Solid phase microextraction assisted by droplets-based liquid-liquid microextraction for analysis of volatile aromatic hydrocarbons in water by gas chromatography

All-in-one solid-phase microextraction: Development of a selective solid-phase microextraction fiber assembly for the simultaneous and efficient extraction of analytes with different polarities

In the present work, for the first time, an all-in-one solid-phase microextraction technique was developed for the simultaneous and efficient extraction of analytes within a vast polarity range. A novel fiber assembly composed of two different steel components each coated with different coatings (polydimethylsiloxane and polyethylene glycol) in terms of polarity by sol-gel technology was employed for the extraction of model compounds of different polarity in a single run followed by gas chromatography with mass spectrometry. Effective parameters in the extraction step and gas chromatography with mass spectrometry analysis were optimized for all model compounds. The detection limits of the developed method for model compounds were below 0.2 ng/L. The repeatability and reproducibility of the proposed method, explained by relative standard deviation, varied between 7.22 and 9.15% and between 7.95 and 14.90 (n = 5), respectively. Results showed that, under random conditions, compared to separate extractions performed by two other differently end-coated components that had not been assembled as the final dual fiber, as two individual fibers; simultaneous, efficient and relatively selective extraction of all model compounds was obtained in a single run by the proposed all-in-one technique. Finally, the optimized procedure was applied to extraction and determination of the model compounds in spiked water samples.

Identification of Volatile Compounds from a Brewery with SPME Technique

The paper presents results of the analysis of the volatile compounds arising from the production processes in a brewery. The investigated material comprised the unhoped brewer’s wort which was taken from the fermentation tanks during the industrial process. The identification of volatile compounds was conducted with the use of Solid-Phase MicroExtraction (SPME) technique by extracting the compounds from the headspace of the brewer’s wort (HS-SPME). The procedure was optimized by modifying the parameters potentially influencing the process efficiency. The analytes adsorbed on the fibers were subsequently placed in the injector of a gas chromatograph, where they were released in the course of thermal desorption. Three types of fibers were chosen for the experiments: 65 μm PDMS/DVB, 50/30 μm DVB/CAR/PDMS and 100 μm PDMS. The greatest number of peaks corresponding to compounds found in the examined material was observed on the 50/30 μm DVB/CAR/PDMS fiber while the lowest was identified on the 100 μm PDMS fiber. The detected compounds are mainly the derivatives of aliphatic, alicyclic and aromatic hydrocarbons with different functional groups e.g. carbonyl, aldehyde or ester and possessing O-heteroatom in their structure.

Determination of monoaromatic hydrocarbons (BTEX) in surface waters from a Brazilian subtropical hydrographic basin

This study examined surface water samples for the presence of the monoaromatic hydrocarbons benzene, toluene, ethylbenzene and xylene. Water samples were collected from the sub-basin of the Tegas River and the Marrecas Stream microbasin located in the metropolitan region of the municipality of Caxias do Sul (Rio Grande do Sul State, Brazil). For all sampling points evaluated, only toluene was detected, with concentrations values in the range of 1.70-18.44 μg L(-1). In general, the relatively high toluene concentration for the samples collected were above the limit of 2 μg L(-1) established by the Brazilian government for Class I rivers for the protection of aquatic life. However, they were well below the established limit of 170 μg L(-1) in water used for human consumption.