Experimental and first-principle investigation of Cu-doped ZnO ferromagnetic powders

Group-Targeting SERS Screening of Total Benzodiazepines Based on Large-Size (111) Faceted Silver Nanosheets Decorated with Zinc Oxide Nanoparticles

Rapid, quantitative, and group-targeting detection of total benzodiazepines (BZDs) is critical to create an accurate judgement in emergent medical and forensic settings. Large-size (111) faceted Ag nanosheets decorated with small ZnO nanoparticles were designed as the prominent surface-enhanced Raman scattering substrate, which possessed advantages of specific metal facets and additional charge-transfer (CT) effect from the semiconductor. The vital and bridge role of ZnO in the CT effect was systematically studied via experimental investigations and molecular dynamics simulation, which proves the essentiality of an appropriate ZnO decoration density. Upon determining optimal Ag NS/ZnO hybrids, a calibration curve of estazolam was established with a 0.5 nM detection limit. Based on the obtained curve, group-targeting screening was achieved toward total concentrations of five BZDs (estazolam, oxazepam, alprazolam, triazolam, and lorazepam). Importantly, the total concentrations of BZDs in mice serum were accurately monitored with changing analytical time during the metabolic process, which was in agreement with the tendency measured by liquid chromatography with tandem mass spectrometry.

Efficient Solar-Induced Photoelectrochemical Response Using Coupling Semiconductor TiO₂-ZnO Nanorod Film

Efficient solar driven photoelectrochemical (PEC) response by enhancing charge separation has attracted great interest in the hydrogen generation application. The formation of one-dimensional ZnO nanorod structure without bundling is essential for high efficiency in PEC response. In this present research work, ZnO nanorod with an average 500 nm in length and average diameter of about 75 nm was successfully formed via electrodeposition method in 0.05 mM ZnCl₂ and 0.1 M KCl electrolyte at 1 V for 60 min under 70 °C condition. Continuous efforts have been exerted to further improve the solar driven PEC response by incorporating an optimum content of TiO₂ into ZnO nanorod using dip-coating technique. It was found that 0.25 at % of TiO₂ loaded on ZnO nanorod film demonstrated a maximum photocurrent density of 19.78 mA/cm² (with V vs. Ag/AgCl) under UV illumination and 14.75 mA/cm² (with V vs. Ag/AgCl) under solar illumination with photoconversion efficiency ~2.9% (UV illumination) and ~4.3% (solar illumination). This performance was approximately 3–4 times higher than ZnO film itself. An enhancement of photocurrent density and photoconversion efficiency occurred due to the sufficient Ti element within TiO₂-ZnO nanorod film, which acted as an effective mediator to trap the photo-induced electrons and minimize the recombination of charge carriers. Besides, phenomenon of charge-separation effect at type-II band alignment of Zn and Ti could further enhance the charge carrier transportation during illumination.

Electrical Properties of CZO Films Prepared by Ultrasonic Spray Pyrolysis

CuZnO (CZO) films have attracted increasing amounts of attention due to their promising potential applications in semiconductor devices. ZnO shows n-type conductivity, and attempts have been made to dope several elements in ZnO to improve the electrical properties. This study investigated the electrical property transitions of CZO films and determined the copper concentration at which the conductivity of CZO films will change from n-type to p-type. In this study, CZO films were fabricated by ultrasonic spray pyrolysis with copper acetate, zinc acetate, and ammonium acetate precursor solution. The concentrations of Cu ions in the CZO films were controlled by the concentration ratios of copper acetate to zinc acetate in the precursor solutions. In addition, these samples were analyzed by Hall effect measurements, X-ray diffraction, transmittance measurements, and photoluminescence measurements. The results show that the conductivity of the CZO film changes from n-type to p-type when the copper ion concentration in the film is 5%.

Dual-donor (Zn(i) and V(O)) mediated ferromagnetism in copper-doped ZnO micron-scale polycrystalline films: a thermally driven defect modulation process

The paper reports robust ferromagnetic Cu-doped ZnO micron-scale polycrystalline films via spin-coating using high-quality doped nanocrystals. A reliable magnetic response is observed in the 900 °C vacuum annealed film without any ferromagnetic contribution from other sources. Post-annealing treatment in terms of atmosphere and temperature can control the proportion of oxygen vacancies (V(O)) and zinc interstitials (Zn(i)) defects and further help to precisely regulate defect-related ferromagnetic behavior. Complex charge transfer processes derived from dual-donor (Zn(i) and V(O)) to Cu acceptor are revealed by photoluminescence (PL) and electron paramagnetic resonance (EPR) spectra. Based on the above, specific charge transfer (CT)-type Stoner splitting and indirect double-exchange mechanisms are proposed to understand the ferromagnetic origin. The improvable FM performance and annealing-specific modulation further indicate that a thermal driven process can delicately tailor the magnetic property of the transition metal ion-doped ZnO system.