The role of different phenomena in surface-activated chemical ionization (SACI) performance

Optimizing Secondary Electrospray Ionization High-Resolution Mass Spectrometry (SESI-HRMS) for the Analysis of Volatile Fatty Acids from Gut Microbiome

Gut microbiota plays essential roles in maintaining gut homeostasis. The composition of gut microbes and their metabolites are altered in response to diet and remedial agents such as antibiotics. However, little is known about the effect of antibiotics on the gut microbiota and their volatile metabolites. In this study, we evaluated the impact of a moderate level of ampicillin treatment on volatile fatty acids (VFAs) of gut microbial cultures using an optimized real-time secondary electrospray ionization coupled with high-resolution mass spectrometry (SESI-HRMS). To evaluate the ionization efficiency, different types of electrospray solvents and concentrations of formic acid as an additive (0.01, 0.05, and 0.1%, v/v) were tested using VFAs standard mixture (C2-C7). As a result, the maximum SESI-HRMS signals of all studied m/z values were observed from water with 0.01% formic acid than those from the aqueous methanolic solutions. Optimal temperatures of sample inlet and ion chamber were set at 130 °C and 85 °C, respectively. SESI spray pressure at 0.5 bar generated the maximum intensity than other tested values. The optimized SESI-HRMS was then used for the analysis of VFAs in gut microbial cultures. We detected that the significantly elevated C4 and C7 VFAs in the headspace of gut microbial cultures six hours after ampicillin treatment (1 mg/L). In conclusion, our results suggested that the optimized SESI-HRMS method can be suitable for the analysis of VFAs from gut microbes in a rapid, sensitive, and non-invasive manner.

A surface-activated chemical ionization approach allows quantitative phosphorylation analysis of the cyclin-dependent kinase inhibitor Sic1 phosphorylated on Ser201

RATIONALE

Quantitative phosphoproteomics represents a front line for functional proteomics and hence for systems biology. Here we present a new application of the surface-activated chemical ionization (SACI) technology for quantitative phosphoproteomics analysis. The main advantages of SACI-MS technology are high sensitivity, quantitative accuracy and matrix effect reduction, which allow quantitative estimations.

METHODS

A SACI-MS approach was used to investigate the quantitative in vivo phosphorylation of the cyclin-dependent kinase inhibitor Sic1, a low-abundance protein of Saccharomyces cerevisiae, which is phosphorylated on Ser201 by casein kinase 2 (CK2) and compared its phosphorylation status in cells growing in two different carbon sources (glucose or ethanol).

RESULTS

Our relative quantification indicated that the Sic1-Ser201 phosphorylation level is about 2-fold higher in ethanol- than in glucose-growing cells, proportional to the Sic1 protein level. This finding is coherent with results of western blot analysis using anti-phospho-Ser201-specific antibody, validating the results obtained with this new SACI approach.

CONCLUSIONS

The findings presented in this paper indicate that the innovative LC/SACI-MS method, coupled with immunoprecipitation, is a powerful device to obtain quantitative information on the phosphorylation state of low abundance proteins.

Investigation on the role of pneumatic aspects in electrospray, desorption electrospray surface ionization and surface activated chemical ionization

This review reports the results of some studies carried out by us on the role of pneumatic aspects in electrospray and desorption electrospray surface ionization, with the aim to propose some relevant aspects of the mechanisms involved in these ionization methods. Electrospray ion sources, with the exception of the nano- electrospray source, operate with the concurrent action of a strong electrical field and a supplementary coaxial gas flow. The electrical field is responsible for electrospraying of the analyte solution but the use of a coaxial gas flow leads to a significant increase of the analyte signal and allows the use of higher solution flows. However, by employing capillary voltages much lower than those necessary to activate the electrospray phenomenon, analyte ions are still observed and this indicates that different mechanisms must be operative for ion production. Under these conditions, ion generation could take place from the neutral pneumatically sprayed droplet by field-induced droplet ionization. Also in the case of desorption electrospray ionization (DESI), and without any voltage on the spraying capillary as well as on the surface of interest, ions of analytes present on the surface become detectable and this shows that desorption/ionization of analytes occurs by neutral droplets impinging the surface. Consequently, the pneumatic effect of the impinging droplets plays a relevant role, and for these reasons the method has been called pneumatic assisted desorption (PAD). Some analogies existing between PAD and surface activated chemical ionization (SACI), based on the insertion of a metallic surface inside an atmospheric pressure chemical ionization source operating without corona discharge, are discussed.

Surface-activated chemical ionization combined with electrospray ionization and mass spectrometry for the analysis of cannabinoids in biological samples. Part I: analysis of 11-nor-9-carboxytetrahydro-cannabinol

Recently, electrospray ionization mass spectroscopy (ESI-MS) has been widely used for the identification of drugs of abuse and their metabolites in biological samples. However, the sensitivity and selectivity of this technique are commonly inadequate for the analysis of tetrahydrocannabinol (THC) and its metabolites at very low levels, such as those sometimes required in forensic and clinical-legal applications. We coupled electrospray ionization and surface-activated chemical ionization (ESI-SACI) to various types of mass analyzers (ion trap, triple quadrupole and orbitrap) (ESI-SACI-MS) to improve the detection of 11-nor-9-carboxy-tetrahydrocannabinol (THC-COOH), the most common marker of THC abuse. The benefits of this approach in terms of sensitivity and selectivity compared with a common ESI-MS approach are clearly demonstrated.

Optimization of information content in a mass spectrometry based flow-chemistry system by investigating different ionization approaches

Current development in catalyst discovery includes combinatorial synthesis methods for the rapid generation of compound libraries combined with high-throughput performance-screening methods to determine the associated activities. Of these novel methodologies, mass spectrometry (MS) based flow chemistry methods are especially attractive due to the ability to combine sensitive detection of the formed reaction product with identification of introduced catalyst complexes. Recently, such a mass spectrometry based continuous-flow reaction detection system was utilized to screen silver-adducted ferrocenyl bidentate catalyst complexes for activity in a multicomponent synthesis of a substituted 2-imidazoline. Here, we determine the merits of different ionization approaches by studying the combination of sensitive detection of product formation in the continuous-flow system with the ability to simultaneous characterize the introduced [ferrocenyl bidentate+Ag](+) catalyst complexes. To this end, we study the ionization characteristics of electrospray ionization (ESI), atmospheric-pressure chemical ionization (APCI), no-discharge APCI, dual ESI/APCI, and dual APCI/no-discharge APCI. Finally, we investigated the application potential of the different ionization approaches by the investigation of ferrocenyl bidentate catalyst complex responses in different solvents.

Surface-activated chemical ionization time-of-flight mass spectrometry and labeling-free approach: two powerful tools for the analysis of complex plant functional proteome profiles

Surface-activated chemical ionization (SACI) has been widely used in recent years to analyze a range of different compounds (e.g., peptides, street drugs, amino acids). The main benefits of this technology are its high sensitivity and its effectiveness under different chromatographic conditions. Here, we used SACI in conjunction with a highly selective quadrupole time-of-flight mass analyzer to characterize a complex proteome pattern after separation by sodium dodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE). The data obtained were compared with those obtained using the micro-electrospray ionization (ESI) approach, which showed that using SACI strongly increased the number of detectable proteins. The higher sensitivity is mainly due to the ability of SACI to selectively produce singly charged species of high intensity under full-scan conditions and doubly charged species for tandem mass spectrometric (MS/MS) peptide characterization by simply changing the ionization conditions during data acquisition.

Atmospheric pressure ion sources

This review of atmospheric pressure ion sources discusses major developments that have occurred since 1991. Advances in the instrumentation and understanding of the key physical principles are the primary focus. Developments with electrospray and atmospheric pressure chemical ionization and variations encompassing adaptations for surface analysis, ambient air analysis, high throughput, and modification of the ionization mechanism are covered. An important and limiting consequence of atmospheric pressure chemical ionization, chemical noise, is discussed as is techniques being employed to ameliorate the problem. Ion transfer and transport from atmospheric pressure into deep vacuum is an area undergoing constant improvement and refinement so is given considerable consideration in this review.

Surface-activated chemical ionization and cation exchange chromatography for the analysis of enterotoxin A

Surface-activated chemical ionization (SACI) has been widely used in recent years for the analysis of different compounds (e.g. peptides, street drugs, amino acids). The main benefits of this technology are its high sensitivity and its effectiveness under different chromatographic conditions [i.e. ion exchange chromatography and reversed-phase (RP) chromatography]. Here we used SACI in conjunction with quadrupole time-of-flight mass spectrometry to analyze enterotoxin A, which is produced by Staphylococcus aureus, in milk matrix using both RP and ion exchange chromatographies. SACI had increased sensitivity as compared with electrospray ionization. Moreover, the higher quantitation efficiency of this technique, mainly in terms of limit of detection (0.01 ng/ml), limit of quantitation (0.05 ng/ml), linearity range (0.05-50 ng/ml), matrix effect, accuracy (intraday and interday accuracy errors were 9.2% and 10.3%, respectively) and precision (intraday and interday precision errors were 5.3% and 12.8%, respectively), is shown and discussed.

The distribution of ion acceptance in atmospheric pressure ion sources: spatially resolved APLI measurements

It is demonstrated that spatially resolved mass selected analysis using atmospheric pressure laser ionization mass spectrometry (APLI MS) represents a new powerful tool for mechanistic studies of ion-molecule chemistry occurring within atmospheric pressure (AP) ion sources as well as for evaluation and optimization of ion source performance. A focused low-energy UV laser beam is positioned computer controlled orthogonally on a two-dimensional grid in the ion source enclosure. Resonance enhanced multiphoton ionization (REMPI) of selected analytes occurs only within the confined volume of the laser beam. Depending on the experimental conditions and the reactivity of the primary photo-generated ions, specific signal patterns become visible after data treatment, as visualized in, e.g., contour or pseudo-color plots. The resulting spatial dependence of sensitivity is defined in this context as the distribution of ion acceptance (DIA) of the source/analyzer combination. This approach provides a much more detailed analysis of the diverse processes occurring in AP ion sources compared with conventional bulk signal response measurements.

Development and applications of surface-activated chemical ionization

This review regards the recently developed ionization source named surface-activated chemical ionization (SACI) that employs an interaction with a surface placed at low voltage for the activation of the ionization of sample molecules to increase the sensitivity in the analysis of various compounds of biological and clinical interest. These results are due to the strong chemical noise decrease and the increase of ionization efficiency. This ionization source has been employed for the analysis of various compounds of different molecular mass and polarity (addicted and pharmaceutical drugs, amino acids, steroids, peptides, and proteins). The SACI development theoretical mechanism, benefits, disadvantages, applications, and future developments are reported and discussed.

A new sensitive and selective method for analysis of ochratoxin A in grape and wine by direct liquid chromatography/surface-activated chemical ionization tandem mass spectrometry

A new sensitive and selective analytical method for the analysis of ochratoxin A (OTA) in grape and wine was developed by coupling liquid chromatography and surface activated chemical ionization and mass spectrometry with multistage fragmentation (LC/SACI-MS(3)). A high flow gradient was used to strongly reduce the matrix effect phenomenon, and the wine sample was directly injected onto the chromatographic column without sample pre-concentration or purification steps. The amount of OTA was determined for two grape extracts and the amount of OTA, percent accuracy error and percent precision error were analyzed for 15 wine samples. An excellent limit of detection of 0.02 ng/mL was achieved, and the limit of quantification was at least 20-fold lower than the maximum legal limit for OTA (2 ppb). Due to the low limit of quantification, this novel method is a potential tool for official OTA screening purposes.

No-discharge atmospheric pressure chemical ionization: evaluation and application to the analysis of animal drug residues in complex matrices

Alternative ionization methods are increasingly being utilized to increase the versatility and selectivity of liquid chromatography/mass spectrometry (LC/MS). One such technique is the practice of using commercially available atmospheric pressure chemical ionization (APCI) sources with the corona discharge turned off, a process termed no-discharge APCI (ND-APCI). The relative LC/MS responses for several different classes of veterinary drugs were obtained by using ND-APCI, electrospray ionization (ESI), and APCI. While the ND-APCI-MS and -MSn spectra for these compounds were comparable with ESI, ND-APCI provided advantages in sensitivity and selectivity for some compounds. Drugs that were charged in solution as cations or sodium adducts responded particularly well with this technique. Instrumental parameters such as temperatures, gas and liquid flow rates, and source design were investigated to determine their effect on the process of ND-APCI. This paper explores advantages of using ND-APCI for the determination and confirmation of drug residues that might be found in food matrices, including malachite green residues in fish tissue and avermectin residues in milk.

Surface-activated chemical ionization and high-flow gradient chromatography to reduce matrix effect

The new atmospheric pressure chemical ionization source, named surface-activated chemical ionization (SACI), has been used in conjunction with high-flow gradient chromatography to reduce the matrix effect. This high-flow gradient chromatography approach avoids the co-elution of analyte and biological matrix compounds that leads to a reduction in quantitation errors due to matrix effect. However, this approach cannot be employed with the classical electrospray ionization (ESI) source that usually works at low eluent flow (< 300 microL/min). SACI can work at high eluent flow (100-2000 microL/min) and can be employed in conjunction with high-flow gradient chromatography. The reduction in matrix effect in tacrolimus analysis in protein-precipitated blood samples, an important immunosuppressive agent for renal transplantation, is presented and discussed.