Influence of thermodisinfection and duration of cryopreservation at different temperatures on pull out strength of cancellous bone

Freezing does not influence the microarchitectural parameters of the microstructure of the freshly harvested femoral head bone

The femoral head is one of the most commonly used bones for allografts and biomechanical studies. However, there are few reports on the trabecular bone microarchitectural parameters of freshly harvested trabecular bones. To our knowledge, this is the first study to characterize the microstructure of femoral heads tested immediately after surgery and compare it with the microstructure obtained with conventional freezing. This study aims to investigate whether freezing at -80 °C for 6 weeks affects the trabecular microstructure of freshly harvested bone tissue. This study was divided into two groups: one with freshly harvested human femoral heads and the other with the same human femoral heads frozen at -80 °C for 6 weeks. Each femoral head was scanned using an X-ray microcomputed tomography scanner (µCT) to obtain the microarchitectural parameters, including the bone volume fraction (BV/TV), the mean trabecular thickness (Tb.th), the trabecular separation (Tb.sp), the degree of anisotropy (DA), and the connectivity density (Conn.D). There was no statistically significant difference between the fresh and the frozen groups for any of the parameters measured. This study shows that freezing at -80 °C for 6 weeks does not alter bone microstructure compared with freshly harvested femoral heads tested immediately after surgery.

Evaluation of ethylene oxide, gamma radiation, dry heat and autoclave sterilization processes on extracellular matrix of biomaterial dental scaffolds

Scaffolds used to receive stem cells are a promising perspective of tissue regeneration research, and one of the most effective solutions to rebuild organs. In the near future will be possible to reconstruct a natural tooth using stems cells, but to avoid an immune-defensive response, sterilize the scaffold is not only desired, but also essential to be successful. A study confirmed stem cells extracted from rat's natural teeth, and implanted into the alveolar bone, could differentiate themselves in dental cells, but the scaffold's chemistry, geometry, density, morphology, adherence, biocompatibility and mechanical properties remained an issue. This study intended to produce a completely sterilized dental scaffold with preserved extracellular matrix. Fifty-one samples were collected, kept in formaldehyde, submitted to partial demineralization and decellularization processes and sterilized using four different methods: dry heating; autoclave; ethylene-oxide and gamma-radiation. They were characterized through optical images, micro-hardness, XRD, EDS, XRF, SEM, histology and sterility test. The results evidenced the four sterilization methods were fully effective with preservation of ECM molecular arrangements, variation on chemical composition (proportion of Ca/P) was compatible with Ca/P proportional variation between enamel and dentine regions. Gamma irradiation and ethylene oxide presents excellent results, but their viability are compromised by the costs and technology's accessibility (requires very expensive equipment and/or consumables). Excepted gamma irradiation, all the sterilization methods more than sterilizing also reduced the remaining pulp. Autoclave presents easy equipment accessibility, lower cost consumables, higher reduction of remaining pulp and complete sterilization, reason why was considered the most promising technique.

Algorithms for the Testing of Tissue Donors for Human Immunodeficiency Virus, Hepatitis B Virus, and Hepatitis C Virus

Background

Although transmission of pathogenic viruses through human tissue grafts is rare, it is still one of the most serious dreaded risks of transplantation. Therefore, in addition to the detailed medical and social history, a comprehensive serologic and molecular screening of the tissue donors for relevant viral markers for human immunodeficiency virus (HIV), hepatitis B virus (HBV), and hepatitis C virus (HCV) is necessary. In the case of reactive results in particular, clear decisions regarding follow-up testing and the criteria for tissue release must be made.

Methods

Based on the clinical relevance of the specific virus markers, the sensitivity of the serological and molecular biological methods used and the application of inactivation methods, algorithms for tissue release are suggested.

Results

Compliance with the preanalytical requirements and assessment of a possible hemodilution are mandatory requirements before testing the blood samples. While HIV testing follows defined algorithms, the procedures for HBV and HCV diagnostics are under discussion. Screening and decisions for HBV are often not as simple, e.g., due to cases of occult HBV infection, false-positive anti-HBc results, or early window period positive HBV NAT results. In the case of HCV diagnostics, modern therapies with direct-acting antivirals, which are often associated with successful treatment of the infection, should be included in the decision.

Conclusion

In HBV and HCV testing, a high-sensitivity virus genome test should play a central role in diagnostics, especially in the case of equivocal serology, and it should be the basis for the decision to release the tissue. The proposed test algorithms and decisions are also based on current European recommendations and standards for safety and quality assurance in tissue and cell banking.

Influence of thermodisinfection on microstructure of human femoral heads: duration of heat exposition and compressive strength

Allogeneic bone derived from living donors being necessary to match demand for bone transplantation and thermodisinfection of femoral heads is an established sterilization method. During the thermodisinfection the peripheral bone is exposed to maximum 86 °C for 94 min providing 82.5 °C within the center of the femoral head for at least 15 min. This study examined the compression force of the central and representative peripheral regions of native and thermodisinfected human femoral heads to observe wether different duration and intensity of heat exposure might alter mechanic behaviour. Slices from the equatorial region of human femoral heads were taken from each 14 native and thermodisinfected human femoral heads. The central area revealed a significantly higher compression force for native (p ≤ 0.001) and for thermodisinfected bone (p = 0.002 and p = 0.005) compared with peripheral regions since no relevant differences were found between the peripheral and intermediate areas themselves. A small reduction of compression force for thermodisinfected bone was shown since this did not appear significant due to the small number of specimens. The heat exposure did not alter the pre-existing anatomical changes of the microarchitecture of the native femoral heads from the center towards the peripheral regions. The heterogeneity of microstructure of the femoral head might be of interest concerning clinical applications of bone grafts since the difference between native and thermodisinfected bone appears moderate as shown previously. The different quantity of heat exposure did not reveal any significant influence on compression force which might enable thermodisinfection of preformed bone pieces for surgical indications.

[Influence of thermodisinfection on impaction of cancellous bone : An in vitro model of femoral impaction bone grafting]

BACKGROUND

The reconstruction of bony defects during endoprosthesis revision surgery using "impaction bone grafting" leads to the possibility of a longstanding osseous integration to achieve good clinical results. Native allogeneic cancellous bone is often used for the procedure. This study examines the influence of thermodisinfection on the impaction behaviour of cancellous bone of different geometries and on the cement distribution.

METHODS

The cancellous bone was obtained from the femoral heads of 7‑month old pigs. One half of the head was thermodisinfected while the other remained native. Bone chips with sizes of 3-5, 5-8 and 8-10 mm were produced. The impaction was performed in a cylinder model with an internal diameter of 30 mm and with standardized impaction force using an impactor with a weight of 1450 g. The best particle combination was used for the subsequent computer tomography examination of the cement distribution and the contact surface to the bone in different parts of the shaft in seven investigations. For statistic measurements two-dimensional variance analysis including repetitions of measurement and Bonferroni correction, the LSD post-hoc-zest and the Mann Whitney U Test were used. The error probability was set at α = 5%. The SPSS® for Windows software was used for the statistical analysis.

RESULTS

The distribution of the cancellous and compacted bone also along the shaft revealed no significant difference between thermodisinfected and native cancellous bone at different levels (p > 0.05). Impacted native cancellous bone showed less inclusion of air, which resulted in a better distribution of density compared with thermodisinfected bone overall (p < 0.001). In the distal shaft area the cement volume was significantly larger in conjunction with the native bone. The overall area of cement penetration appeared to be significantly larger for native cancellous bone (p < 0.001).

CONCLUSIONS

The impaction of thermodisinfected and native cancellous bone showed greater deformation of the processed bone without any significant difference in the maximum density reached at different levels. Cement volume and cement penetration were pronounced proximally in native and processed cancellous bone. The cement distribution was significantly more distal for the native bone. Distally, the stabilization of the shaft appears to be increasingly dependent on the density of the impacted spongiosa, while proximally, the penetration of the cement into cancellous bone seems to correlate with porosity.

Effect of thermodisinfection on mechanic parameters of cancellous bone

Revision surgery of joint replacements is increasing and raises the demand for allograft bone since restoration of bone stock is crucial for longevity of implants. Proceedings of bone grafts influence the biological and mechanic properties differently. This study examines the effect of thermodisinfection on mechanic properties of cancellous bone. Bone cylinders from both femoral heads with length 45 mm were taken from twenty-three 6-8 months-old piglets, thermodisinfected at 82.5 °C according to bone bank guidelines and control remained native. The specimens were stored at -20 °C immediately and were put into 21 °C Ringer's solution for 3 h before testing. Shear and pressure modulus were tested since three point bending force was examined until destruction. Statistical analysis was done with non-parametric Wilcoxon, t test and SPSS since p < 0.05 was significant. Shear modulus was significantly reduced by thermodisinfection to 1.02 ± 0.31 GPa from 1.28 ± 0.68 GPa for unprocessed cancellous bone (p = 0.029) since thermodisinfection reduced pressure modulus not significantly from 6.30 ± 4.72 GPa for native specimens to 4.97 ± 2.23 GPa and maximum bending force was 270.03 ± 116.68 N for native and 228.80 ± 70.49 N for thermodisinfected cancellous bone. Shear and pressure modulus were reduced by thermodisinfection around 20 % and maximum bending force was impaired by about 15 % compared with native cancellous bone since only the reduction of shear modulus reached significance. The results suggest that thermodisinfection similarly affects different mechanic properties of cancellous bone and the reduction of mechanic properties should not relevantly impair clinical use of thermodisinfected cancellous bone.

Radiation sterilization of tissue allografts: A review

Tissue substitutes are required in a number of clinical conditions for treatment of injured and diseased tissues. Tissues like bone, skin, amniotic membrane and soft tissues obtained from human donor can be used for repair or reconstruction of the injured part of the body. Allograft tissues from human donor provide an excellent alternative to autografts. However, major concern with the use of allografts is the risk of infectious disease transmission. Therefore, tissue allografts should be sterilized to make them safe for clinical use. Gamma radiation has several advantages and is the most suitable method for sterilization of biological tissues. This review summarizes the use of gamma irradiation technology as an effective method for sterilization of biological tissues and ensuring safety of tissue allografts.