A New Fluorescent Probe for Selective Cd2+ Detection and Cell Imaging

Novel fluorescent probe for sequential recognition of Zn2+ and pyrophosphate in aqueous based on aggregation-induced emission

A new fluorescent probe (E)-4-(4-([2,2':6',2''-terpyridin]-4'-yl)styryl)-1-dodecylpyridin-1-ium (TPy-SD), with the aggregation-induced emission (AIE) property in aqueous solution, has been synthesized and characterized. The new probe, TPy-SD exhibited excellent selectivity and sensitivity towards Zn²⁺ with a relatively low detection limit (1.76 × 10^-7 M). The addition of Zn²⁺ is thought to disrupt the AIE property of TPy-SD, thereby leading to a fluorescence blue shift. Interestingly, the complex of probe TPy-SD with Zn²⁺ (Zn (II) TPy-SD), with molar ratio of 1:1, can be used as a simple, sensitive, and rapid means for the detection of pyrophosphates (PPi) in solution (water/DMSO = 99:1). As evidenced by transmission electron microscopy (TEM), dynamic light scattering (DLS) and fluorescence emission spectroscopy, this detection is thought to be due to the strong affinity between PPi and Zn²⁺, which brings out Zn²⁺ from the coordination cavity of chemical sensor TPy-SD, thus realizing the detection and recognition of PPi. Therefore, the new AIE fluorescent probe can be used as a dual probe for the detection of cations and anions.

Heterocyclic Organic Compounds as a Fluorescent Chemosensor for Cell Imaging Applications: A Review

Fluorometric determination of different biologically, industrially, and environmentally important analytes is a powerful technique because this technique has excellent selectivity, high sensitivity, rapid photoluminescence response, low cost, applicability to bioimaging, and low detection limit. Fluorescence imaging is a powerful technique for screening different analytes in the living system. Heterocyclic organic compounds have been extensively used as a fluorescence chemosensor for the determination of different biologically important cations like Co2+, Zn2+, Cu2+, Hg2+, Ag+, Ni2+, Cr3+, Al3+, Pd2+, Fe3+ Pt2+, Mn2+, Sn2+, Pd2+, Au3+, Pd2+, Cd2+, Pb2+ and other ions in biological and environmental systems. These compounds also showed significant biological applications such as anti-cancer, anti-ulcerogenic, antifungal, anti-inflammatory, anti neuropathic, antihistaminic, antihypertensive, analgesic, antitubercular, antioxidant, antimalarial, antiparasitic, antiglycation, antiviral anti-obesity, and antibacterial potency. In this review, we summarize the heterocyclic organic compounds based on fluorescent chemosensors and their applications in bioimaging studies for the recognition of different biologically important metal ions.

Enantioselective Recognition of Lysine and Phenylalanine Using an Imidazole Salt-Type Fluorescent Probe Based on H8-BINOL

An imidazole bromide fluorescent probe (R)-1 based on chiral H₈-BINOL was synthesized with a high yield; it was found to have good enantioselective recognition of lysine and phenylalanine using fluorescence analysis. When L-lysine was recognized, the enantioselective fluorescence enhancement ratio was 2.7 (ef = I_L - I₀/I_D - I₀, ef = 2.7, 20 eq Lys); as the amount of L-Lys increased, a distinct red shift was observed (the wavelength varied by 55.6 nm, 0-100 eq L-Lys), whereas D-Lys had a minimal red shift. The generation of this red shift phenomenon was probably due to the ICT effect; the probe's intramolecular charge transfer was affected after (R)-1 bound to L-Lys, and this charge transfer was enhanced, leading to a red shift in fluorescence. In addition to the enantioselective recognition of lysine, phenylalanine was also recognized; the enantioselective fluorescence enhancement ratio was 5.1 (ef = I_L - I₀/I_D - I₀, ef = 5.1, 20 eq Phe).

Detection of Cd2+ in Aqueous Solution by the Fluorescent Probe of CdSe/CdS QDs Based on OFF–ON Mode

The detection of heavy metals in aqueous solutions has always attracted much attention from all over the world. A fluorescent probe of CdSe/CdS core-shell quantum dots (QDs) was designed to detect trace Cd²⁺ in aqueous solutions using the OFF–ON mode rapidly and efficiently, likely based on adsorption and desorption reactions between ethylenediaminetetraacetic acid disodium salt (EDTA) and CdSe/CdS QDs. In the OFF mode, the optical shielding function of EDTA results in fluorescence quenching owing to the strong adsorption ability of EDTA with Cd²⁺ on the sites of CdSe/CdS QDs surface. In the ON mode, the introduction of Cd²⁺ promotes the desorption of EDTA from the EDTA-CdSe/CdS QDs and restores the fluorescence intensity. There were two linear response ranges which were 0.1–20 µmol/L and 20–90 µmol/L for the EDTA-CdSe/CdS system to detect Cd²⁺. The detection limit was 6 nmol/L, and the standard deviation was below 4% for the detection of Cd²⁺ concentration in tap water.

A highly selective and sensitive "on-off" fluorescent probe for detecting cadmium ions and l-cysteine based on nitrogen and boron co-doped carbon quantum dots

Cadmium ions (Cd2+) have caused relatively serious pollution, threatening human health and ecosystems. l-Cysteine (l-Cys) is an essential amino acid in living organisms and concentration of l-Cys is closely related to some human diseases. In this work, we first introduced 2-amino-3-hydroxypyridine and sodium borohydride as the nitrogen source and boron source to fabricate boron and nitrogen co-doped carbon quantum dots (N,B-CQDs) with high fluorescence quantum yield (21.2%), which were synthesized through a simple, low-consumption and pollution-free one-pot hydrothermal method. The obtained N,B-CQDs are able to detect Cd2+ rapidly and sensitively through fluorescence enhancement, which may be ascribed to chelation enhanced fluorescence that is induced by the formation of the N,B-CQDs/Cd2+ complex. Simultaneously, N,B-CQDs can be used to detect l-cysteine because significant fluorescence quenching was observed when l-Cys was added into the N,B-CQDs/Cd2+ system. In the two fluorescence "turn-on" and "turn-off" processes, this fluorescent probe obtained a good linear relationship over Cd2+ concentration ranging from 2.5 µM to 22.5 µM with a detection limit of 0.45 µM, while the concentration of l-cysteine showed a linear relationship in the range of 2.5-17.5 µM with a detection limit of 0.28 µM. The sensor has been successfully used to detect Cd2+ and l-cysteine in real samples with satisfying results.

Recent progress in cadmium fluorescent and colorimetric probes

Cadmium is a heavy metal which exists widely in industrial and agricultural production and can induce a variety of diseases in organisms. Therefore, its detection is of great significance in the fields of biology, environment and medicine. Fluorescent probe has been a powerful tool for cadmium detection because of its convenience, sensitivity, and bioimaging capability. In this paper, we reviewed 98 literatures on cadmium fluorescent sensors reported from 2017 to 2021, classified them according to different fluorophores, elaborated the probe design, application characteristics and recognition mode, summarized and prospected the development of cadmium fluorescent and colorimetric probes. We hope to provide some help for researchers to design cadmium fluorescent probes with higher selectivity, sensitivity and practicability.

Cadmium is a heavy metal which exists widely in industrial and agricultural production and can induce a variety of diseases in organisms.