Alaska Pollock-derived Gelatin Sealant has Higher Sealing Strength than, and Comparable Biocompatibility with, Fibrin Sealant in Porcine and Rat Dural Injury Models

STUDY DESIGN

Burst strength study in porcine dural models and functional and histological study in rat dural models.

OBJECTIVE

This study aimed to investigate the sealing strength and biocompatibility of Alaska pollock-derived gelatin (ApGltn) and fibrin sealants in disrupted dural injuries.

SUMMARY OF BACKGROUND DATA

Disruption of the dura mater occurs during spine surgery, leading to cerebrospinal fluid leakage. Fibrin sealant is usually applied to ruptured sites; however, it lacks sealing strength. A novel biocompatible sealant composed of ApGltn was recently demonstrated to have good burst strength and biocompatibility in the porcine aorta.

METHODS

Ten porcine dura maters with central holes were covered with ApGltn and fibrin sealants (five samples per group). The maximum burst strength of each sealant was measured, and histological examination was performed after burst testing. Twenty-seven dura maters of male Wistar rats were used for functional and histopathological evaluations. The rats were treated with three surgical interventions: defect + ApGltn sealant; defect + fibrin sealant; defect alone (nine rats per group). Macroscopic confirmation of the sealant, hindlimb motor function analysis, and histopathological examination were performed at two, four, and eight weeks after the procedure.

RESULTS

The maximum burst strength of the ApGltn sealant was ~4.4 times higher than that of the fibrin sealant (68.1±12.1 vs . 15.6±8.7 mmHg; P <0.001). Histological examination confirmed that the ApGltn sealant showed tight adhesion to the dural surface, whereas a gap was observed between the fibrin sealant and the dura mater. In the rat model, the ApGltn sealant resulted in spinal function and dural histological findings similar to those of the fibrin sealant.

CONCLUSION

The ApGltn sealant had a higher sealing strength than, and comparable effect on dura regeneration with, the fibrin sealant.

Effect of Alaska pollock-gelatin sheet on repair strength and regeneration of nerve

The aim of the study was to investigate the repair strength and the biocompatibility of Alaska pollock-derived gelatin (ApGltn) sheet for nerve repair. Cadaveric digital nerves were repaired with double suture, single suture + ApGltn sheet, single suture + fibrin glue, single suture, ApGltn sheet and fibrin. Maximum failure loads were measured (20 nerves each). Rat sciatic nerves were repaired with double suture, single suture + ApGltn sheet, single suture, ApGltn sheet, fibrin glue and resection (10 nerves each). Macroscopic appearance, muscle weight and histopathological findings were examined 8 weeks postoperatively. The mean failure load of ApGltn sheet (0.39 N) was significantly higher than that of a fibrin (0.05 N), and that of single suture + ApGltn sheet (1.32 N) was significantly higher than that of a single suture alone (0.97 N). Functional and histological assessments showed similar nerve recovery among the suture, ApGltn and fibrin groups. ApGltn sheet has potential for clinical application as an alternative to fibrin.

Improved Swelling Property of Tissue Adhesive Hydrogels Based on α-Cyclodextrin/Decyl Group-Modified Alaska Pollock Gelatin Inclusion Complexes

Adhesives/sealants are used after suturing to prevent leakage of cerebrospinal fluid from an anastomotic site. Commercial adhesives/sealants have been used to close the cerebral dura. However, swelling of the cured adhesives/sealants induces increased intracranial pressure and decreases the strength of the seal. In the present study, tissue adhesive hydrogels with improved swelling property using inclusion complex composed of α-cyclodextrin (αCD) and decyl group (C10)-modified Alaska pollock-derived gelatin (C10-ApGltn) with a high degree of substitution (DS) (>20 mol%) are developed. Viscosity of C10-ApGltn with a high DS solution remarkably decreased by the addition of αCD. The resulting αCD/C10-ApGltn adhesive hydrogel composed of αCD/C10-ApGltn inclusion complexes and poly(ethylene glycol) (PEG)-based crosslinker showed improved swelling property after immersion in saline. Also, the resulting adhesive has a significantly higher burst strength than fibrin-based adhesives and is as strong as a PEG-based adhesive. Quantitative analysis of αCD revealed that the improved swelling property of the resulting adhesive hydrogels is induced by the release of αCD from cured adhesive, and the subsequent assembly of decyl groups in the saline. These results suggest that adhesives developed using the αCD/C10-ApGltn inclusion complex can be useful for closing the cerebral dura mater.

Poly(ethylene oxide)/Gelatin-Based Biphasic Photocrosslinkable Hydrogels of Tunable Morphology for Hepatic Progenitor Cell Encapsulation

Macroporous hydrogels have great potential for biomedical applications. Liquid or gel-like pores were created in a photopolymerizable hydrogel by forming water-in-water emulsions upon mixing aqueous solutions of gelatin and a poly(ethylene oxide) (PEO)-based triblock copolymer. The copolymer constituted the continuous matrix, which dominated the mechanical properties of the hydrogel once photopolymerized. The gelatin constituted the dispersed phase, which created macropores in the hydrogel. The microstructures of the porous hydrogel were determined by the volume fraction of the gelatin phase. When volume fractions were close to 50 v%, free-standing hydrogels with interpenetrated morphology can be obtained thanks to the addition of a small amount of xanthan. The hydrogels displayed Young's moduli ranging from 5 to 30 kPa. They have been found to be non-swellable and non-degradable in physiological conditions. Preliminary viability tests with hepatic progenitor cells embedded in monophasic PEO-based hydrogels showed rapid mortality of the cells, whereas encouraging viability was observed in PEO-based triblock copolymer/gelatin macroporous hydrogels. The latter has the potential to be used in cell therapy.

A Novel Alaska Pollock Gelatin Sealant Shows Higher Bonding Strength and Nerve Regeneration Comparable to That of Fibrin Sealant in a Cadaveric Model and a Rat Model

BACKGROUND

A novel biocompatible sealant composed of Alaska pollock-derived gelatin (ApGltn) has recently shown good burst strength and biocompatibility in a porcine aorta. The purpose of this study was to investigate the bonding strength and biocompatibility of the ApGltn sealant in transected digital nerves of fresh frozen cadavers and in the sciatic nerves of a rat model.

METHODS

Eighty human digital nerves of fresh frozen cadavers were transected for biomechanical traction testing. They were treated with four surgical interventions: (1) suture plus ApGltn sealant; (2) suture; (3) ApGltn sealant; and (4) fibrin sealant. Forty-three sciatic nerves of male Wistar rats were used for functional and histopathologic evaluation. They were treated with six surgical interventions: (1) suture plus ApGltn sealant; (2) suture; (3) ApGltn sealant; (4) fibrin sealant; (5) resection with a 5-mm gap (10 rats per group); and (6) sham operation (three rats). Macroscopic confirmation, muscle weight measurement, and histopathologic findings including G-ratio were examined 8 weeks after the procedure.

RESULTS

The maximum failure load of the ApGltn sealant was significantly higher than that of a fibrin sealant (0.22 ± 0.05 N versus 0.06 ± 0.04 N). The maximum failure load of the ApGltn sealant was significantly lower that of suture plus ApGltn sealant (1.37 N) and suture (1.27 N). Functional evaluation and histologic examination showed that sciatic nerves repaired with ApGltn sealant showed similar nerve recovery compared to repair with the suture and fibrin sealant.

CONCLUSION

The ApGltn sealant showed higher bonding strength and equal effect of nerve regeneration when compared with the fibrin sealant.

Prevention of pulmonary air leaks using a biodegradable tissue-adhesive fiber sheet based on Alaska pollock gelatin modified with decanyl groups

Tissue adhesives have been widely used in surgery to treat pulmonary air leaks. However, conventional adhesives have poor interfacial strength under wet conditions. To overcome this clinical problem, we modified Alaska pollock-derived gelatin to include decanyl (C10) groups (C10-ApGltn) and used electrospinning to create a tissue-adhesive fiber sheet (AdFS). C10-AdFS showed higher burst strength when adhering to porcine pleura compared with a sheet of original ApGltn (Org-ApGltn). Hematoxylin-eosin-stained sections after burst experiments reveal that a dense C10-AdFS layer remained on the surface of the porcine pleura. The effect of the degree of C10 modification of ApGltn on the burst strength was evaluated. ApGltn with a C10 modification ratio of 13 mol% amino groups (13C10-AdFS) exhibited the highest burst strength. Furthermore, from ex vivo experiments with extracted rat lung, 13C10-AdFS exhibited a higher burst strength (41 cm H₂O) than Org-AdFS. The decanyl groups in 13C10-AdFS interacted with the hydrophobic proteins and the lipid bilayers of the cells, resulting in the high interfacial strength between 13C10-AdFS and the pleura. Moreover, 13C10-AdFS samples implanted subcutaneously in the backs of rats were completely degraded within 21 days without any severe inflammation. These results show that 13C10-AdFS is a promising adhesive material for the treatment of pulmonary air leaks.