Study of plasma-polyethylene interactions using electron beam-generated plasmas produced in Ar/SF6 mixtures

Effect of Non-Thermal Sulfur Hexafluoride Cold Plasma Modification on Surface Properties of Polyoxymethylene

X-ray photoelectron spectroscopy was employed to reveal the differences in the chemical structure of the topmost layer after plasma modification. It was found out that changes in the surface properties of the polymer could be observed even after 20 seconds of treatment. The surface becomes hydrophobic or superhydrophobic, with the water contact angles up to 160 degrees. Morphological changes and increased roughness can be observed only in the nanoscale, whereas the structure seems to be unaffected in the microscale. As a result of plasma modification a permanent hydrophobic effect was obtained on the polyoxymethylene surface.

Plasma electron source for generating a ribbon beam in the forevacuum pressure range

We describe a plasma-cathode electron beam source based on a hollow cathode glow discharge and operating in the forevacuum pressure range that produces a steady-state ribbon beam. The electron beam is generated in the pressure range of 10-30 Pa. A multi-aperture electron extraction and beam formation system is used to provide beam stability and enhanced uniformity of beam current density, allowing the use of this kind of device for beam-plasma surface modification over relatively large areas.

Comparison of SF₆ and CF₄ Plasma Treatment for Surface Hydrophobization of PET Polymer

The fluorination of the polymer polyethylene terephthalate in plasma created from SF₆ or CF₄ gas at various pressures was investigated. The surface was analysed by X-ray photoelectron spectroscopy and water contact angle measurements, whereas the plasma was characterized by optical emission spectroscopy. The extent of the polymer surface fluorination was dependent on the pressure. Up to a threshold pressure, the amount of fluorine on the polymer surface and the surface hydrophobicity were similar, which was explained by the full dissociation of the SF₆ and CF₄ gases, leading to high concentrations of fluorine radicals in the plasma and thus causing the saturation of the polymer surface with fluorine functional groups. Above the threshold pressure, the amount of fluorine on the polymer surface significantly decreased, whereas the oxygen concentration increased, leading to the formation of the hydrophilic surface. This effect, which was more pronounced for the SF₆ plasma, was explained by the electronegativity of both gases.

Plasma-Based Chemical Modification of Epitaxial Graphene

In this work, the treatment of epitaxial graphene on SiC using electron beam generated plasmas produced in mixtures of argon and oxygen is demonstrated. The treatment imparts oxygen functional groups on the surface with concentrations ranging up to about 12 at.%, depending on treatment parameters. Surface characterization of the functionalized graphene shows incorporation of oxygen to the lattice by disruption of ∏-bonds, and an altering of bulk electrical properties.