A proposed mechanism of contraction in which stepwise shortening is a basic feature

The descending limb of the force-sarcomere length relation of the frog revisited

1. We studied the descending limb of the force-sarcomere length relation in single frog muscle fibres using sarcomere isometric contractions. 2. Sarcomere length was measured simultaneously with two independent methods: a laser diffraction method and a segment length method that detects the distance between two markers attached to the surface of the fibre, about 800 microns apart. Both methods were used to keep sarcomeres at constant length during contraction. 3. Fibres were selected for low resting tension since it was known from previous experiments that for such fibres the force developed by fixed-end tetani is much higher than that predicted by the degree of filament overlap. 4. With fixed-end tetani, force decline with increase of sarcomere length was small between 2.0 and 3.0 microns. At a sarcomere length of 3.0 microns, force was about 90% of maximal. 5. With sarcomere isometric tetani, force was considerably lower than with fixed-end tetani. Force was maximal at about 2.1 microns and decreased to zero at about 3.6 microns. At intermediate lengths the descending limb was within 80 nm of the values predicted from filament overlap. 6. We investigated why force of fixed-end contractions was much higher than that generated by sarcomere isometric contractions. 7. During the force plateau of fixed-end tetani at sarcomere lengths longer than about 2.0-2.2 microns, sarcomeres in the fibres mid-region were not isometric, but instead stretched slowly. By measuring the force-velocity relation it was shown that this slow stretch elevates active force well beyond sarcomere isometric force. 8. Stretch of the central region was also observed during the tetanic force rise. This was shown to result in an increase of passive force that grew larger at longer sarcomere lengths. At about 3.6 microns the increase of passive force was similar to the total force generated by fixed-end contractions at this length. 9. Laser diffraction and segment length methods gave the same results, diminishing the chance that any systematic artifact underlies our findings. 10. While earlier experiments from this laboratory carried out on fibres held at constant length during contraction did not reveal a linear descending limb, the present results support the linear descending limb as a characteristic feature of isometrically contracting sarcomeres.

Effect of active pre-shortening on isometric and isotonic performance of single frog muscle fibres

1. We studied the effects of shortening history on isometric force and isotonic velocity in single intact frog fibres. Fibres were isometrically tetanized. When force reached a plateau, shortening was imposed, after which the fibre was held isometric again. Isometric force after shortening could then be compared with controls in which no shortening had taken place. 2. Sarcomere length was measured simultaneously with two independent methods: a laser-diffraction method and a segment-length method that detects the distance between two markers attached to the surface of the fibre, about 800 microns apart. 3. The fibre was mounted between two servomotors. One was used to impose the load clamp while the other cancelled the translation that occurred during this load clamp. Thus, translation of the segment under investigation could be minimized. 4. Initial experiments were performed at the fibre level. We found that active preshortening reduced isometric force considerably, thereby confirming earlier work of others. Force reductions as large as 70% were observed. 5. Under conditions in which there were large effects of shortening at the fibre level, we measured sarcomere length changes in the central region of the fibre. These sarcomeres shortened much less than the fibre's average. In fact, when the load was high, these sarcomeres lengthened while the fibre as a whole shortened. Thus, while the fibre-length signal implied that sarcomeres might have shortened to some intermediate length, in reality some sarcomeres were much longer, others much shorter. 6. Experiments performed at the sarcomere level revealed that isometric force was unaffected by previous sarcomere shortening provided the shortening occurred against either a low load or over a short distance. However, if the work done during shortening was high, force after previous shortening was less than if sarcomeres had remained at the final length throughout contraction. The correlation between the force deficit and the work done during shortening was statistically significant (P = 0.0001). 7. Interrupting the tetanus for 0.5-3.0 s did not reverse the effects of shortening on isometric force; at least 5-10 min of rest were required before force recovered completely. 8. Sarcomeres accelerated during the period of shortening under constant load, indicating that the sarcomeres became progressively stronger. However, the acceleration was less than that predicted from the force-velocity relation applicable at each of the sarcomere lengths transversed during shortening. 9. Velocity of shortening appeared to be much more sensitive to previous shortening than isometric force. 10. Results obtained with the diffraction method were the same as those obtained with the segment method.(ABSTRACT TRUNCATED AT 400 WORDS)

Stepwise shortening of muscle fibre segments

Shortening dynamics were measured in single fibres of frog skeletal muscle using a system that could track the spacing between hairs mounted on the fibre surface. Segment length changes were predominantly stepwise. The objective of the study was to identify potential artifacts and check their relevance. Several possible causes of artifactual steps were evaluated quantitatively and ruled out. In addition, the surface marker method and an independent length-detection method based on light diffraction were used simultaneously. The concurrence of results confirmed that it is highly unlikely that stepwise shortening could arise out of instrument artifact. Possible mechanisms underlying the phenomenon are considered.

Bridgelike interconnections between thick filaments in stretched skeletal muscle fibers observed by the freeze-fracture method

The ultrastructure of frog semitendinosus muscle was explored using the freeze-fracture, deep-etch, rotary-shadowing technique. Mechanically skinned fibers were stretched to decrease or eliminate the overlap of thick and thin filaments before rapid freezing with liquid propane. In relaxed, contracting, and rigor fibers, a significant number of bridgelike interconnections, distinct from those observed in the M-region, were observed between adjacent thick filaments in the non-overlap region. Their half-length and diameter corresponded approximately to the known dimensions of the cross-bridge (or myosin S-1). The interconnection may thus be formed by the binding of two apposed cross-bridges projecting from adjacent thick filaments. Fixation with 0.5% glutaraldehyde for 5-10 min before freezing effectively preserved these structures. The results indicate that the interconnections are genuine structures that appear commonly in stretched muscle fibers. They may play a role in stabilizing the thick filament lattice, and possibly in the contractile process.