Theoretical and experimental studies on photocatalytic removal of methylene blue (MetB) from aqueous solution using oyster shell synthesized CaO nanoparticles (CaONP-O)

The development of technologies for the removal of dye from aqueous solution is most desirable if the end product is relatively green (i.e., environmentally friendly). Photodegradation (as one of such technology) and photolysis (without the catalyst) was applied to investigate the role of sol-gel synthesized calcium oxide nanoparticle (using the oyster shell as the precursor). The results obtained gave substantial evidence that calcium oxide nanoparticles catalyzed the degradation of the methylene blue dye up to a maximum percentage of 98 % removal. Degradation efficiency displayed a strong dependency on time, initial dye concentration, catalyst load, pH, and ionic strength. Chi-square and sum of square error analysis indicated that the photodegradation kinetics fitted the Langmuir-Hinshelwood, first order, and pseudo first-order models best. The half-life of the dye was significantly reduced from hours to minutes due to photocatalysis. Quantum chemical calculations indicated that the degradation proceeded through adsorption, deformation/degradation, and desorption through the chloride end of the molecule linked to the calcium active center of the catalyst. Results from Fukui functions and molecular descriptors analysis confirmed the mechanism of photocatalysis.

Synthesis and characterization of calcium and magnesium based oxides and titanates for photocatalytic degradation of rhodamine B: a comparative study

The current investigation deals with the simple and ecological synthesis of CaO, MgO, CaTiO_3, and MgTiO₃ for the photocatalytic dilapidation of rhodamine B dye. CaO was procured from chicken eggshell waste by calcination process, while MgO was produced by solution combustion method using urea as a fuel source. Furthermore, CaTiO₃ and MgTiO₃ were synthesized through an easy and simple solid-state method by mixing thoroughly the synthesized CaO or MgO with TiO₂ before calcination at 900 °C. XRD and EDX investigations confirmed the phase formation of the materials. Moreover, FTIR spectra revealed the existence of Ca-Ti-O, Mg-Ti-O, and Ti-O which resembles the chemical composition of the proposed materials. SEM micrographs revealed that the surface of CaTiO₃ is rougher with relatively dispersed particles compared to MgTiO₃, reflecting a higher surface area of CaTiO₃. Diffuse reflectance spectroscopy investigations indicated that the synthesized materials can act as photocatalysts under UV illumination. Accordingly, CaO and CaTiO₃ effectively degraded rhodamine B dye within 120 min with a photodegradation activity of 63% and 72%, respectively. In contrast, the photocatalytic degradation activity of MgO and MgTiO₃ was much lower, since only 21.39 and 29.44% of the dye were degraded, respectively after 120 min of irradiation. Furtheremore, the photocatalytic activity of the mixture from both Ca and Mg titanates was 64.63%. These findings might be valuable for designing potential and affordable photocatalysts for wastewater purification.

Enhanced photocatalytic potential of TiO2 nanoparticles in coupled CdTiO2 and ZnCdTiO2 nanocomposites

Photodegradation of organic pollutants is the most suitable and cheaper technique to counter decontamination issues. Among the metal-based nanoparticles, TiO₂ is considered to be the most effective heterogeneous photocatalyst for the photodegradation of organic pollutants. However, the large band gap and the high electron-hole pair recombination rate limit its practical applications. Herein, an approach was introduced to minimize the mentioned limitations by preparing CdTiO₂ and ZnCdTiO₂ nanocomposites by co-precipitation method. The as-synthesized TiO₂, CdTiO₂, and ZnCdTiO₂ were characterized by scanning electron microscopy, transmission electron microscopy (TEM), energy dispersive X-ray, X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET), and UV-visible spectrophotometry. Morphological analysis revealed that TiO₂ are mostly agglomerated with different shapes and sizes and the nanocomposites are mostly in dispersed form. The components of the nanocomposites are strongly intercalated in the ternary nanocomposite as confirmed from TEM analysis. XRD analysis confirmed the anatase TiO₂ while the UV-visible analysis showed the shifting toward higher wavelength. The band gap energy of TiO₂ (2.65) decreased to 2.6 and 2.56 eV for CdTiO₂ and ZnCdTiO₂, respectively. BET analysis has shown a 47.2 m²/g surface area for the ternary ZnCdTiO₂ nanocomposite. The photodegradation results revealed that TiO₂, CdTiO₂, and ZnCdTiO₂ degraded about 74%, 86%, and 97.61% methylene blue dye, respectively, within 2 h. Maximum photodegradation is achieved in the basic medium and the ternary ZnCdTiO₂ nanocomposite degraded 98% dye at pH 10.