Carbon Dot-NaCl Crystals for White-Light Generation and Fabry-Perot Lasing

Recent advances in fluorescence and afterglow of CDs in matrices

Carbon dots (CDs) are novel nanomaterials with dimensions less than 10 nm that have attracted much attention due to their outstanding optical properties. However, the development of solid-state fluorescence and afterglow methods has been relatively slow, although the properties of these materials under liquid conditions have been extensively studied. In recent years, embedding CDs in a matrix has been shown to prevent aggregation quenching and inhibit nonradiative transitions, thus realizing solid-state fluorescence and afterglow, which has greatly broadened the research and application areas of CDs. In terms of hydrogen bonding, ionic bonding, covalent bonding and spatial confinement, the interactions between CDs and matrices can effectively realize and improve the solid-state fluorescence and afterglow effects of CDs. Recent applications of CDs in matrices in optoelectronics, information security, sensing, biotherapeutics and imaging are also summarized. Finally, we summarize the challenges and developments of CDs in matrices.

One-step synthesis of orange-red emissive carbon dots: photophysical insight into their excitation wavelength-independent and dependent luminescence

A low-temperature method was developed to synthesize orange-red luminescence phosphor-doped carbon dots (CDs) without complicated purification procedures. These CDs showed excitation wavelength-independent narrow emission (photo-luminescence quantum yield, Φf ∼ 12 to 22%) with single exponential time-resolved decay in weakly polar/non-polar solvents, indicating the presence of one kind of chromophore. In contrast, the same CDs showed excitation wavelength-dependent broad emission (Φf ∼ 1 to 8%) with multi-exponential fluorescence decay in polar solvents. These CDs exhibited poor solubility in polar solvents, resulting in CD aggregates contributed by excitation wavelength-dependent weak luminescence. The CDs embedded in polymethyl methacrylate (PMMA) polymer film displayed bright orange-red fluorescence under UV 365 nm illumination, indicating their potential application in solid-state luminescence. Further, an analytical method was developed for the naked-eye detection of trifluoracetic acid (red emission) and triethylamine (green emission) under UV 365 nm illumination with reversible two switch-mode luminescence. Additionally, this efficient orange-red luminescence of CDs was utilized for possible bioimaging applications with negligible cytotoxicity in 3T3 mouse fibroblast cells.

Understanding the aggregation of excitation wavelength independent emission of amphiphilic carbon dots for bioimaging and organic acid sensing

Herein, excitation wavelength-independent, tunable emissive and amphiphilic CDs with high quantum yield were synthesized by a low-temperature oxidation method employing banana peel waste as a carbon source. These CDs showed longer wavelength emissions (green to yellow) independent of the excitation wavelength when dispersed in different polar to non-polar solvents. The quantum yields of the same CDs were 9-32% in different solvent polarities for different emissions. On the other hand, a large stokes-shifted emission (∼9606 cm^-1) was observed for CDs in the non-polar and weak polar solvents. The particle size of CDs increases from a hydrophobic to a hydrophilic environment with the change in emission colour from yellow to green. A polar and a non-polar host matrix were used to overcome the limitation of aggregation-caused quenching of CDs in the solid state to obtain bright emissions. These CDs were potentially used for naked-eye detection of trifluoroacetic acid (TFA) by changing the emission colour from yellow to orange under UV 365 nm. Sensing of TFA was also shown reversibly switch emission colour and average lifetime for multiple cycles. Additionally, the highly emissive CDs show negligible cytotoxicity in 3T3 fibroblast cells, indicating possible bioimaging applications in 3T3 cells.

Ultra-Broadband Random Laser and White-Light Emissive Carbon Dots/Crystal In-Situ Hybrids

The continuous white-light emission of carbon dots (CDs) can be applied to producing multicolor laser emissions by one single medium. Meanwhile, the solid-state emission greatly contributes to its practical application. In this work, a strategy to realize the in-situ hybridization of silane-functionalized CDs (SiCDs) and 1,3,5-benzenetricarboxylic acid trimethyl ester (Et3BTC) by a one-pot solvothermal method is reported. Significantly, the SiCDs/Et3BTC hybrid crystals exhibit ultra-broadband random laser emission over the near ultraviolet-visible region under 265 nm nanosecond pulsed laser excitation. The wavelength region of laser emission is achieved from 315 to 600 nm within an emission band of CDs-based materials. It is worth noting that the wavelength range of the laser is wider than the previously reported works. It is proposed that the continuous white-light emission of SiCDs caused by multiple fluorescence centers mainly gives rise to the broadband random laser emission. Moreover, the crystals are conducive to forming resonance and realizing solid-state laser emission. This in-situ method is expected to enable a more convenient, cheaper, and greener approach to prepare luminescent hybrids for application in multicolor laser displays, multi-level laser anti-counterfeiting, supercontinuum light sources, and so on.

Rapid and sensitive naked eye detection of faecal pigments using their enhanced solid-state green fluorescence on a zinc acetate substrate

The identification of trace faecal pigments in real-time and on-site detection remains a challenge for water quality monitoring. Herein, a simple, low-cost and rapid fluorescence-based analytical method has been developed in a solid matrix for faecal pigments like stercobilin and urobilin detection. This was made possible due to significant enhancement of green solid-state fluorescence (520 nm) by zinc(II) complexation with faecal pigments embedded in the surface of zinc acetate crystals. It enables naked-eye detection of these pigments even at a 10 μM level when excited with 365 nm blue-UV. It was demonstrated that easily available white cellulose paper strips or TLC silica plates coated with zinc acetate can be used as substrates. A photophysical study of solid-state faecal pigments-zinc(II) complexes suggests that green fluorescence enhancement results from the complexation, which can be attributed to the substantial decrease of the non-radiative decay rate (k_nr) as well as more efficient use of excitation light. The observation of reduced interference of humic acid fluorescence makes faecal pigment detection more efficient by this proposed method.

Photophysics of faecal pigments stercobilin and urobilin in aliphatic alcohols: introduction of a sensitive method for their detection using solvent phase extraction and fluorometry

Faecal pigments (FPs) are ubiquitous in the environment and are a primary contaminant in groundwater and surface water. This article presents a new analytical paradigm by a fluorescence coupled extraction-based method involving FP fluorescence enhancement and minimization of background fluorescence for high sensitivity detection. FPs show higher fluorescence intensity in aliphatic alcohols due to the breaking down of higher-order H-aggregates into lower-order H-aggregates (dimers). DFT studies using the B3LYP functional and LANL2DZ basis set show π-π stacking and hydrogen-bonding contributions towards forming H-aggregated dimers of FPs in the implicit and explicit solvent environments of 1-hexanol. This study is the first report on the extractability of FPs using 1-hexanol as an efficient extraction medium in comparison to higher-order aliphatic alcohols (1-butanol, 1-hexanol and 1-octanol). Furthermore, FP-Zn(II) complexes in 1-hexanol medium significantly enhance the fluorescence emission intensity (∼14-17 times), and the emission intensity remains stable over time. This further helps to increase the detection limit of FPs in the picomolar to sub-picomolar concentration range. This study proposes a protocol involving extraction of FPs by 1-hexanol followed by the complexation of FPs with Zn(II) in the alcohol media and subsequent fluorimetric detection of the FP-Zn(II) complex with a high level of sensitivity, enabled by reduced interference from the background fluorescence of humic acid. The complexation behaviour of FPs with various metal salts was also examined, which provided an understanding of the fluorescence behaviour of FPs with various other metal ions commonly present in natural environmental water. The proposed analytical method has been further validated using real water samples.