 0.0001). No significant change was observed in the original plaque + media area (7.65 +/- 3 vs. 7.38 +/- 2.9 mm(2); P = NS). Thus, of the total lumen enlargement (5.13 +/- 1.85 mm(2)), 23% was the result of increase in mean SA, whereas 77% was the result of a decrease in mean RA. These changes were associated with a 5% increase in EEMA. IVUS volumetric changes paralleled planar variations. Angiographic and IVUS changes were well maintained at 24 hr. CB enlarges coronary lumen mainly by in-stent tissue reduction associated with a moderate degree of additional stent expansion. Favorable QCA and IVUS acute results are maintained at 24 hr.