Dispersive liquid-liquid microextraction of five chlorophenols in water samples followed by determination using capillary electrophoresis

Zeolitic imidazolate framework-8/ fluorinated graphene coated SiO2 composites for pipette tip solid-phase extraction of chlorophenols in environmental and food samples

In this work, a novel composite adsorbent was successfully prepared by zeolite imidazolate framework-8/fluorinated graphene layer-by-layer covalently bonded on SiO₂ microspheres, and followed to be packed into micro pipette tip for extraction of trace chlorophenols prior to their detection by high performance liquid chromatography (HPLC). The morphology and structure of adsorbent material was characterized by field emission scanning electron microscopy with energy dispersive spectrometer, X-ray diffraction, and N₂ adsorption. The parameters including the amount of adsorbent, sampling volume, sampling rate, sample pH, and desorption solvent affected the extraction performance was systematically investigated by pipette tip solid-phase extraction (PT-SPE) coupled with HPLC analysis. Under the optimized condition, the linearity of this method ranged from 20 to 2000 ng mL^-1 for chlorophenols (CPs) with determination coefficient higher than 0.99. The limit of detection (at a signal-to-noise ratio of 3) were in the range 2-20 ng mL^-1 for tap water and black tea drinks, 0.2-2 μg g^-1 for honey. The relative recoveries of the CPs from spiked samples ranged from 71.8% to 104.7%, with relative standard deviations less than 6.2%. The filled extraction tube exhibited good stability and reproducibility. The proposed method has been successfully used to detect CPs in water and drinks with satisfactory recoveries.

Determination of phenols in natural and waste waters by capillary electrophoresis after preconcentration on magnetic nanoparticles coated with aminated hypercrosslinked polystyrene

An efficient sorbent for magnetic solid-phase extraction was developed from Fe₃ O₄ nanoparticles covered with aminated hypercrosslinked polystyrene. The sorbent has a saturation magnetization of 47 emu/g and a surface area of 509 mg/g and was tested for the extraction of 11 phenols from aqueous media. The optimum conditions were as follows: pH 3; adsorbent mass, 20.0 mg; adsorption time, 30 min; eluent (acetone) volume, 0.5 mL; and desorption time, 5 min. The enrichment factor after desorption reached 1595-1716 and the maximum adsorption capacity was 501-909 mg/g. Capillary electrophoresis was applied successively to separate 11 phenols after solid-phase extraction. The best separation was achieved using a fused silica capillary and borate buffer (pH 10.7) as a supporting electrolyte. After optimization, the linearity range was from 0.2 to 950 μg/L, and the limits of detection were 0.05-0.2 μg/L. The relative standard deviation varied from 6.1 to 8.7% (C = 1 μg/L) and from 2.9 to 3.5% (C = 500 μg/L). The determination of phenols is complicated in eutrophic water and spring water with a high content of humic and fulvic acids.

A twin enrichment method based on dispersive liquid-liquid microextraction and field-amplified sample injection for the simultaneous determination of sulfonamides

A twin enrichment method based on offline dispersive liquid-liquid microextraction (DLLME) coupled with online field-amplified sample injection (FASI) was developed for the simultaneous determination of four sulfonamide (SA) antibiotics, including sulfamethazine (SMZ), sulfamerazine (SMR), sulfadizine (SDZ) and sulfacetamide (SFA), in different environmental waters, followed by capillary electrophoresis (CE). Various parameters that affected the separation performance of CE and the enrichment efficiencies of DLLME and FASI were optimized in detail, and excellent CE separation was attained within 6 min. The DLLME-FASI-CE offered high sensitivity enrichment factors of 206, 166, 185 and 150 for SMZ, SMR, SDZ and SFA, respectively. Highly sensitive detection was realized with low limits of detection (LODs), which ranged from 2.0-23.0, 2.2-26.0 and 4.3-63.0 ng mL-1 in tap water, lake water and seawater, respectively, as well as limits of quantification (LOQs) within 6.0-63.0, 7.4-96.0 and 14.0-201.0 ng mL-1, respectively. Satisfactory recoveries in the range of 91-108% were obtained with the three spiked environmental water samples, and the relative standard deviations were from 1.09-7.45%. The simple effective twin enrichment method provided promising perspective for CE determination of SAs in complicated aqueous matrices, with rapidity, sensitivity, and accuracy.

Field-amplified sample injection combined with capillary electrophoresis for the simultaneous determination of five chlorophenols in water samples

A sensitive method of CZE-ultraviolet (UV) detection based on the on-line preconcentration strategy of field-amplified sample injection (FASI) was developed for the simultaneous determination of five kinds of chlorophenols (CPs) namely 4-chlorophenol (4-CP), 2-chlorophenol (2-CP), 2,4-dichlorophenol (2,4-DCP), 2,4,6-trichlorophenol (2,4,6-TCP), and 2,6-dichlorophenol (2,6-DCP) in water samples. Several parameters affecting CZE and FASI conditions were systematically investigated. Under the optimal conditions, sensitivity enhancement factors for 4-CP, 2-CP, 2,4-DCP, 2,4,6-TCP, and 2,6-DCP were 9, 27, 35, 43, and 43 folds, respectively, compared with the direct CZE, and the baseline separation was achieved within 5 min. Then, the developed FASI-CZE-UV method was applied to tap and lake water samples for the five CPs determination. The LODs (S/N = 3) were 0.0018-0.019 µg/mL and 0.0089-0.029 µg/mL in tap water and lake water, respectively. The values of LOQs in tap water (0.006-0.0074 µg/mL) were much lower than the maximum permissible concentrations of 2,4,6-TCP, 2,4-DCP, and 2-CP in drinking water stipulated by World Health Organization (WHO) namely 0.3, 0.04, and 0.01 µg/mL, respectively, and thereby the method was suitable to detect the CPs according to WHO guidelines. Furthermore, the method attained high recoveries in the range of 83.0-119.0% at three spiking levels of five CPs in the two types of water samples, with relative standard deviations of 0.37-8.58%. The developed method was proved to be a simple, sensitive, highly automated, and efficient alternative to CPs determination in real water samples.

Dispersive liquid-liquid microextraction coupled with pressure-assisted electrokinetic injection for simultaneous enrichment of seven phenolic compounds in water samples followed by determination using capillary electrophoresis

Offline dispersive liquid-liquid microextraction combined with online pressure-assisted electrokinetic injection was developed to simultaneously enrich seven phenolic compounds in water samples, followed by determination using capillary electrophoresis, namely phenol, 4-chlorophenol, pentachlorophenol, 2,4,6-trichlorophenol, 2,4-dichlorophenol, 2-chlorophenol, and 2,6-dichlorophenol. Several parameters affecting separation performance of capillary electrophoresis and the enrichment efficiency of pressure-assisted electrokinetic injection and dispersive liquid-liquid microextraction were systematically investigated. Under the optimal conditions, seven phenolic compounds were completely separated within 14 min and good enrichment factors were obtained of 61, 236, 3705, 3288, 920, 86, and 1807 for phenol, 4-chlorophenol, pentachlorophenol, 2,4,6-trichlorophenol, 2,4-dichlorophenol, 2-chlorophenol, and 2,6-dichlorophenol, respectively. Good linearity was attained in the range of 0.1-200 μg/L for 2,4-dichlorophenol, 0.5-200 μg/L for 4-chlorophenol, pentachlorophenol, 2,4,6-trichlorophenol, 2-chlorophenol, and 2,6-dichlorophenol, as well as 1-200 μg/L for phenol, with correlation coefficients (r) over 0.9905. The limits of detection and quantification ranging from 0.03-0.28 and 0.07-0.94 μg/L were attained. This two step enrichment method was potentially applicable for the rapid and simultaneous determination of phenolic compounds in water samples.