Effect of killer toxin K1 on yeast membrane potential reported by the diS-C3(3) probe reflects strain- and physiological state-dependent variations

Impact of the growth phase on the activity of multidrug resistance pumps and membrane potential of S. cerevisiae: effect of pump overproduction and carbon source

The potentiometric fluorescence probe diS-C3(3) is expelled from S. cerevisiae by ABC pumps Pdr5 and Snq2 and can conveniently be used for studying their performance. The activity of these pumps in a strain with wild-type PDR1 allele was shown to drop sharply on glucose depletion from the medium and then again at the end of the diauxic shift when the cells are adapted to growth on respiratory substrates. The presence of the PDR1-3 allele causing pump overproduction prevented this second drop and the pump activity typical for diauxic cells was largely retained. Growth phase-dependent changes of membrane potential measured by the same probe in pump-free mutants included a Deltapsi drop in the late exponential and diauxic growth phase, indicating lowered activity of H+ -ATPase. Suppression of activity of both ABC pumps and H+ -ATPase obviously signifies cell transition to an energy-saving mode. Challenging respiration-adapted cells with glucose showed a novel feature of yeast ABC pumps--a strong dependence of pump activity on the type of the carbon source.

Effect of biocides on S. cerevisiae: relationship between short-term membrane affliction and long-term cell killing

The long-term action of recommended (RC) and near-recommended concentrations of several commercial biocides (Lonzabac 12.100, Genamin CS302D, benzalkonium chloride and 2-phenoxyethanol) on cells of S. cerevisiae wild-type strain DTXII was described using plating tests while short-term effects were determined using the potentiometric fluorescent probe diS-C3(3) that detects both changes in membrane potential and impairment of membrane integrity. A 2-d plating of cells exposed to 0.5xRC of benzalkonium chloride and Genamin CS302D for 15 min showed a complete long-term cell killing, with 2-phenoxyethanol the killing was complete only at 2xRC and Lonzabac caused complete killing at RC but not at 0.5xRC. The diS-C3(3) fluorescence assay performed immediately after a 10-min biocide exposure revealed several concentration-dependent modes of action: Lonzabac at 0.5xRC caused a mere depolarization, higher concentrations causing gradually increasing cell damage; benzalkonium chloride and Genamin CS302D rapidly damaged the membrane of some cells and depolarized the rest whereas 2-phenoxyethanol, which had the lowest effect in the plating test, produced a concentration-dependent fraction of cells with impaired membranes. Cell staining slightly increased during the diS-C3(3) assay; addition of a protonophore showed that part of the remaining undamaged cells retained their membrane potential. Comparison of short-term and long-term data implies that membrane depolarization alone is not sufficient for complete long-term killing of yeast cells under the action of a biocide unless it is accompanied by perceptible impairment of membrane integrity. The results show that the diS-C3(3) fluorescence assay, which reflects the short-term effects of a biocide on cell membranes, can be successfully used to assess the microbicidal efficiency of biocides.

Use of synchronously excited fluorescence to assess the accumulation of membrane potential probes in yeast cells

Evaluation of emission spectra of fluorescent probes used for the monitoring of membrane potential in microbial cells can be greatly facilitated by using synchronously excited spectroscopy (SES). This method permits the suppression of undesirable spectrum components (contributions due to scattered light or cell autofluorescence) and leads to considerable increase in monitored emission intensity and to narrowing of spectral peaks. It allows an efficient fractional decomposition of the probe fluorescence spectra into their free and bound dye fluorescence components. The usefulness of the method was tested by monitoring the accumulation of the fluorescent membrane potential probe diS-C3(3) in yeast cells, which serves as a qualitative measure of the membrane potential.

Susceptibility of individual cells of Saccharomyces cerevisiae to the killer toxin K1

The susceptibility of sensitive yeast to killer toxins is known to depend on various factors, such as the selected killer toxin, the exposed yeast strain, its growth phase and the state of culture under given experimental conditions. The aim of this paper was to find whether individual cells from one culture are equally susceptible to the impact of the killer toxin. For this purpose the rhodamine B assay in a modified form was used. In order to observe the fate of individual cell the method of fluorescence video microscopy with a digital picture analysis was applied. Four selected groups of specific cells (with no, small, medium, and large bud, respectively) were investigated. Different sensitivity of Saccharomyces cerevisiae cells to the killer toxin K1 was observed in these cell groups. The most susceptible appeared to be the cells which were in S-phase (cells with the small buds); the least susceptible were the M-phase cells with large buds. The enhanced susceptibility in S-phase results probably from coincidence in higher porosity of the cell wall, accumulation of surface receptors, and enlarged growth activity at the surface cell structures.

Factors underlying membrane potential-dependent and -independent fluorescence responses of potentiometric dyes in stressed cells: diS-C(3)(3) in yeast

The redistribution fluorescent dye diS-C(3)(3) responds to yeast plasma membrane depolarisation or hyperpolarisation by Delta psi-dependent outflow from or uptake into the cells, reflected in changes in the fluorescence maximum lambda(max) and fluorescence intensity. Upon membrane permeabilisation the dye redistributes between the cell and the medium in a purely concentration-dependent manner, which gives rise to Delta psi-independent fluorescence responses that may mimic Delta psi-dependent blue or red shift in lambda(max). These lambda(max) shifts after cell permeabilisation depend on probe and ion concentrations inside and outside the cells at the moment of permeabilisation and reflect (a) permeabilisation-induced Delta psi collapse, (b) changing probe binding capacity of cell constituents (inverse to the ambient ionic strength) and (c) hampering of probe equilibration by the poorly permeable cell wall. At low external ion concentrations, cell permeabilisation causes ion outflow and probe influx (hyperpolarisation-like red shift in lambda(max)) caused by an increase in the probe-binding capacity of the cell interior and, in the case of heat shock, protein denaturation unmasking additional probe-binding sites. At high external ion levels minimising net ion efflux and at high intracellular probe concentrations at the moment of permeabilisation, the Delta psi collapse causes a blue lambda(max) shift mimicking an apparent depolarisation.