Permeability of the Skin

Stretchable Seal

Many stretchable electronic devices require stretchable hermetic seals. However, stretchability and permeability are inextricably linked at the molecular level: stretchable, low-permeability materials do not exist. We collect data for the permeation of water and oxygen in many materials and describe the scaling relations for both flat and wrinkled seals. Whereas flat seals struggle to fulfill the simultaneous requirements of stretchability, low stiffness, and low transmissibility, wrinkled seals can fulfill them readily. We further explore the behavior of wrinkled seals under cyclic stretch using aluminum, polyethylene, and silica films on elastomer substrates. The wrinkled aluminum develops fatigue cracks after a small number of cycles, but the wrinkled polyethylene and silica maintain low transmissibility after 10 000 cycles of tensile strain.

Palm Olein Emulsion: a Novel Vehicle for Topical Drug Delivery of Betamethasone 17-Valerate

This study aims to investigate the use of palm olein as the oil phase for betamethasone 17-valerate (BV) emulsions. The physicochemical properties of the formulations were characterized. In vitro drug release study was performed with the Hanson Vertical Diffusion Cell System; the samples were quantified with HPLC and the results were compared with commercial products. Optimized emulsion formulations were subjected to stability studies for 3 months at temperatures of 4, 25, and 40°C; the betamethasone 17-valerate content was analyzed using HPLC. The formulations produced mean particle size of 2-4 μm, viscosities of 50-250 mPa.s, and zeta potential between -45 and -68 mV. The rheological analyses showed that the emulsions exhibited pseudoplastic and viscoelastic behavior. The in vitro release of BV from palm olein emulsion through cellulose acetate was 4.5 times higher than that of commercial products and more BV molecules deposited in rat skin. Less than 4% of the drug was degraded in the formulations during the 3-month period when they were subjected to the three different temperatures. These findings indicate that palm olein-in-water emulsion can be an alternative vehicle for topical drug delivery system with superior permeability.

Synthesis of a semi-interpenetrating polymer network as a bioactive curcumin film

This study focused on the synthesis and characterization of a natural polymeric system employing the interpenetrating polymer network (IPN) comprising curcumin as a bioactive. Biopolymers and actives such as chitosan, hypromellose, citric acid, genipin, and curcumin were used to develop an effective, biodegradable, and biocompatible film employed therapeutically as a wound healing platform. The semi-IPN films were investigated for their physicochemical, physicomechanical, and biological properties by quantification by FTIR, DSC, and Young's modulus. Following characterization, an optimum candidate formulation was produced whereby further in vitro and ex vivo studies were performed. Results revealed a burst release occurring at the first hour with 1.1 mg bioactive released when in contact with the dissolution medium and 2.23 mg due to bioactive permeation through the skin, thus suggesting that the lipophilic nature of skin greatly impacted the bioactive release rate. Furthermore, chemical and mechanical characterization and tensile strength analysis revealed that the degree of crosslinking and concentration of polymeric material used significantly influenced the properties of the film.

Annette Bunge: developing the principles in percutaneous absorption using chemical engineering principles

Annette Bunge and her research group have had the central theme of mathematically modeling the dermal absorption process. Most of the research focus has been on estimating dermal absorption for the purpose of risk assessment, for exposure scenarios in the environment and in the occupational setting. Her work is the basis for the United States Environmental Protection Agency's estimations for dermal absorption from contaminated water. It is also the basis of the dermal absorption estimates used in determining if chemicals should be assigned a 'skin notation' for potential systemic toxicity following occupational skin exposure. The work is truly translational in that it started with mathematical theory, is validated with preclinical and human experiments, and then is used in guidelines to protect human health. Her valued research has also extended into the topical drug bioavailability and bioequivalence assessment field.

Engineering approaches to transdermal drug delivery: a tribute to contributions of prof. Robert Langer

Transdermal drug delivery continues to provide an advantageous route of drug administration over injections. While the number of drugs delivered by passive transdermal patches has increased over the years, no macromolecule is currently delivered by the transdermal route. Substantial research efforts have been dedicated by a large number of researchers representing varied disciplines including biology, chemistry, pharmaceutics and engineering to understand, model and overcome the skin's barrier properties. This article focuses on engineering contributions to the field of transdermal drug delivery. The article pays tribute to Prof. Robert Langer, who pioneered the engineering approach towards transdermal drug delivery. Over a period spanning nearly 25 years since his first publication in the field of transdermal drug delivery, Bob Langer has deeply impacted the field by quantitative analysis and innovative engineering. At the same time, he has inspired several generations of engineers by collaborations and mentorship. His scientific insights, innovative technologies, translational efforts and dedicated mentorship have transformed the field.

A nonlinear electrical-thermal model of the skin

This work presents a model for the skin which accounts for both the nonlinearities and the asymmetries in its voltage-current characteristic. This model consists of an electrical submodel and a heat transfer submodel. The electrical submodel uses nonlinear devices in which some parameters depend on skin temperature. The heat transfer submodel models the heat exchange between the skin, the surrounding tissues, and the ambient medium and calculates the temperature of the skin to update the necessary parameters of the electrical submodel. The model is based on experiments designed to determine: 1) the dry skin voltage-current characteristic; 2) the changes in the skin breakdown voltage with location; 3) the moist skin voltage-current characteristic; 4) the changes in the voltage-current characteristic of the skin with duration after the onset of stimulation; and 5) the effect of skin temperature on its voltage-current characteristic. During these experiments we used 84-mm2 square Ag-AgCl electrodes to apply sinusoidal voltage of 0.2 and 20 Hz. The simulations were performed using the Advanced Continuous Simulation Language (ACSL), capable of solving differential and integral equations with variable coefficients. The model predicted the skin behavior satisfactorily for a large range of amplitudes and frequencies. We found that the breakdown occurred when the energy delivered to the skin exceeded a threshold. Above this threshold the voltage-current characteristic of the skin became nonlinear and asymmetric and, in a real situation, the subject would experience an uncomfortable sensation which could rapidly develop into pain.