Photostability studies for micellar liquid chromatographic determination of nifedipine in serum and urine samples

Comparative Bioequivalence and Food Effect of Two Formulations of 30-mg Nifedipine Controlled-Release Tablets in Healthy Chinese Adults

Nifedipine is a potent antihypertensive medication classified as a dihydropyridine calcium channel blocker. The objective of this trial was to assess the bioequivalence of a 30-mg nifedipine controlled-release tablet and a reference drug in a cohort of healthy Chinese individuals. Two independent open-label, randomized, single-dose, crossover studies were conducted, 1 under fasting conditions (N = 44, with 1 participant dropping out midway) and the other under fed conditions (N = 44, with 4 participants dropping out midway). Plasma concentrations of nifedipine were determined using liquid chromatography-mass spectrometry, and pharmacokinetic (PK) parameters were calculated using noncompartmental analysis with Phoenix WinNonlin 8.0 software. In both fasting and fed studies, reasonable bioequivalence was observed for the PK parameters of both the test product and the reference drug. A good safety profile was demonstrated for both the test product and reference drug, with no serious adverse events reported, and both were similarly well tolerated. An important observation with food coadministration was that systemic exposure to nifedipine (based on area under the curve, AUC0-∞) was reduced by approximately 12%. The bioequivalence of the test product and reference drug under fasting/fed conditions in healthy subjects in China was demonstrated by the study results.

Complex Spectroscopy Studies of Nifedipine Photodegradation

The aim of this work is to highlight the influence of UV light on the hydrolysis reaction of nifedipine (NIF) in the presence of alkaline solutions. In this context, the photodegradation of NIF in the absence of alkaline solutions caused (a) a change in the ratio between the absorbances of three bands in the UV-VIS spectra localized at 224-240 nm, 272-276 nm and 310-340 nm, assigned to the electronic transitions of -COOCH3 groups, -NO2 groups and a heterocycle with six atoms; (b) a red-shift of the photoluminescence (PL) band from 458 nm to 477 nm, simultaneous with an increase in its intensity; (c) a decrease in the ratio of the Raman line intensities, which peaked at 1224 cm-1 and 1649 cm-1, associated with the vibrational modes of -C-C-O in the ester group and C=C stretching; and (d) a decrease in the ratio between the absorbances of the IR bands, which peaked at 1493 cm-1 and 1223 cm-1, associated with the vibrational modes of the -NO2 group and C-N stretching. These changes were explained considering the NIF photodegradation reaction, which leads to the generation of the compound 4-(2-nitrosophenyl)-2.6-dimethyl-3.5-dimethoxy carbonyl pyridine. The interaction of NIF with NaOH in the absence of UV light was demonstrated to induce changes in the vibrational mode of the -C-C-O bond in the ester group. The photodegradation of NIF after its reaction with NaOH induces significant changes highlighted in its (a) UV-VIS spectra, by the shift of the absorption band at 238 nm; (b) PL spectra, by the supraunitary value of the ratio between the emission band intensities at 394-396 nm and 450 nm; (c) Raman spectra, by the change in the ratio between the intensities of the lines that peaked at 1224 cm-1 and 1649 cm-1 from 0.61 to 0.49; and (d) FTIR spectra, by the lowered absorbance of the IR band at 1493 cm-1 assigned to the vibrational mode of the -NO2 group as a result of the generation of the nitroso compound. These changes were explained considering the hydrolysis reaction products of NIF, as the nitroso compound is converted to a lactam-type compound. The photodegradation reaction rate constants of NIF and NIF after interaction with NaOH were also reported. The decrease in thermal stability of NIF samples after interaction with NaOH, as well as of NIF after exposure to UV light compared to NIF prior to exposure to UV light, was demonstrated by thermogravimetry, and the key fragments were confirmed by mass spectrometry.

Micellar liquid chromatography in doping control

The issue of doping control in sport involves the development of reliable analytical procedures and efficient strategies to process a large number of samples in a short period of time. Reversed-phase LC techniques with aqueous-organic mobile phases and MS or diode-array detection yield satisfactory results for the identification of prohibited substances in sport. However, time-consuming sample pretreatment steps are required, which reduces sample throughput. Micellar LC (MLC) that uses hybrid mobile phases of surfactant above its critical micellar concentration and organic solvent has been revealed as an interesting alternative. The surfactant sodium dodecyl sulfate solubilizes the protein components of urine, serum and plasma, which permits their direct injection into the chromatographic system. Only dilution and filtering of the samples may be required. Most MLC analyses are performed in isocratic mode, with short retention times and good selectivity. The sensitivity of MLC allows the detection of a variety of doping substances at least 24-48 h after being administered.

Stability of analytes in biosamples - an important issue in clinical and forensic toxicology?

Knowledge of the stability of drugs in biological samples is important for the interpretation of toxicological findings. This paper reviews data on the stability of drugs in blood, plasma, or serum. Since such data have already been reviewed for classic drugs of abuse, the focus here is on newer drugs of abuse and on therapeutic drugs. Key information about the conditions of the stability experiments will be provided and the following drugs or drug classes are covered: amphetamines, amphetamine-derived, piperazine-derived, and phenethylamine-derived designer drugs, antidepressants, neuroleptics, anti-HIV drugs, antiepileptics, cardiovascular drugs, and others. In addition, aspects of stability experiments and their evaluations are discussed. The data presented show that the majority of drugs are stable in blood, plasma, or serum samples under the conditions usually encountered in a clinical or forensic toxicology laboratory. Instability usually only occurs for drugs carrying ester moieties, sulfur atoms, or other easily oxidized or reduced structures. Nevertheless, clinical or forensic specimens should always be stored at least in the refrigerator and preferably at -20 degrees C or lower to avoid any degradation. Finally, results obtained from biosamples that have been stored at room temperature for a longer time should be interpreted with great care and partial degradation should always be considered.