Nanofiltration membrane cross-linked by m -phenylenediamine for dye removal from textile wastewater

Impact of textile dyes on health and ecosystem: a review of structure, causes, and potential solutions

The rapid growth of population and industrialization have intensified the problem of water pollution globally. To meet the challenge of industrialization, the use of synthetic dyes in the textile industry, dyeing and printing industry, tannery and paint industry, paper and pulp industry, cosmetic and food industry, dye manufacturing industry, and pharmaceutical industry has increased exponentially. Among these industries, the textile industry is prominent for the water pollution due to the hefty consumption of water and discharge of coloring materials in the effluent. The discharge of this effluent into the aquatic reservoir affects its biochemical oxygen demand (BOD), chemical oxygen demand (COD), total dissolved solids (TDS), total suspended solids (TSS), and pH. The release of the effluents without any remedial treatment will generate a gigantic peril to the aquatic ecosystem and human health. The ecological-friendly treatment of the dye-containing wastewater to minimize the detrimental effect on human health and the environment is the need of the hour. The purpose of this review is to evaluate the catastrophic effects of textile dyes on human health and the environment. This review provides a comprehensive insight into the dyes and chemicals used in the textile industry, focusing on the typical treatment processes for their removal from industrial wastewaters, including chemical, biological, physical, and hybrid techniques.

Nanomaterials as a Sustainable Choice for Treating Wastewater: A Review

The removal of dyes from textile effluents utilizing advanced wastewater treatment methods with high efficiency and low cost has received substantial attention due to the rise in pollutants in water. The purpose of this work is to give a comprehensive analysis of the different treatments for removing chemical dyes from textile effluents. The capability and potential of conventional treatments for the degradation of dyeing compounds in aqueous media, as well as the influence of multiple parameters, such as the pH solution, initial dye concentration, and adsorbent dose, are presented in this study. This study is an overview of the scientific research literature on this topic, including nanoreductive and nanophotocatalyst processes, as well as nanoadsorbents and nanomembranes. For the purpose of treating sewage, the special properties of nanoparticles are currently being carefully researched. The ability of nanomaterials to remove organic matter, fungus, and viruses from wastewater is another benefit. Nanomaterials are employed in advanced oxidation techniques to clean wastewater. Additionally, because of their small dimensions, nanoparticles have a wide effective area of contact. Due to this, nanoparticles' adsorption and reactivity are powerful. The improvement of nanomaterial technology will be beneficial for the treatment of wastewater. This report also offers a thorough review of the distinctive properties of nanomaterials used in wastewater treatment, as well as their appropriate application and future possibilities. Since only a few types of nanomaterials have been produced, it is also important to focus on their technological feasibility in addition to their economic feasibility. According to this study, nanoparticles (NPs) have a significant adsorption area, efficient chemical reactions, and electrical conductivity that help treat wastewater effectively.

The comparison of Fenton and photo-Fenton oxidation as a primary unit process for the treatment of raw textile wastewaters

The Fenton and photo-Fenton oxidation processes (FOP and PFOP) are usually applied as a secondary unit process, and direct usage of both processes is critical in textile wastewater treatment. There is seldom study on the direct application of the FOP or PFOP showing the treatment of raw textile industry wastewaters. This study demonstrates the application and comparison of both FOP and PFOP as single units separately for the treatment of wastewater in a textile industry producing woven fabrics. In both processes, the highest treatment efficiency was achieved at pH 3. Chemical oxygen demand (COD), suspended solids (SS), and color parameters in FOP reduced from 1341 to 254 mg/L, 99.5 to 19.9 mg/L, and 1396 to 97.7 Pt-Co, respectively. Separately, in the PFOP, 365-nm wavelength UV radiation sources have been used. In PFOP, the same parameters were reduced from 715 to 42.9 mg/L, 90 to 9 mg/L, and 2080 to 83.2 Pt-Co, respectively. These results were obtained at 0.7 g Fe2+/L and 2 mM H2O2 concentrations in both studies. PFOP can meet the textile industry receiving environment discharge standards of many countries, especially in Turkey. The use of PFOP as a single unit is possible in the treatment of textile industry wastewater without primary precipitation. The findings in this study may be practical for the adaptation of the processes on the field scale. PRACTITIONER POINTS: There is seldom study on the direct application of Fenton or photo-Fenton processes as a single unit to raw textile wastewaters This study shows the application of the Fenton or photo-Fenton processes as single units for the treatment of raw wastewater in a textile industry Results of both processes in this study meet the discharge standards of many countries Evaluations of efficiencies of both processes were achieved This study may be the focus of attention of treatment plant operators and researchers.

A Survey on Nanotechnology-Based Bioremediation of Wastewater

Rainwater discharge and human impacts produce wastewater, which is a contaminated type of water. Sediments also discharge phosphate into the water column when there is a lack of dissolved oxygen in the water. Through the manufacturing of environmentally benign nanoparticles, nanotechnology may reduce the amount of money spent by enterprises to remediate such contaminants. Because of their improved physiological, biochemical, and biomechanical qualities, nanoparticles are getting prominence. The importance of the global wastewater dilemma is discussed in this survey. The use of nanomaterials in heavy metal remediation (HMR) and wastewater treatment is covered in this survey. This paper also discusses the benefits of nanotechnology over traditional approaches in certain fields. This survey aims to gather together many recent studies on nanoparticle production and their benefits as adsorbents in the remediation of wastewater which have been done so far. The promising role of nanotechnology in wastewater remediation is surveyed in this research, which also discusses recent developments in nanotechnology-mediated remediation methods. This survey examines the vital potential of nanotechnology in wastewater treatment, as well as recent breakthroughs in nanotechnology-mediated treatment systems.

Activated biochar derived from spent Auricularia auricula substrate for the efficient adsorption of cationic azo dyes from single and binary adsorptive systems

In this study, spent Auricularia auricula substrate (AS)-derived biochar (ASBCs) and activated biochar with NaOH (A-ASBC) were evaluated for the adsorption of cationic azo dyes, including methylene blue (MB), rhodamine B (RB), and crystal violet (CV), from single and binary adsorptive systems. A-ASBC showed a higher maximum adsorption capacity for these dyes (MB: 53.62 mg·g^-1, RB: 32.33 mg·g^-1, CV: 735.73 mg·g^-1) than ASBCs in a single system because it had a greater specific surface area and more oxygen containing-functional groups on the surface. The adsorption process of the three dyes onto the adsorbents was in good agreement with the Freundlich adsorption isotherm and fit the pseudo-second-order kinetic model, which revealed sorbate polymolecular layer formation over the adsorbent surface and the involvement of chemisorption. The adsorption mechanism showed that the adsorption of three dyes on adsorbents could be postulated as a multistep process with extraordinary affinity-induced adsorption in terms of both physisorption and chemisorption. In the binary adsorptive system, the results showed that all MB, RB, and CV had antagonistic/competitive effects on each other's adsorption (Q_Binary/Q_Single < 1). Furthermore, a phytotoxic assay affirmed the effectiveness of the adsorbent in adsorbing dye species from aqueous solutions using Brassica pekinensis L. seeds as the model. Therefore, activated biochar prepared from AS can be used as a potentially economical and effective adsorbent for treating printing and dyeing wastewater.