Crystallization and Phase Transition of 1‐Butene Copolymers with Distinct Cyclic Co‐units

Crystallization and phase transition of butene/propylene copolymers

The introduction of propylene co-units into butene/propylene random copolymers can accelerate the II–I phase transition and even induce the direct formation of trigonal form I′ from an amorphous melt.

Investigation of the synergistic effect of melt-extension and nanofiller on the crystal-crystal phase transition from form II to I of isotactic polybutene-1

New questions and conjectures are raised on the crystal-crystal phase transition of isotactic polybutene-1 (iPB-1) containing nanofiller in the flow field. In this work, we investigate the phase transition from flow-induced oriented form II to I in iPB-1 blends with multi-walled carbon nanotubes (MWCNTs) with a homemade two-drum extensional rheometer combined with in situ wide-angle X-ray diffraction (WAXD) measurements. The MWCNTs show a limited promoting effect on the phase transition kinetics under quiescent conditions, while the phase transition kinetic is highly accelerated with the impose of melt-extension. When the loading extension strain is 0.5 or 2.0, the half time of phase transition (t_1/2) is shortened from tens of hours to a few hours, depending on the melt-extension strain and the MWCNTs content in iPB-1. When the extension strain increases to 3.5, t_1/2 decreases to about 30 min, which is independent of the MWCNTs content in all iPB-1 blends except in blends with MWCNTs content of 1%, where the phase transition rate in the middle and late stages is restrained. It's speculated that flow-induced molecular orientation or shish-kebab morphology affects the internal stress or stress transfer. The addition of a nanofiller enlarged the effect of melt-extension through strengthening the localized intensity of flow field. In general, the combination of nanofiller and melt-extension can obviously promote the phase transition kinetics.