Polyamide-6/high-density polyethylene blend using recycled high-density polyethylene as compatibilizer: Morphology, mechanical properties, and thermal stability

Reactive Compatibilization of Polyamide 6/Olefin Block Copolymer Blends: Phase Morphology, Rheological Behavior, Thermal Behavior, and Mechanical Properties

In this study, the morphology, rheological behavior, thermal behavior, and mechanical properties of a polyamide 6 (PA6) and olefin block copolymer (OBC) blend compatibilized with maleic anhydride-grafted polyethylene-octene copolymer (POE-g-MAH) were investigated. The morphological observations showed that the addition of POE-g-MAH enhanced the OBC particle dispersion in the PA6 matrix, suggesting a better interfacial compatibility between the pure PA6 and OBC. The results of the Fourier transform infrared (FTIR) spectroscopy analysis and the Molau test confirmed the compatibilization reactions between POE-g-MAH and PA6. The rheological test revealed that the melt viscosity, storage modulus (G’), and loss modulus (G”) of the compatibilized PA6/OBC blends at low frequency were increased with the increasing POE-g-MAH content. The thermal analysis indicated that the addition of OBC had little effect on the crystallization behavior of PA6, while the incorporation of POE-g-MAH at high content (7 wt%) in the PA6/OBC blend restricted the crystallization of PA6. In addition, the compatibilized blends exhibited a significant enhancement in impact strength compared to the uncompatibilized PA6/OBC blend, in which the highest value of impact strength obtained at a POE-g-MAH content of 7 wt% was about 194% higher than that of pure PA6 under our experimental conditions.

Closing the loop on plastic packaging materials: What is quality and how does it affect their circularity?

While attention on the importance of closing materials loops for achieving circular economy (CE) is raging, the technicalities of doing so are often neglected or difficult to overcome. These technicalities determine the ability of materials, components and products (MCPs) to be properly recovered and redistributed for reuse, recycling or recovery, given their remaining functionality, described here as the remaining properties and characteristics of MCPs. The different properties of MCPs make them useful for various functions and purposes. A transition, therefore, towards a CE would require the utmost exploitation of the remaining functionality of MCPs; ideally, enabling recirculation of them back in the economy. At present, this is difficult to succeed. This short communication article explains how the remaining functionality of MCPs, defined here as quality, is perceived at different stages of the supply chain, focusing specifically on plastic packaging, and how this affects their potential recycling. It then outlines the opportunities and constraints posed by some of the interventions that are currently introduced into the plastic packaging system, aimed at improving plastic materials circularity. Finally, the article underpins the need for research that integrates systemic thinking, with technological innovations and policy reforms at all stages of the supply chain, to promote sustainable practices become established.