Development of a validated process for manual preparation of dental transmission instruments

High-Speed Dental Instruments: An Investigation of Protein-Contaminated Dental Handpieces with the Bicinchoninic Acid Assay in Dental Offices in Styria, Austria

Due to permanent contact with bodily secretions such as blood and saliva, the dental workplace poses a high risk of infection for patients as well as for personnel. High-speed dental instruments are still considered one of the major hygienic risks, as the high-speed rotation of the attachments leads to the retraction of infectious material from patients' oral cavities. The aim of this study was to investigate the extent to which dental handpieces are contaminated after use. Spray-water samples were taken from different handpieces used in seven dental offices and protein concentrations were measured photometrically. In the first part of the study, samples were collected from each handpiece before and after the treatment of the patients. Additionally, the changes in protein concentration after consecutive treatments in which the same high-speed dental instrument was used were investigated. The results demonstrated measurable protein concentrations in 91.2% of a total of 398 samples, and 96.4% of the spray-water samples taken after treatment showed a discrepancy from the initial measured protein concentration. In 68.4% an increase in protein concentration was observed, whereas in 27.9% a decrease was measured. In conclusion, the internal contamination of high-speed dental instruments frequently occurs in daily usage and consequently may lead to the transmission of infectious agents by flushing the contaminated water out of the spray water tubes. Moreover, it must be pointed out that internal cleansing of handpieces is insufficient and that a final mechanical disinfection is indispensable.

Alternative Methods of Sterilization in Dental Practices Against COVID-19

SARS-CoV-2, and several other microorganisms, may be present in nasopharyngeal and salivary secretions in patients treated in dental practices, so an appropriate clinical behavior is required in order to avoid the dangerous spread of infections. COVID-19 could also be spread when patients touches a contaminated surface with infected droplets and then touch their nose, mouth, or eyes. It is time to consider a dental practice quite similar to a hospital surgery room, where particular attention should be addressed to problems related to the spreading of infections due to air and surface contamination. The effectiveness of conventional cleaning and disinfection procedures may be limited by several factors; first of all, human operator dependence seems to be the weak aspect of all procedures. The improvement of these conventional methods requires the modification of human behavior, which is difficult to achieve and sustain. As alternative sterilization methods, there are some that do not depend on the operator, because they are based on devices that perform the entire procedure on their own, with minimal human intervention. In conclusion, continued efforts to improve the traditional manual disinfection of surfaces are needed, so dentists should consider combining the use of proper disinfectants and no-touch decontamination technologies to improve sterilization procedures.