Synthesis of Chiral Covalent Organic Frameworks via Asymmetric Organocatalysis for Heterogeneous Asymmetric Catalysis

A general and efficient organocatalytic asymmetric polymerization approach for the synthesis of chiral covalent organic frameworks (CCOFs) has been developed. With a chiral 2-methylpyrrolidine catalyst, a series of tris(N-salicylideneamine)-derived β-ketoenamine-CCOFs are directly constructed from prochiral aldehyde- and primary amine-monomers. The adopted aminocatalytic asymmetric Schiff-base condensation herein is performed under ambient conditions with clear green synthetic advantages over the conventional acid-catalysed solvothermal methods. The obtained β-ketoenamine-CCOFs can be further metalated by a solid-state coordination approach, and the resulting Cu^II @CCOFs can highly promote an asymmetric A³ -coupling reaction. Specifically, a Cu^II @CCOF@chitosan aerogel was fabricated as a highly efficient fixed-bed model reactor for scaled-up catalysis. The concept of aminocatalytic asymmetric polymerization might open a new way for constructing the CCOFs via asymmetric organocatalysis.

Transition Metal-Free Synthesis of Carbamates Using CO2 as the Carbon Source

Utilization of carbon dioxide as a C1 synthon is highly attractive for the synthesis of valuable chemicals. However, activation of CO₂ is highly challenging, owing to its thermodynamic stability and kinetic inertness. With this in mind, several strategies have been developed for the generation of carbon-heteroatom bonds. Among these, formation of C-N bonds is highly attractive, especially, when carbamates can be synthesized directly from CO₂ . This Minireview focuses on transition metal-free approaches for the fixation of CO₂ to generate carbamates for the production of fine chemicals and pharmaceuticals. Within the past decade, transition metal-free approaches have gained increasing attention, but traditional reviews have rarely focused on these approaches. Direct comparisons between such methods have been even more scarce. This Minireview seeks to address this discrepancy.

Organocatalyzed Domino Synthesis of New Thiazole-Based Decahydroacridine-1,8-diones and Dihydropyrido[2,3-d : 6,5-d']- dipyrimidines in Water as Antimicrobial Agents

Organopromoter, 2-aminoethanesulfonic acid was used to catalyze the synthesis of a series of structurally intriguing new hybrids thiazolyl acridine-1,8(2H,5H)-diones and dihydropyrido[2,3-d : 6,5-d']dipyrimidine-2,4,6,8(1H,3H,5H,7H)-tetraones for the first time. 2-Aminoethanesulfonic acid is a biobased organopromoter, used to generate four new bonds for the synthesis of new coupled thiazole-based decahydroacridine-1,8-diones. Superior green credentials, operational simplicity, easy work-up and recyclability of the catalyst are the key strengths of this method. The broad substrate scope, mild reaction conditions, short reaction time, cost effectiveness, high atom economy and good to excellent yields make the present method a distinct improvement over existing methods. Spectral (IR, ¹ H-NMR,¹³ C-NMR, Mass) data and elemental analyses confirmed the structures of the titled products. A series of thiazolyl acridine-1,8(2H,5H)-diones and dihydropyrido[2,3-d : 6,5-d']dipyrimidine-2,4,6,8(1H,3H,5H,7H)-tetraones were screened for their antimicrobial activity against four bacterial and three fungal strains.

Insight into Isothiourea-Catalyzed Enantioselective Addition of Saturated Esters to Iminium Ions

The possible mechanisms and origin of the selectivities of isothiourea-catalyzed addition of saturated esters to iminium ions have been investigated by density functional theory. The favorable reaction pathway includes three stages: formation of an ammonium enolate intermediate, enantioselective addition of the ammonium enolate intermediate to the iminium ion, and dissociation of the catalyst to form the product. The enantioselective addition process is the stereoselectivity-determining step, while the chemoselectivity-determining step is included in the formation of the final product. The calculated energy barriers show that the chemoselectivity is thermodynamically controlled, and it depends on the polarities of the products and the nucleophilicities of the N atoms of the enamine reactant moieties of the intermediates. The origin of the stereoselectivity was investigated by non-covalent interaction analysis of the key transition states. Hydrogen bonding interactions were identified as the determining factor for controlling the stereoselectivity. The obtained insight will be valuable for rational design of novel Lewis base organocatalyst-promoted enantioselective addition reactions with special chemoselectivities.

Palladium-Catalyzed Construction of Quaternary Stereocenters by Enantioselective Arylation of γ-Lactams with Aryl Chlorides and Bromides

Herein, we report the first Pd-catalyzed enantioselective arylation of α-substituted γ-lactams. Two sets of conditions were developed for this transformation, allowing for the use of either aryl chlorides or bromides as electrophiles. Utilizing a highly electron-rich dialkylphosphine ligand we have been able to construct α-quaternary centers in good yields (up to 91 % yield) and high enantioselectivities (up to 97 % ee).

Design of Chiral Bifunctional Dialkyl Sulfide Catalysts for Regio-, Diastereo-, and Enantioselective Bromolactonization

Although a wide variety of chiral organocatalysts have been developed for asymmetric transformations, effective chiral dialkyl sulfide organocatalysts remain relatively rare and under-developed, despite the potential utility of dialkyl sulfide catalysts. Herein, we report the development of chiral bifunctional dialkyl sulfide catalysts possessing a urea moiety for regio-, diastereo-, and enantioselective bromolactonization. The importance of the bifunctional design of chiral sulfide catalysts was clearly demonstrated in the present work. The roles of both the sulfide and urea moieties of the catalyst were clarified based on the results of experimental and theoretical investigation.

Simple and Effective Catalyst Separation by New CO2 -Induced Switchable Organocatalysts

CO₂ -induced switchable tertiary amine-based organocatalysts were investigated for an efficient catalyst and product separation by its different partitioning between an organic and carbonated water phase. In this case study, the switching ability of eight tertiary amine-based catalysts between the organic and water phase by addition or removal of CO₂ was investigated. Here, the catalyst switched both nearly completely (99.9 %) into the aqueous phase by addition of CO₂ and effectively back into the organic phase (99.3 %) by expelling CO₂ . With this technique, the organocatalyst was successfully recovered and reused twelve times without significant loss of activity (up to 90 % enantiomeric excess) for the asymmetric nitroaldol (Henry) reaction. After the first catalyst switch, evaporation of the solvent affords the product in 98 % purity without any further purification steps.

Hydrogen-Bonding Catalysis of Tetraalkylammonium Salts in an Aza-Diels-Alder Reaction

A piperidine-derived tetraalkylammonium salt with a non-coordinating counteranion worked as an effective hydrogen-bonding catalyst in an aza-Diels-Alder reaction of imines and a Danishefsky diene. The hydrogen-bonding interaction between the ammonium salt and an imine was observed as part of a (1) H NMR titration study.

Switchable-Hydrophilicity Solvents for Product Isolation and Catalyst Recycling in Organocatalysis

Switchable-hydrophilicity solvents (SHSs) are solvents that can switch reversibly between a water-miscible state to a state that forms a biphasic mixture with water. In this case study, SHSs have been studied for easy product/catalyst separation as well as catalyst recycling. A series of tertiary amine SHSs have been identified for the extraction of the hydrophilic product from the postreaction mixture. Here, we determined high extraction efficiencies for the product (>84%) and low extraction rates for the catalyst (<0.1%). With the catalyst recycling experiments, we isolated the product in high purity (>98%) without further purification steps. At the same time, the catalyst was reused without any loss of activity (>91% enantiomeric excess, >99% yield) four times. Furthermore, we optimized the extraction efficiency by working with a microextractor. In addition, with the use of a falling-film microreactor, we obtained the product with high enantioselectivity by working at ambient conditions.

Preparation of Poly(ionic liquid)s-Supported Recyclable Organocatalysts for the Asymmetric Nitroaldol (Henry) Reaction

A novel strategy for the embedding of quinine-based organocatalysts in polymerized ionic liquids-based hydrogels is presented. With this technique, the encapsulated organocatalyst was successfully recovered and reused for four cycles without any loss of enantioselectivity (up to 91% ee) for the asymmetric nitroaldol (Henry) reaction. In this study, high catalyst leaching was significantly reduced (<0.01%) by controlling the water content. After catalyst removal, evaporation of the solvent affords the product in 98% purity without any further purification.

Tetraalkylammonium Salts as Hydrogen-Bonding Catalysts

Although the hydrogen-bonding ability of the α hydrogen atoms on tetraalkylammonium salts is often discussed with respect to phase-transfer catalysts, catalysis that utilizes the hydrogen-bond-donor properties of tetraalkylammonium salts remains unknown. Herein, we demonstrate hydrogen-bonding catalysis with newly designed tetraalkylammonium salt catalysts in Mannich-type reactions. The structure and the hydrogen-bonding ability of the new ammonium salts were investigated by X-ray diffraction analysis and NMR titration studies.

Highly enantioselective cross-aldol reactions of acetaldehyde mediated by a dual catalytic system operating under site isolation

Polystyrene-supported (PS) diarylprolinol catalysts 1 a (Ar = phenyl) and 1 b (Ar = 3,5-bis(trifluoromethyl)phenyl) have been developed. Operating under site-isolation conditions, PS-1 a/1 b worked compatibly with PS-bound sulfonic acid catalyst 2 to promote deoligomerization of paraldehyde and subsequent cross-aldol reactions of the resulting acetaldehyde in one pot, affording aldol products in high yields with excellent enantioselectivities. The effect of water on the performance of the catalytic system has been studied and its optimal amount (0.5 equiv) has been determined. The dual catalytic system (1/2) allows repeated recycling and reuse (10 cycles). The potential of this methodology is demonstrated by a two-step synthesis of a phenoperidine analogue (68% overall yield; 98% ee) and by the preparation of highly enantioenriched 1,3-diols 4 and 3-methylamino-1-arylpropanols 5, key intermediates in the synthesis of a variety of druglike structures.

Aggregation and cooperative effects in the aldol reactions of lithium enolates

Density functional theory and Car-Parrinello molecular dynamics simulations have been carried out for model aldol reactions involving aggregates of lithium enolates derived from acetaldehyde and acetone. Formaldehyde and acetone have been used as electrophiles. It is found that the geometries of the enolate aggregates are in general determined by the most favorable arrangements of the point charges within the respective Lin On clusters. The reactivity of the enolates follows the sequence monomer≫dimer>tetramer. In lithium aggregates, the initially formed aldol adducts must rearrange to form more stable structures in which the enolate and alkoxide oxygen atoms are within the respective Lin On clusters. Positive cooperative effects, similar to allosteric effects found in several proteins, are found for the successive aldol reactions in aggregates. The corresponding transition structures show in general sofa geometries.