HPLC-AAS hybrid technique for studying the speciation of trace metals (Al, Fe, Si, Hg) in biological fluids: A review of applications, recent experiences and perspectives

Simultaneous liquid chromatographic determination of metals and organic compounds in pharmaceutical and food-supplement formulations using evaporative light scattering detection

A novel method for the non-derivatization liquid chromatographic determination of metals (potassium, aluminium, calcium and magnesium) and organic compounds (ascorbate and aspartate) was developed and validated based on evaporative light scattering detection (ELSD). Separation of calcium, magnesium and aluminium was achieved by the cation exchange column Dionex CS-14 and an aqueous TFA mobile phase according to the following time program: 0-6 min TFA 0.96 mL L(-1), 6-7 min linear gradient from TFA 0.96-6.4 mL L(-1). Separation of potassium, magnesium and aspartate was achieved by the lipophilic C18 Waters Spherisorb column and isocratic aqueous 0.2 mL L(-1) TFA mobile phase. Separation of sodium, magnesium, ascorbate and citrate was also achieved by the C18 analytical column, according to the following elution program: 0-2.5 min aqueous nonafluoropentanoic acid (NFPA) 0.5 mL L(-1); 2.5-3.5 min linear gradient from 0.5 mL L(-1) NFPA to 1.0 mL L(-1) TFA. In all cases, evaporation temperature was 70 degrees C, pressure of the nebulizing gas (nitrogen) 3.5 bar, gain 11 and the flow rate 1.0 mL min(-1). Resolution among calcium and magnesium was 1.8, while for all other separations was > or = 3.2. Double logarithmic calibration curves were obtained within various ranges from 3-24 to 34-132 microg mL(-1), and with good correlation (r>0.996). Asymmetry factor ranged from 0.9 to 1.9 and limit of detection from 1.3 (magnesium) to 17 microg mL(-1) (ascorbate). The developed method was applied for the assay of potassium, magnesium, calcium, aluminium, aspartate and ascorbate in pharmaceuticals and food-supplements. The accuracy of the method was evaluated using spiked samples (%recovery 95-105%, %R.S.D. < 2) and the absence of constant or proportional errors was confirmed by dilution experiments.

Competition between transferrin and the serum ligands citrate and phosphate for the binding of aluminum

A key issue regarding the speciation of Al(3+) in serum is how well the ligands citric acid and phosphate can compete with the iron transport protein serum transferrin for the aluminum. Previous studies have attempted to measure binding constants for each ligand separately, but experimental problems make it very difficult to obtain stability constants with the accuracy required to make a meaningful comparison between these ligands. In this study, effective binding constants for Al-citrate and Al-phosphate at pH 7.4 have been determined using difference UV spectroscopy to monitor the direct competition between these ligands and transferrin. The analysis of this competition equilibrium also includes the binding of citrate and phosphate as anions to apotransferrin. The effective binding constants are 10(11.59) for the 1:1 Al-citrate complexes and 10(14.90) for the 1:2 Al-citrate complexes. The effective binding constant for the 1:2 Al-phosphate complex is 10(12.02). No 1:1 Al-phosphate complex was detected. Speciation calculations based on these effective binding constants indicate that, at serum concentrations of citrate and phosphate, citrate will be the primary low-molecular-mass ligand for aluminum. Formal stability constants for the Al-citrate system have also been determined by potentiometric methods. This equilibrium system is quite complex, and information from both electrospray mass spectrometry and difference UV experiments has been used to select the best model for fitting the potentiometric data. The mass spectra contain peaks that have been assigned to complexes having aluminum:citrate stoichiometries of 1:1, 1:2, 2:2, 2:3, and 3:3. The difference UV results were used to determine the stability constant for Al(H(-1)cta)-, which was then used in the least-squares fitting of the potentiometric data to determine stability constants for Al(Hcta)+, Al(cta), Al(cta)2(3-), Al(H(-1)cta)(cta)(4-), Al2(H(-1)cta)2(2-), and Al3(H(-1)cta)3(OH)(4-).

A method for the quantitative analysis of iron speciation in meat by using a combination of spectrophotometric methods and high-performance liquid chromatography coupled to sector field inductively coupled plasma mass spectrometry

The determination of the heme and non-heme iron fractions in raw and cooked beef steak by using spectrophotometric methods and high-performance liquid chromatography coupled to a double-focusing sector field inductively coupled plasma mass spectrometer (HPLC-SF-ICPMS) is reported. Size exclusion chromatography coupled to SF-ICPMS was used to measure the iron-containing biomolecules in the samples. This approach allowed for the direct on-line detection of the most abundant iron isotope 56Fe without interference from 40Ar16O. The HPLC-ICPMS results for the iron speciation analysis of a raw beef steak, used as an analytical quality control (AQC) sample, showed that the main iron biomolecule present was the heme iron-containing protein myoglobin. For the AQC sample, the agreement among the HPLC-ICPMS method, the non-heme iron spectrophotometric method, and the total iron concentration showed 100% recovery of iron. The sum of the different iron-containing compounds determined using the developed HPLC-ICPMS method accounted for all the iron-containing compounds extracted. The analysis of myoglobin in steak by HPLC-ICPMS showed that on cooking the concentration was reduced by 85%. However, a spectrophotometric method specific for heme iron showed that it was still intact, even after heating to 80 degrees C. The measurement of the total iron in the cooked steak and the HPLC extracts by inductively coupled plasma optical emission spectroscopy (ICP-OES) indicated that the extraction method for the HPLC analysis was no longer applicable and that loss of the heme group from the protein rendered it incompatible with the size exclusion separation. The detection limit (concentration equivalent to 3 times the baseline for a blank injection) of the HPLC-ICPMS method was 2.4 ng as iron. The results demonstrate that a combination of analytical methods can be used to provide valuable information about dietary levels of nutritionally important metal-containing compounds as well as the efficiency of established extraction methods for raw and cooked meat samples.

Steric restrictions on the binding of large metal ions to serum transferrin

Apotransferrin in 0.1 M N-(2-hydroxyethyl)piperazine-N'-2-ethanesulfonic acid at 25 degrees C and pH 7.4 was titrated with acidic solutions of Lu3+, Tb3+, and Eu3+. Metal binding at the two specific metal-binding sites of transferrin was followed from changes in the difference UV spectra at 245 nm. The binding of Tb3+ was also followed from changes in the fluorescence emission spectrum at 549 nm. Apotransferrin was titrated with solutions containing varying ratios of the metal ion and the competitive chelating agent nitrilotriacetic acid, and metal-transferrin binding constants were calculated by nonlinear least-squares fits of the absorbance as a function of titrant added. The sequential carbonate-independent equilibrium constants for the binding of two metal ions are log KM1 = 11.08 and log KM2 = 7.93 for Lu3+, log KM1 = 11.20 and log KM2 = 7.61 for Tb3+, and log KM1 = 9.66 and log KM2 = 7.27 for Eu3+. Titrations of both C-terminal and N-terminal monoferric transferrins indicate that all of these metal ions bind more strongly to the C-terminal binding site. The trend in log K values as a function of the lanthanide ionic radius has been evaluated both by plots of log K versus the metal ion charge/radius ratio and by linear free-energy relationships in which binding constants for complexes of the larger lanthanides are plotted versus the binding constants for complexes with the smallest lanthanide, Lu3+. Both methods indicate that there is a sharp drop in the binding constants for the C-terminal binding site for metals larger than Tb3+. This decrease is attributed to a steric hindrance to the binding of the larger cations. The steric effect is not as strong for metal binding at the N-terminal site. As a result, the selectivity for binding to the C-terminal site, which is quite high for the smaller lanthanides, drops sharply on going from Tb3+ to Nd3+.

Flow injection analysis of mercury(II) in pharmaceuticals based on enzyme inhibition and biosensor detection

An enzymatic amperometric procedure for measurement of mercury(II) in pharmaceuticals, based on the inhibition of invertase and on a glucose electrode was studied. Analytical parameters for measurements in batch and flow injection analysis (FIA) have been optimised. Mercury(II) was detected in the 10-60 ppb range with RSD < or =2%. A sample throughput of 6 h(-1) for batch and 15 h(-1) for FIA was obtained. The total mercury(II) from thimerosal (thiomersal, sodium ethylmercurithiosalicylate) in eye-drop samples was measured with the amperometric procedure after oxidative cleavage treatment. Results for both batch and FIA procedures correlated well with atomic absorbtion spectroscopy (AAS) data.

Al and Si: their speciation, distribution, and toxicity

OBJECTIVES

In dialysis patients both aluminum (AI) and silicon (Si) may accumulate. Whereas the toxic effects of AI within this population are clearly established, little is known on the role of Si in the development/protection of particular dialysis-related diseases. A clear insight in the protein binding and speciation of trace elements is important to better understand the mechanisms underlying their toxicity/essentiality. Research in this field however is complex and often prone to analytical difficulties and inaccuracies.

DESIGN AND METHODS

In the first part of this review techniques used for speciation studies of AI and Si in biological fluids are discussed. Notwithstanding recent technical advances (a) extraneous metal contamination, (b) unrecognized aspecific binding of metals to proteins, and (c) unwanted interactions with separation equipment such as chromatography columns and ultrafiltration membranes remain important pitfalls and often lead to erroneous conclusions. The factors that determine the speciation of AI and Si and their ultimate tissue distribution and toxicity are dealt with in the second part. Here, experimental data obtained with various speciation techniques are linked to in vivo data on the tissue distribution, localization/toxicity of both elements.

CONCLUSIONS

A model in which the AI tissue distribution/toxicity is mediated by either its citrate or transferrin bound form is proposed.

Chromatographic and hyphenated methods for elemental speciation analysis in environmental media

This review discusses chromatographic techniques that permit the analysis of speciated metals in the environment using conventional detectors, such as UV, and element-specific detectors, such as flame atomic absorption spectrometry, electrothermal atomic absorption spectrometry and inductively coupled plasma mass spectrometry. The importance of determining precise elemental forms in hazardous waste-contaminated soil, water and biota in terms of toxicity is outlined. Previous reviews on this subject are described and recent research on this subject is discussed. Most of the work cited has been performed in the 1990s and a table summarizing the chromatographic method and the detector system used, including brief comments on the work, is included to enable quick reference.