The Potential of Spent Coffee Grounds @ MOFs Composite Catalyst in Efficient Activation of PMS to Remove the Tetracycline Hydrochloride from an Aqueous Solution

The efficient removal of Tetracycline Hydrochloride (TC) from wastewater, which is a difficult process, has attracted increasing attention. Aiming to synchronously achieve the goal of natural waste utilization and PMS activation, we have combined the MOFs material with waste coffee grounds (CG). The catalytic activity of the CG@ZIF-67 composite in the TC removal process was thoroughly evaluated, demonstrating that the TC removal rate could reach 96.3% within 30 min at CG@ZIF-67 composite dosage of 100 mg/L, PMS concertation of 1.0 mM, unadjusted pH 6.2, and contact temperate of 293.15 K. The ¹O₂ and ·SO₄^- in the CG@ZIF-67/PMS/TC system would play the crucial role in the TC degradation process, with ¹O₂ acting as the primary ROS. The oxygen-containing functional groups and graphite N on the surface of CG@ZIF-67 composite would play a major role in efficiently activating PMS and correspondingly degrading TC. In addition, the CG@ZIF-67/PMS/TC system could withstand a wide pH range (3-11). The application of CG in preparing MOF-based composites will provide a new method of removing emerging pollutants from an aqueous solution.

Electrochemical degradation of tetracycline hydrochloride in sulfate solutions on boron-doped diamond electrode: The accumulation and transformation of persulfate

In this study, a novel electrifying mode (divided power-on and power-off stage) was applied in the system of BDD activate sulfate to degrade tetracycline hydrochloride (TCH). The BDD electrode could activate sulfate and H₂O to generate sulfate radicals (SO₄^•-) and hydroxyl radicals (^•OH) to remove TCH, and SO₄^•- could dimerize to form S₂O₈^2-. Then, the S₂O₈^2- was activated by heat and quinones to generate SO₄^•- for the continuous degradation of TCH during the power-off stage. In addition, the intermittent time has a significant effect on the degradation of TCH. Factors, affecting the accumulation of S₂O₈^2-, were analyzed using a full factorial design, and the accumulation of S₂O₈^2- could reach 16.2 mM in 120 min. The results of electron spin resonance and radical quenching test showed that SO₄^•-, ^•OH, direct electron transfer (DET), and non-radical in the system could effectively degrade TCH, and SO₄^•- was dominated. The intermediate products of TCH were analyzed by HPLC-QTOF-MS/MS, and the TCH mainly underwent hydroxylation, demethylation and ring opening reactions to form small molecules, and finally mineralized. The results of the feasibility analysis revealed that some intermediates have high toxicity, but the system could improve the toxicity. The results of energy consumption indicated that the intermittent electrifying mode could make full use of the persulfate generated during the power-on stage and reduce about 30% energy consumption. In conclusion, this work demonstrated that it was economically feasible to degrade TCH in wastewater by activating sulfate with BDD electrodes with an intermittent electrifying mode.

Chemical Vapor Deposition Growth of MoS2 on g-C3N4 Nanosheets for Efficient Removal of Tetracycline Hydrochloride

MoS₂ was vertically grown on g-C₃N₄ nanosheets by chemical vapor deposition to prepare nanocomposites named MS-CN samples. Because of a large-surface area of 545.2 m²·g^-1 and a total pore volume of 1.7 cm³·g^-1, the sample MS-CN revealed fast and large adsorption capacity for tetracycline hydrochloride (TCH). The adsorption kinetics model proved that TCH could be rapidly adsorbed within 5 min, and chemical adsorption was dominant. For single-component adsorption of TCH, the maximum adsorption capacity was ∼154 mg/g. The monolayer adsorption was carried out on the surface of MS-CN. Both of the film and intra-particle diffusion were considered as significant processes to facilitate adsorption. Thermodynamic parameters indicate that the adsorption of TCH is a spontaneous endothermic process. The adsorption of TCH was highly pH-dependent. The maximum adsorption capacity of TCH was obtained in the case of pH ∼ 7. After four adsorption and desorption cycles, MS-CN still maintained well-adsorption performance. Multiple adsorption mechanism, pore filling, electrostatic force, π-π conjugation, and hydrogen bonding interactions were studied. Because of fast adsorption, large adsorption capacity, and high stability, it is a promising adsorbent for antibiotics.

A High Flux Electrochemical Filtration System Based on Electrospun Carbon Nanofiber Membrane for Efficient Tetracycline Degradation

In this work, an electrochemical filter using an electrospun carbon nanofiber membrane (ECNFM) anode fabricated by electrospinning, stabilization and carbonization was developed for the removal of antibiotic tetracycline (TC). ECNFM with 2.5 wt% terephthalic acid (PTA) carbonized at 1000 °C (ECNFM-2.5%-1000) exhibited higher tensile stress (0.75 MPa) and porosity (92.8%), more graphitic structures and lower electron transfer resistance (23.52 Ω). Under the optimal condition of applied voltage 2.0 V, pH 6.1, 0.1 mol L−1 Na2SO4, initial TC concentration 10 ppm and membrane flux 425 LMH, the TC removal efficiency of the electrochemical filter of ECNFM-2.5%-1000 reached 99.8%, and no obvious performance loss was observed after 8 h of continuous operation. The pseudo-first-order reaction rate constant in flow-through mode was 2.28 min−1, which was 10.53 times higher than that in batch mode. Meanwhile, the energy demand for 90% TC removal was only 0.017 kWh m−3. TC could be converted to intermediates with lower developmental toxicity and mutagenicity via the loss of functional groups (-CONH2, -CH3, -OH, -N(CH3)2) and ring opening reaction, which was mainly achieved by direct anodic oxidation. This study highlights the potential of ECNFM-based electrochemical filtration for efficient and economical drinking water purification.

Efficient degradation of tetracycline hydrochloride by photocatalytic ozonation over Bi2WO6

Photocatalytic ozonation technique for wastewater treatment has received much attention for their efficient capability in the mineralization of persistent organic pollutants. In this study, nanostructured Bi₂WO₆ was prepared by hydrothermal method and applied in the photocatalytic ozonation process for tetracycline hydrochloride (TCH) degradation under simulated solar light irradiation. Bi₂WO₆ triggered an effective synergy between photocatalysis and ozonation, and it showed a good activity and adaptability in the degradation of organic compounds. Besides, the influence of experimental factors on the total organic carbon removal (including catalyst dosage, ozone concentration, initial pH, reaction temperature and coexisting ions) was also investigated comprehensively. Spin-trapping electron paramagnetic resonance measurements and quenching experiments demonstrated that O₂^-, OH, ¹O₂ and h⁺ contributed to TCH degradation. The possible degradation pathways of TCH were proposed by identifying the intermediates with liquid chromatography-mass spectroscopy.