The Molecular Footprint of Peptides on the Surface of Ultrasmall Gold Nanoparticles (2 nm) Is Governed by Steric Demand

Ultrasmall gold nanoparticles were functionalized with peptides of two to seven amino acids that contained one cysteine molecule as anchor via a thiol-gold bond and a number of alanine residues as nonbinding amino acid. The cysteine was located either in the center of the molecule or at the end (C-terminus). For comparison, gold nanoparticles were also functionalized with cysteine alone. The particles were characterized by UV spectroscopy, differential centrifugal sedimentation (DCS), high-resolution transmission electron microscopy (HRTEM), and small-angle X-ray scattering (SAXS). This confirmed the uniform metal core (2 nm diameter). The hydrodynamic diameter was probed by 1H-DOSY NMR spectroscopy and showed an increase in thickness of the hydrated peptide layer with increasing peptide size (up to 1.4 nm for heptapeptides; 0.20 nm per amino acid in the peptide). 1H NMR spectroscopy of water-dispersed nanoparticles showed the integrity of the peptides and the effect of the metal core on the peptide. Notably, the NMR signals were very broad near the metal surface and became increasingly narrow in a distance. In particular, the methyl groups of alanine can be used as probe for the resolution of the NMR spectra. The number of peptide ligands on each nanoparticle was determined using quantitative 1H NMR spectroscopy. It decreased with increasing peptide length from about 100 for a dipeptide to about 12 for a heptapeptide, resulting in an increase of the molecular footprint from about 0.1 to 1.1 nm2.

Ultrastructure and Surface Composition of Glutathione-Terminated Ultrasmall Silver, Gold, Platinum, and Alloyed Silver-Platinum Nanoparticles (2 nm)

Alloyed ultrasmall silver-platinum nanoparticles (molar ratio Ag:Pt = 50:50) were prepared and compared to pure silver, platinum, and gold nanoparticles, all with a metallic core diameter of 2 nm. They were surface-stabilized by a layer of glutathione (GSH). A comprehensive characterization by high-resolution transmission electron microscopy (HRTEM), electron diffraction (ED), X-ray diffraction (XRD), small-angle X-ray scattering (SAXS), differential centrifugal sedimentation (DCS), and UV spectroscopy showed their size both in the dry and in the water-dispersed state (hydrodynamic diameter). Solution NMR spectroscopy (1H, 13C, COSY, HSQC, HMBC, and DOSY) showed the nature of the glutathione shell including the number of GSH ligands on each nanoparticle (about 200 with a molecular footprint of 0.063 nm2 each). It furthermore showed that there are at least two different positions for the GSH ligand on the gold nanoparticle surface. Platinum strongly reduced the resolution of the NMR spectra compared to silver and gold, also in the alloyed nanoparticles. X-ray photoelectron spectroscopy (XPS) showed that silver, platinum, and silver-platinum particles were at least partially oxidized to Ag(+I) and Pt(+II), whereas the gold nanoparticles showed no sign of oxidation. Platinum and gold nanoparticles were well crystalline but twinned (fcc lattice) despite the small particle size. Silver was crystalline in electron diffraction but not in X-ray diffraction. Alloyed silver-platinum nanoparticles were almost fully amorphous by both methods, indicating a considerable internal disorder.

Charge Transfer Surface-Enhanced Raman and Absorption Spectra of the Zwitterionic Form of Cysteine Adsorbed on M@Au12 (M = Au, Ag, Pt, and Pd) Nanoclusters

The effect of the core atom type of the M@Au₁₂ nanocluster (M = Au, Ag, Pt, and Pd) on the normal (NR) and charge-transfer surface-enhanced Raman spectroscopy (CT-SERS) of the zwitterion form of l-cysteine (ZWCYS) adsorbed on two different sites (D1 and D2) of the nanocluster is investigated separately in the gas phase and water. Because SERS requires the calculation of the absorption spectrum, the effect of the core atom type on the absorption spectrum of M@Au₁₂ and its complex with the ZWCYS has also been investigated. The vibrational bands that show the intensity enhancement in the CT-SERS of the ZWCYS interacting with the D1 site of M@Au₁₂ nanocluster in water are O─C═O asymmetric stretching (M = Au and Ag), NH₂ bending (M = Ag), S-H stretching (M = Ag, Pt, and Pd), CH₂ bending (M = Pt), and CH₂ symmetric stretching (M = Pt and Pd). The ZWCYS at the D₂ site of the M@Au₁₂ nanocluster in water exhibits intensity enhancement for O─C═O asymmetric stretching (M = Pt), NH₃ wagging (M = Au), and S-H stretching (M = Pd). The intensity of the vibrational bands of ZWCYS does not increase for M = Ag but decreases for O─C═O asymmetric stretching, S-H stretching, CH₂ symmetric stretching, CH₂ asymmetric stretching, and especially NH₂ symmetric stretching.

Water-Based Synthesis of Ultrasmall Nanoparticles of Platinum Group Metal Oxides (1.8 nm)

Ultrasmall nanoparticles of platinum group metal oxides (core diameter of about 1.8 nm) were prepared by alkaline hydrolysis of metal precursors in the presence of NaBH₄ and by colloidal stabilization with tripeptide glutathione. We obtained water-dispersed nanoparticles of Rh₂O₃, PdO, RuO₂, IrO₂, Os/OsO₂, and Pt/PtO. Their size was probed using high-resolution transmission electron microscopy, differential centrifugal sedimentation, small-angle X-ray scattering, and diffusion-ordered ¹H NMR spectroscopy (¹H DOSY). Their oxidation state was clearly determined using X-ray photoelectron spectroscopy, X-ray powder diffraction, and electron diffraction. The chemical composition of the nanoparticles, that is, the ratio of the metal oxide core and glutathione capping agent, was quantitatively determined by a combination of these methods.

Surface reconstruction of AgPd nanoalloy particles during the electrocatalytic formate oxidation reaction

Formate is a kind of carbon-neutral fuel that can be synthesized by electrochemical conversion of CO₂, however, the generated aqueous formate electrolyte is still short of potential application. Here, formate solution is proposed to be utilized as anode fuels of direct formate fuel cells through the formate oxidation reaction (FOR), and graphene supported AgPd nanoalloys (AgPd/rGO) are prepared to catalyze the FOR. Specifically, the mass activity of the as-prepared Ag₄₉Pd₅₁/rGO catalyst is 4.21 A mg^-1_Pd and the retention activity of Ag₄₉Pd₅₁/rGO is 49.1% of initial activity after successive 500 cycles, which is 2.48 and 3.03 times higher than that of unsupported Ag₅₁Pd₄₉ nanoalloys. When increasing the positive scan limit from 0.0 to 0.8 V, the mass activity of the Ag₄₉Pd₅₁/rGO catalyst increases from 2.32 to 6.03 A mg^-1_Pd and Pd surface coverage increases from 51.87% to 62.42%, indicating the occurrence of surface reconstruction where Pd atoms migrate to the surface of AgPd nanoalloys, and less intensive reconstruction is observed in unsupported Ag₅₁Pd₄₉ nanoalloys, whose mass activity increases from 1.35 to 2.49 A mg^-1_Pd. The driving force and kinetic path are calculated for the surface reconstruction induced by the adsorption of H, O and C atoms, in the case of C atoms on graphene, the segregation energy of surface Pd atoms in the AgPd nanoalloy is -1.16 eV, and the activation energy for the migration of subsurface Pd atoms to the surface is 0.54 eV, which are lower than the segregation (0.03 eV) and activation (2.06 eV) energy on a clean alloy surface.

Adaptive kinetic Monte Carlo simulations of surface segregation in PdAu nanoparticles

Surface segregation in bimetallic nanoparticles (NPs) is critically important for their catalytic activity because the activity is largely determined by the surface composition. Little, however, is known about the atomic scale mechanisms and kinetics of surface segregation. One reason is that it is hard to resolve atomic rearrangements experimentally. It is also difficult to model surface segregation at the atomic scale because the atomic rearrangements can take place on time scales of seconds or minutes - much longer than can be modeled with molecular dynamics. Here we use the adaptive kinetic Monte Carlo (AKMC) method to model the segregation dynamics in PdAu NPs over experimentally relevant time scales, and reveal the origin of kinetic stability of the core@shell and random alloy NPs at the atomic level. Our focus on PdAu NPs is motivated by experimental work showing that both core@shell and random alloy PdAu NPs with diameters of less than 2 nm are stable, indicating that one of these structures must be metastable and kinetically trapped. Our simulations show that both the Au@Pd and the PdAu random alloy NPs are metastable and kinetically trapped below 400 K over time scales of hours. These AKMC simulations provide insight into the energy landscape of the two NP structures, and the diffusion mechanisms that lead to segregation. In the core-shell NP, surface segregation occurs primarily on the (100) facet through both a vacancy-mediated and a concerted mechanism. The system becomes kinetically trapped when all corner sites in the core of the NP are occupied by Pd atoms. Higher energy barriers are required for further segregation, so that the metastable NP has a partially alloyed shell. In contrast, surface segregation in the random alloy PdAu NP is suppressed because the random alloy NP has reduced strain as compared to the Au@Pd NP, and the segregation mechanisms in the alloy require more elastic energy for exchange of Pd and Au and between the surface and subsurface.

X-ray powder diffraction to analyse bimetallic core–shell nanoparticles (gold and palladium; 7–8 nm)

A comparative X-ray powder diffraction study on poly(N-vinyl pyrrolidone) (PVP)-stabilized palladium and gold nanoparticles and bimetallic Pd–Au nanoparticles (both types of core–shell nanostructures) was performed.

Surface faceting and compositional evolution of Pd@Au core–shell nanocrystals during in situ annealing

A step-wise transformation process of a Pd@Au nanoparticle both structurally and compositionally was observed. Monte Carlo simulation was used to explain the results.

Bimetallic Gold-Silver Nanoparticles Supported on Zeolitic Imidazolate Framework-8 as Highly Active Heterogenous Catalysts for Selective Oxidation of Benzyl Alcohol into Benzaldehyde

The metal-organic zeolite imidazolate framework-8 (ZIF-8) supported gold-silver bimetallic catalysts with a core-shell structure (Au@Ag/ZIF-8 and Ag@Au/ZIF-8) and cluster structure (AuAg/ZIF-8) were successfully prepared by the deposition-redispersion method. Energy dispersive X-ray spectroscopy (EDS) elemental mapping images displayed that in the Au@Ag/ZIF-8 catalyst, Ag atoms were deposited on an exposed Au surface, and core-shell structured Au@Ag particles with highly dispersed Ag as the shell were formed. Additionally, the XPS investigation at gold 4f levels and silver 3d levels indicated that the Au and Ag particles of Au@Ag/ZIF-8, Ag@Au/ZIF-8, and AuAg/ZIF-8 were in a zero valence state. Among the resultant catalysts obtained in this study, Ag@Au/ZIF-8 catalysts showed the highest catalytic activity for the selective oxidation of benzyl alcohol, followed by AuAg/ZIF-8 and Au@Ag/ZIF-8. The turnover frequency (TOF) values were in the order of Ag@Au/ZIF-8 (28.2 h-1) > AuAg/ZIF-8 (25.0 h-1) > Au@Ag/ZIF-8 (20.0 h-1) at 130 °C within 1 h under 8 bar O₂ when using THF as solvent. The catalysts of Au@Ag/ZIF-8 and Ag@Au/ZIF-8 with core⁻shell structures have higher benzaldehyde selectivities (53.0% and 53.3%) than the AuAg/ZIF-8 catalyst (35.2%) in the selective oxidation of benzyl alcohol into benzaldehyde. The effect of the solvent, reaction temperature, reaction time, and reaction pressure on benzyl alcohol conversion and benzaldehyde selectivity in benzyl alcohol selective oxidation over Au@Ag/ZIF-8, Ag@Au/ZIF-8, and AuAg/ZIF-8 were also investigated. All of the catalysts showed excellent performance at 130 °C under 8 bar O₂ within 1 h when using THF as the solvent in the selective oxidation of benzyl alcohol to benzaldehyde. Moreover, the catalysts can be easily recycled and used repetitively at least four times.