Spatial distribution, sources and quantitative human health risk assessments of polycyclic aromatic hydrocarbons in urban and suburban soils of Chile

Polycyclic aromatic hydrocarbons in sewage-irrigated vegetables from industrial cities in Haryana, India

The majority of Indians consume a lot of vegetables because of their health advantages. High concentrations of polycyclic aromatic hydrocarbons (PAHs) in vegetables may be seriously harmful to consumers' health. The method for identifying and measuring 16 USEPA polycyclic aromatic hydrocarbons (PAHs) in samples of sewage-irrigated vegetables from three industrial cities in Haryana, India, is described in this research. Ultrasonication, liquid-liquid extraction using n-hexane as a solvent, clean-up using a Florisil column, and reversed-phase high-performance liquid chromatography with a UV detector were all included in the process. The PAHs were successfully linearized (R2 > 0.99) at various doses. Results for PAH recovery ranged from 90 to about 100%. The limit of quantification was 0.002-0.580, and the limit of detection was 0.0006-0.174 µgkg-1. Data indicated that the highest mean concentrations of ∑16 PAHs were detected in Spinach (123.36 µgkg-1), in carrot (105.09 µgkg-1), and in cucumber (63.40 µgkg-1) among leafy, underground, and fruity vegetables, respectively.

Source characteristics of polycyclic aromatic hydrocarbons and polychlorinated biphenyls in surface soils of Shenyang, China: A comparison of two receptor models combined with Monte Carlo simulation

The surface soil concentrations of 16 PAHs and 15 PCBs were simultaneously determined by gas chromatography-tandem mass spectrometry in 21 locations of urban areas of Shenyang. The average concentrations of PAHs and PCBs were 26.40 ± 34.68 mg/kg and 48.03 ± 27.47 μg/kg, respectively. Factor analysis with nonnegative constraints (FA-NNC) and absolute principal component score with multiple linear regression (APCS-MLR) model were used to explore and evaluate the sources of PAHs and PCBs in the study area. The results of FA-NNC showed that PAHs in soils were mainly from traffic emissions (49.64%), coal combustion (46.88%) and petrogenic source (3.49%). The PCBs in soils were mainly from commercial and high temperature combustion mixed sources (20.3%), combustion and industry emission mixed sources (21.1%), electrical equipment sources (22.2%) and traffic emission sources (36.4%). The results of APCS-MLR were consistent with those of FA-NNC. The uncertainty of FA-NNC and APCS-MLR model was analyzed by Monte Carlo simulation method. The results revealed the reliability of the two receptor models on source apportionment. The estimated carcinogenic risks indicated that the risks of PAHs in soils exceed the acceptable range (10-6-10-4), while the risks of PCBs were below the acceptable risk level of 10-6.

Ecological and health risk assessments of polycyclic aromatic hydrocarbons (PAHs) in soils around a petroleum refining plant in China: A quantitative method based on the improved hybrid model

Polycyclic aromatic hydrocarbons (PAHs) are extensively released into the environment by petroleum refining activities, predominantly affecting soil as a major reservoir. This study focuses on an active petroleum refinery in central China and employs a multi-faceted approach, combining geo-statistics, the absolute principal component-multiple linear regression model, and the Monte Carlo simulation, to comprehensively unravel the sources and risks associated with 12 PAHs. The analysis reveals a wide range of PAH concentrations, spanning from 60.23 to 1678.00 μg·kg-1, with an average of 278.91 μg·kg-1. Strikingly elevated PAH levels are primarily concentrated in construction and transportation lands, whereas woodland and grasslands exhibit lower PAH concentrations. In terms of ecological impact, the risk arising from oil-coal combustion significantly surpasses that linked to biomass combustion. meticulous assessments indicate negligible carcinogenic risks for both children and adults within the study area. An innovative hybrid model, which seamlessly integrates risk assessments with source identification, emerges as a pivotal advancement. This hybrid model not only quantifies PAH emission levels from refining activities but also effectively quantifies potential risks from distinct sources. Consequently, this study furnishes a robust theoretical foundation for strategizing PAH pollution risk mitigation. In essence, our research not only contributes a comprehensive understanding of PAH distribution around an active petroleum refinery but also introduces an advanced hybrid model, culminating in valuable insights for devising measures to curtail PAH-related environmental risks.

Lichens as bio-monitors of polycyclic aromatic hydrocarbons: Measuring the impact of features and traffic patterns

The role of road characteristics, including gradient and speed control devices, in influencing emission dynamics remains to be fully elucidated. Most studies have focused on fuel consumption as an indirect indicator of sector emissions instead of directly quantifying specific pollutants, like polycyclic aromatic hydrocarbons (PAHs). This research approach is often due to the complexities involved in capturing these pollutants and their subsequent analysis. Bio-monitors, such as lichens, offer an economically viable method. Their wide distribution across various habitats enables the comparison of PAH levels in diverse environments. Against this background, The present work analyses the ability of tropical lichens to indicate the effect that traffic patterns and geometric design features of roads (traffic activity, road gradient, traffic control devices, and vehicular speed) have on the emission of PAH concentration. Results showed that PAHs in lichens strongly correlated with the road gradient (Spearman correlation, p < 0.005 with R = 0.98 ). Each 1% increase in road gradient implies a rise of 24 ngPAH/gLichen in National Road. Additionally, a trend coherent of PAH concentration with the vehicle speed profile was observed on Panamericana Road. Speed control devices were associated with higher concentrations of PAHs due to acceleration and braking actions that increment fuel consumption. Finally, the results evidenced that lichens helped determine the source of aromatics and their carcinogenic potential using the diagnostic ratio of PAHs and the carcinogenic equivalence sum, respectively.

Emission profiles, source identifications, and health risk of polycyclic aromatic hydrocarbons (PAHs) in a road tunnel located in Xi'an, China

Understanding the sources and characteristics of PM2.5-bound PAHs from traffic-related pollution can provide valuable data for mitigating air contamination from traffic in local urban regions. However, little information on PAHs is available regarding the typical arterial highway-Qinling Mountains No.1 tunnel in Xi'an. We estimated the profiles, sources, and emission factors of PM2.5-bound PAHs in this tunnel. The total PAH concentrations were 22.78 ng·m-3 and 52.80 ng·m-3 at the tunnel middle and exit, which were 1.09 and 3.84 times higher than that at the tunnel entrance. Pyr, Flt, Phe, Chr, BaP, and BbF were the dominant PAH species (representing approximately 78.01% of total PAHs). The four rings PAHs were dominant (58%) among the total PAH concentrations in PM2.5. The results demonstrated that diesel and gasoline vehicles exhaust emissions contributed 56.81% and 22.60% to the PAHs, respectively, while the corresponding value for together brakes, tyre wear, and road dust was 20.59%. The emission factors of total PAHs were 29.35 μg·veh-1·km-1, and emission factors of 4 rings PAHs were significantly higher than those of the other PAHs. The sum of ILCR was estimated to be 1.41×10-4, which accorded with acceptable level of cancer risk (10-6-10-4), PAHs should not ignored as they still affect the public health of inhabitants. This study shed light on PAH profiles and traffic-related sources in the tunnel, thereby facilitating the assessment of control measures targeting PAHs in local areas.

Distribution and Relationships of Polycyclic Aromatic Hydrocarbons (PAHs) in Soils and Plants near Major Lakes in Eastern China

The distributions and correlations among polycyclic aromatic hydrocarbons (PAHs) in soils and plants were analyzed. In this study, 9 soil samples and 44 plant samples were collected near major lakes (Hongze Lake, Luoma Lake, Chaohu, Changhu, Danjiangkou Reservoir, Wuhan East Lake, Longgan Lake, Qiandao Lake and Liangzi Lake) in eastern China. The following results were obtained: The total contents of PAHs in soil varied from 99.17 to 552.10 ng/g with an average of 190.35 ng/g, and the total contents of PAHs in plants varied from 122.93 to 743.44 ng/g, with an average of 274.66 ng/g. The PAHs in soil were dominated by medium- and low-molecular-weight PAHs, while the PAHs in plants were dominated by low-molecular-weight PAHs. The proportion of high-molecular-weight PAHs was the lowest in both soil and plants. Diagnostic ratios and principal component analysis (PCA) identified combustion as the main source of PAHs in soil and plants. The plant PAH monomer content was negatively correlated with Koa. Acenaphthylene, anthracene, benzo[k]fluoranthene, benzo[b]fluoranthene and dibenzo[a,h]anthracene were significantly correlated in plants and soil. In addition, no significant correlation between the total contents of the 16 PAHs and the content of high-, medium-, and low-molecular-weight PAHs in plants and soil was found. Bidens pilosa L. and Gaillardia pulchella Foug in the Compositae family and cron in the Poaceae family showed relatively stronger accumulation of PAHs, indicating their potential for phytoremediation.

Fingerprint analysis reveals sources of petroleum hydrocarbons in soils of different geographical oilfields of China and its ecological assessment

The distribution and characteristics of petroleum in three different geographic oilfields in China: Shengli Oilfield (SL), Nanyang Oilfield (NY), and Yanchang Oilfield (YC) were investigated. The average concentration of the total petroleum hydrocarbons (TPHs) conformed to be in the following law: SL Oilfield > NY Oilfield > YC Oilfield. Fingerprint analysis on the petroleum contamination level and source was conducted by the geochemical indices of n-alkanes and PAHs, such as low to high molecular weight (LMW/HMW) hydrocarbons, n-alkanes/pristine or phytane (C17/ Pr, C18/Ph), and ratio of anthracene/ (anthracene + phenanthrene) [Ant/(Ant + Phe)]. Soils adjacent to working well oils indicated new petroleum input with higher ratio of low to high molecular weight (LMW/HMW) hydrocarbons. The oil contamination occurred in the grassland soils might result of rainfall runoff. Petroleum source, petroleum combustion source, and biomass combustion were dominant PAHs origination of soils collected from oil exploitation area, petrochemical-related sites, farmland and grassland, respectively. The suggestive petroleum control strategies were proposed in each oilfield soils. Ecological potential risk of PAHs was assessed according to the toxic equivalent quantity (TEQ) of seven carcinogenic PAHs. The results showed that high, medium, and low ecological risk presented in petro-related area, grassland soils, and farmland soils, respectively. High ecological risk was persistent in abandoned oil well areas over abandoned time of 15 years, and basically stable after 5 years. This study can provide a critical insight to ecological risk management and source control of the petroleum contamination.

Levels, source appointment, and ecological risk of petroleum hydrocarbons in tropical coastal ecosystems (northeast Brazil): Baseline for future monitoring programmes of an oil spill area

We reviewed 20 years of levels, sources, and environmental risks related to the main petroleum hydrocarbons in the northeast region of Brazil. The aim of this study was to conduct a systematic review to serve as a comprehensive baseline for future monitoring programmes related to the oil spill disaster in 2019/2020. Most contamination levels of both PAHs and AHs were classified as low, except those in specific areas influenced by human activities, such as ports, highly urbanised mangroves, or rivers of medium-sized cities with inadequate liquid and solid waste treatment. Most hydrocarbons were linked to natural sources and burning processes, except in regions of extraction activities and petrochemical facilities as well as highly urbanised areas, where degraded petroleum and oil hydrocarbons predominated. Only 2.5% of the samples exceeded threshold effect levels for ∑_16-PAHs and no samples exceeded probable effect levels. When regional threshold levels were used, however, the probable effect for the ∑_16-PAHs measured was high, ranging from 5.8 to 6.1%. The few studies reporting biological responses showed that hydrocarbons from anthropogenic sources can induce adverse effects on marine organisms even at low to moderate levels. As the region has recently received a considerable quantity of crude oil, studies should be prioritised for a more precise assessment of the impact of this oil spill.