Malononitrile-Assisted Highly Chemoselective Bismuth Triflate Catalyzed Conjugate Reduction of α,β-Unsaturated Ketones

Highly efficient iron-catalyzed conjugate reduction of α,β-unsaturated ketones with polymethylhydrosiloxane

An iron-catalyzed ligand free conjugate reduction of α,β-unsaturated ketones with PMHS (polymethylhydrosiloxane) was reported to deliver the corresponding carbonyl compounds with up to 93% yield. This operationally simple protocol shows a broad substrate scope using readily available PMHS as a cost-effective and easy-to-handle reductive reagent.

Catalyst-Free Transfer Hydrogenation of Activated Alkenes Exploiting Isopropanol as the Sole and Traceless Reductant

Both metal-catalyzed and organocatalytic transfer hydrogenation reactions are widely employed for the reduction of C=O and C=N bonds. However, selective transfer hydrogenation reactions of C=C bonds remain challenging. Therefore, the chemoselective transfer hydrogenation of olefins under mild conditions and in the absence of metal catalysts, using readily available and inexpensive reducing agents (i.e. primary and secondary alcohols), will mark a significant advancement towards the development of green transfer hydrogenation strategies. Described herein is an unconventional catalyst-free transfer hydrogenation reaction of activated alkenes using isopropanol as an eco-friendly reductant and solvent. The reaction gives convenient synthetic access to a wide range of substituted malonic acid half oxyesters (SMAHOs) in moderate to good yields. Mechanistic investigations point towards an unprecedented hydrogen bond-assisted transfer hydrogenation process.

Borane-Catalyzed, Chemoselective Reduction and Hydrofunctionalization of Enones Enabled by B-O Transborylation

The use of stoichiometric organoborane reductants in organic synthesis is well established. Here these reagents have been rendered catalytic through an isodesmic B-O/B-H transborylation applied in the borane-catalyzed, chemoselective alkene reduction and formal hydrofunctionalization of enones. The reaction was found to proceed by a 1,4-hydroboration of the enone and B-O/B-H transborylation with HBpin, enabling catalyst turnover. Single-turnover and isotopic labeling experiments supported the proposed mechanism of catalysis with 1,4-hydroboration and B-O/B-H transborylation as key steps.

Chemoselective and metal-free reduction of α,β-unsaturated ketones by in situ produced benzeneselenol from O-(tert-butyl) Se-phenyl selenocarbonate

The carbon–carbon double bond of arylidene acetones and chalcones can be selectively reduced with benzeneselenol generated in situ by reacting O-(tert-butyl) Se-phenyl selenocarbonate with hydrochloric acid in ethanol. This mild, metal-free and experimentally simple reduction procedure displays considerable functional-group compatibility, products are obtained in good to excellent yields, and the use of toxic Se/CO mixture and NaSeH, or the smelly and air-sensitive benzeneselenol, is avoided.

The carbon–carbon double bond of arylidene acetones and chalcones can be selectively reduced with benzeneselenol generated in situ by reacting O-(tert-butyl) Se-phenyl selenocarbonate with hydrochloric acid in ethanol.

Ligandless nickel-catalyzed transfer hydrogenation of alkenes and alkynes using water as the hydrogen donor

The first general route for nickel-catalyzed transfer hydrogenation reaction of alkenes and alkynes using water as the hydrogen source has been developed.

Electrochemical 1,4-reduction of α,β-unsaturated ketones with methanol and ammonium chloride as hydrogen sources

This protocol presented a sustainable, chemoselective 1,4-reduction of α,β-unsaturated ketones by means of an electrochemical method with ammonium chloride (NH₄Cl) as the only additive.

Transfer Hydrogenation of Alkenes Using Ethanol Catalyzed by a NCP Pincer Iridium Complex: Scope and Mechanism

The first general catalytic approach to effecting transfer hydrogenation (TH) of unactivated alkenes using ethanol as the hydrogen source is described. A new NCP-type pincer iridium complex (^BQ-NC^OP)IrHCl containing a rigid benzoquinoline backbone has been developed for efficient, mild TH of unactivated C-C multiple bonds with ethanol, forming ethyl acetate as the sole byproduct. A wide variety of alkenes, including multisubstituted alkyl alkenes, aryl alkenes, and heteroatom-substituted alkenes, as well as O- or N-containing heteroarenes and internal alkynes, are suitable substrates. Importantly, the (^BQ-NC^OP)Ir/EtOH system exhibits high chemoselectivity for alkene hydrogenation in the presence of reactive functional groups, such as ketones and carboxylic acids. Furthermore, the reaction with C₂D₅OD provides a convenient route to deuterium-labeled compounds. Detailed kinetic and mechanistic studies have revealed that monosubstituted alkenes (e.g., 1-octene, styrene) and multisubstituted alkenes (e.g., cyclooctene (COE)) exhibit fundamental mechanistic difference. The OH group of ethanol displays a normal kinetic isotope effect (KIE) in the reaction of styrene, but a substantial inverse KIE in the case of COE. The catalysis of styrene or 1-octene with relatively strong binding affinity to the Ir(I) center has (^BQ-NC^OP)Ir^I(alkene) adduct as an off-cycle catalyst resting state, and the rate law shows a positive order in EtOH, inverse first-order in styrene, and first-order in the catalyst. In contrast, the catalysis of COE has an off-cycle catalyst resting state of (^BQ-NC^OP)Ir^III(H)[O(Et)···HO(Et)···HOEt] that features a six-membered iridacycle consisting of two hydrogen-bonds between one EtO ligand and two EtOH molecules, one of which is coordinated to the Ir(III) center. The rate law shows a negative order in EtOH, zeroth-order in COE, and first-order in the catalyst. The observed inverse KIE corresponds to an inverse equilibrium isotope effect for the pre-equilibrium formation of (^BQ-NC^OP)Ir^III(H)(OEt) from the catalyst resting state via ethanol dissociation. Regardless of the substrate, ethanol dehydrogenation is the slow segment of the catalytic cycle, while alkene hydrogenation occurs readily following the rate-determining step, that is, β-hydride elimination of (^BQ-NC^OP)Ir(H)(OEt) to form (^BQ-NC^OP)Ir(H)₂ and acetaldehyde. The latter is effectively converted to innocent ethyl acetate under the catalytic conditions, thus avoiding the catalyst poisoning via iridium-mediated decarbonylation of acetaldehyde.

Graphene-enhanced platinum-catalysed hydrosilylation of amides and chalcones: a sustainable strategy allocated with in situ heterogenization and multitask application of H2PtCl6

This work developed a new sustainable strategy with comprehensive utilization of recovered catalyst, which the organosilicon/graphene-supported platinum catalyst prepared from reduction of amides could be further used in the 1,4-hydrosilylation of chalcones.

Biotechnological methods for chalcone reduction using whole cells of Lactobacillus, Rhodococcus and Rhodotorula strains as a way to produce new derivatives

Microbial strains of the genera Dietzia, Micrococcus, Pseudomonas, Rhodococcus, Gordonia, Streptomyces, Pseudomonas, Bacillus, Penicillium, Rhodotorula and Lactobacillus were screened for the ability to convert chalcones. Synthesis of chalcones was performed by the Claisen-Schmidt reaction. There were three groups of chalcones obtained as the products, which included the derivatives containing 4-substituted chalcone, 2'-hydroxychalcone and 4'-methoxychalcone. The B ring of the chalcones was substituted in the para position with different groups, such as halide, hydroxyl, nitro, methyl, ethyl and ethoxy one. The structure-activity relationship of the tested chalcones in biotransformation processes was studied. It has been proven that Gram-positive bacterial strains Rhodococcus and Lactobacillus catalyzed reduction of C=C bond in the chalcones to give respective dihydrochalcones. The strain Rhodotorula rubra AM 82 transformed chalcones into dihydrochalcones and respective secondary alcohols. These results suggest that the probiotic strain of Lactobacillus can be used for biotransformations of chalcones, which has not been described before. The structure of new metabolites 14a and 15b were established as 4-ethoxy-4'-methoxydihydrochalcone and 3-(4-bromophenyl)-1-(4'-O-methylphenyl)-2-propan-1-ol, respectively, which was confirmed by (1)H NMR and (13)C NMR analysis.

Highly Selective Continuous-Flow Synthesis of Potentially Bioactive Deuterated Chalcone Derivatives

The selective synthesis of various dideuterochalcones as potentially bioactive deuterium-labeled products is presented, by means of the highly controlled partial deuteration of antidiabetic chalcone derivatives. The benefits of continuous-flow processing in combination with on-demand electrolytic D₂ gas generation has been exploited to avoid over-reaction to undesired side products and to achieve selective deuterium addition to the carbon-carbon double bond of the starting enones without the need for unconventional catalysts or expensive special reagents. The roles of pressure, temperature, and residence time proved crucial for the fine-tuning of the sensitive balance between the product selectivity and the reaction rate. The presented flow-chemistry-based deuteration technique lacks most of the drawbacks of the classical batch methods, and is convenient, time- and cost-efficient, and safe.

A base-controlled chemoselective transfer hydrogenation of α,β-unsaturated ketones catalyzed by [IrCp*Cl2]2 with 2-propanol

A simple homogeneous catalyst system based on commercially available [IrCp*Cl₂]₂ has been developed for the transfer hydrogenation of α,β-unsaturated ketones.