Derivatization of inorganic ions in capillary electrophoresis

Derivatization in Capillary Electrophoresis

Capillary electrophoresis is a well-established separation technique in analytical research laboratories worldwide. Its interesting advantages make CE an efficient and potent alternative to other chromatographic techniques. However, it is also recognized that its main drawback is the relatively poor sensitivity when using optical detection. One way to overcome this limitation is to perform a derivatization reaction which is intended to provide the analyte more suitable analytical characteristics enabling a high sensitive detection. Based on the analytical step where the CE derivatization takes place, it can be classified as precapillary (before separation), in-capillary (during separation), or postcapillary (after separation). This chapter describes the application of four different derivatization protocols (in-capillary and precapillary modes) to carry out the achiral and chiral analysis of different compounds in food and biological samples with three different detection modes (UV, LIF, and MS).

Simultaneous determination of Zr(IV) and Hf(IV) by CE using precolumn complexation with a [PW11O39]7− ligand

A CE method was developed for the simultaneous determination of Zr(IV) and Hf(IV) at trace levels. A lacunary Keggin-type [PW(11)O(39)](7-) ligand reacted quantitatively with a mixture of trace amounts of Zr(IV) and Hf(IV) to form the so-called ternary Keggin-type anions [P(Zr(IV)W(11))O(40)](5-) and [P(Hf(IV)W(11))O(40)](5-) in 0.010 M monochloroacetate buffer (pH 2.2). Since both ternary anions possessed different electrophoretic mobilities and high molar absorptivities in the UV region, Zr(IV) and Hf(IV) were determined simultaneously with direct UV detection at 258 nm. Each peak height was linearly dependent on the concentration of Zr(IV) or Hf(IV) in the range of 5.0x10(-7)-1.0x10(-5) M; a detection limit of 2x10(-7) M was achieved. The utility of the proposed CE method was demonstrated for the simultaneous determination of Zr(IV) and Hf(IV) in natural water samples with satisfactory results.

CE-ESI-MS of biological anions in plastic capillaries at high pH

In this study, the potential of poly(methylmethacrylate) (PMMA, Plexiglas) and polyether ether ketone (PEEK) tubing for CE-ESI-MS separations of anions at high pH values was examined. A set of model compounds of biological interest was used to investigate the main operational parameters for CE-ESI-MS, such as the sheath-flow interface design, the polarity of the ionization voltage, the use of ammonia-based separation electrolytes, and the sheath liquid composition. Optimum separations and detection sensitivities in negative ESI mode were obtained using a running electrolyte of 75 mM of ammonia at pH 11 and a sheath liquid of 60:40 v/v or 75:25 v/v isopropanol/water with 0.5% v/v of ammonia. At these experimental conditions, PMMA and PEEK capillaries show good hydrolytic stabilities and lower EOF values than fused-silica columns. Better separation resolutions were obtained with PMMA capillary, but this plastic rapidly swelled and bled because of its limited chemical resistance to the sheath liquid. PMMA columns equipped with a fused-silica tip were used for a safer exposure to the sheath liquid, but the inner surface of the fused-silica tips had limited stability at pH 11. On the other hand, good separations and reproducibility on migration times and peak areas were obtained using PEEK capillaries without capillary column deterioration.

Selective Determination of Cadmium(II) from Divalent Metal Ions in Environmental Samples by Capillary Electrophoresis Using In-capillary Complexation with a Lacunary Keggin-type [PW11O39]7- Complex

A novel capillary electrophoretic (CE) method, based on in-capillary complexation with [PW(11)O(39)](7-), was developed for the determination of cadmium(II) in natural water samples. When a sample solution is injected into a capillary containing 0.20 mM [PW(11)O(39)](7-) and 0.10 M malonate buffer (pH 3.0), the ternary Keggin-type complex, [P(Cd(II)W(11))O(39)](5-), which possesses high molar absorbtivities in the UV region, is formed in the capillary, and its migration toward the anode gives a well-defined migration peak in the electropherogram. An advantage of this method is that many divalent metal ions do not interfere. The proposed method was successfully applied to the determination of Cd(II) in environmental samples. The detection limits were 1 x 10(-7) and 5 x 10(-7) M for river-water and seawater samples, respectively (signal-to-noise ratio = 3).

Confirmation of vanadium complex formation using electrospray mass spectrometry and determination of vanadium speciation by sample stacking capillary electrophoresis

Capillary zone electrophoresis (CZE) with UV detection was used to determine vanadium species. Nitrilotriacetic acid (NTA), hydroxyethylethylenediaminetriacetic acid (HEDTA), ethylenediaminetetraacetic acid (EDTA), diethylenetriaminepentaacetic acid (DTPA), ethylene glycol-bis(2-aminoethylether)-tetraacetic acid (EGTA) and 2,6-pyridinedicarboxylic acid (PDCA) were investigated to determine whether these ligands formed stable anionic complexes with vanadium. Of all the ligands studied HEDTA was the most suitable ligand because it gave the largest UV response with reasonable migration time. Electrospray mass spectrometry (ES-MS) was used to confirm the formation of [VO(2)(HEDTA)](2-) and [VO(HEDTA)](1-) in solution. An electrolyte containing 25 mM phosphate, 0.25 mM tetradecyltrimethylammonium bromide (TTAB) at pH 5.5 was optimum for the separation of these anionic vanadium complexes. Sample stacking techniques, including large-volume sample stacking (LVSS) and field-amplified sample injection (FASI), were tested to improve the sensitivity. Best sensitivity was obtained using FASI, with detection limits of 0.001 microM, equivalent to 0.4 microg L(-1), for [VO(2)(HEDTA)](2-) and 0.01 microM, equivalent to 3.4 microg L(-1) for [VO(HEDTA)](1-). The utility of the method for the speciation of V(IV) and V(V) was demonstrated using ground water samples.

Kinetic Monitoring of Electrophoretically Induced Solute Reaction by Axial Absorption Detection with Liquid-Core Waveguide

Teflon AF-2400 capillary has been used for capillary electrophoretic separation as well as for liquid-core waveguide for axial absorption detection. This separation/detection scheme has allowed continuous monitoring of electrophoretically induced reactions. In this paper, the decomposition of Cd2+ complex with 4-(2-pyridylazo)resorcinol has been tested, and its decomposition kinetics has been studied. A simple modeling has predicted the single-exponential decay of the absorbance detected by the present axial absorption detector and has allowed the estimation of the decomposition rate constant for this reaction.

Speciation of chromium by in-capillary derivatization and electrophoretically mediated microanalysis

An electrophoretic method for chromium speciation analysis--as Cr(III) and Cr(VI)--based on in-capillary derivatization with 1,5-diphenylcarbazide (DPC) is here proposed. As Cr(III) does not react with DPC, it was oxidized also in-capillary to Cr(VI) by Ce(IV). For this purpose, a capillary electrophoresis (CE) mode called electrophoretically mediated microanalysis (EMMA) based on sequential injection of sample and reagents--namely, DPC, sample and Ce(IV)--was employed. The conditions of both reactions--Cr(III) oxidation and Cr(VI)-DPC derivatization--were optimized in order to quantify separately the Cr(VI)-DPC complex from the original Cr(VI) in the sample and that from oxidation of Cr(III) to Cr(VI). The electrophoretic conditions were independently optimized for variables influencing the resolution and those affecting sensitivity. The method thus developed was applied to the determination of Cr(III) and Cr(VI) in glass material, for which different sample preparation methods--namely, EPA method 3060A, ultrasound-assisted leaching and microwave-assisted digestion--were tested. Microwave-assisted digestion was found to be the best sample preparation alternative in terms of efficiency of the step--99.6 and 98.3% for Cr(VI) and Cr(III), respectively--and procedure time--20 min. The complete method was validated with the certified reference material BAM-S004.

Recent advances in capillary electrophoresis and capillary electrochromatography of pollutants

Recent advances in the CE and CEC separation, detection, and sample preparation methodologies applied to the determination of a variety of compounds having current or potential environmental relevance have been overviewed. The reviewed literature has illustrated the wide range of CE applications, indicating the continuing interest in CE and CEC in the environmental field.

CE determination of small ions: methods and techniques

This paper provides an overview on the current status of capillary electrophoresis (CE) in the analysis of inorganic and charged small organic species. The various CE strategies used to improve the separation of ionic analytes are summarized. Technical developments in the design of improved detection systems are described. A brief account of their advantages and limitations is given. The potential use of these devices for miniaturized CE systems is also described. Finally, special attention is focused on the on-capillary preconcentration techniques developed in attempts to overcome the poor detectability of CE. Recent review articles are frequently cited to provide readers with a source of information about pioneering work, theoretical treatments, and specific applications.

Metal Complex Separation with On-line Sample Preconcentration in Micellar Electrokinetic Chromatography

Micellar electrokinetic chromatography (MEKC) using a cationic surfactant as a pseudostationary phase was examined to separate anionic metal cyclohexane-1,2-diaminetetraacetic acid (CDTA) complexes. Cetyltrimethylammonium chloride (CTAC) was employed as the cationic surfactant micelle, its addition leading to EOF reversal. Cu(II), Co(II), Zn(II), Mn(II) and Pb(II) were used as test analytes, and the complete separation was obtained by MEKC. On-line sample preconcentration by sweeping was also examined to improve the detection sensitivity. From 15- to 42-fold increases in the detection sensitivity in terms of the peak heights were obtained by sweeping with a cationic micelle in the presence of high EOF. The limits of detection were in the range (0.6 - 1.8) x 10(-6) M with UV detection without any off-line preconcentration step.

Dual injection capillary electrophoresis: Foundations and applications

The state of the art of capillary electrophoresis (CE) approaches based on dual injection is here reported. Dual injection strategies have been proposed with three main objectives: (i) to provide information about reaction kinetics and/or related parameters, (ii) to perform in-capillary derivatization for improving separation and/or determination, (iii) to develop electrophoretic methods for the simultaneous analysis of anionic and cationic compounds. For the first two purposes, dual injection, which involves sample and reagent, can be realized either from the same end of the capillary (electrophoretically mediated microanalysis, EMMA) or from the two ends of the capillary (electroinjection analysis, EIA). The third objective, with dual injection of sample from the two ends of the capillary, takes advantage of moving cationic and anionic compounds with opposite directions. The foundations of each alternative, conditions necessary for working with them, restrictions, applications as well as perspectives are reviewed in order to establish the advantages, shortcomings, and convenience or no of their use in comparison to conventional CE.

Capillary electrophoresis of inorganic ions: An update

This review as a sequel of three earlier similar reports gives a summary of the progress and significant methodological developments, starting from 2002, in the use of capillary electrophoresis (CE) for inorganic ion analysis. As substantiated by the illustrative number of relevant references, improvements in sensitivity achieved both in and outside a CE system, advances in manipulating the separation selectivity, novel hardware configurations, and system performance innovations are continually being reported over the review period. Specifically viewed are the recent advancements in elemental (bio)speciation analysis, which remains one of the most fertile areas of CE research, as well as in three recently booming research topics: contactless conductivity detection, separations on microchips, and transient isotachophoretic preconcentration. A state-of-the-art picture of technique's potentialities within the field of interest presented here demonstrates that CE has become recognized and is growing in acceptance as a reliable alternative to traditional analytical methods such as high-performance liquid chromatography (HPLC).