Effect of C content on the mechanical properties of solution treated as-cast ASTM F-75 alloys

In vivo corrosion and damages in modular shoulder prostheses

Wear and corrosion at taper junctions of orthopaedic endoprostheses remain of great concern and are associated with adverse clinical reactions. Whereas tribocorrosion of hip tapers was extensively investigated, there is only little knowledge regarding the clinical performance of modular total shoulder prostheses. This retrieval study evaluated 35 modular taper junctions of anatomical shoulder explants using stereomicroscopy, confocal microscopy, as well as optical and scanning electron microscopy to determine the damage modes as well as the effects of taper topography and alloy microstructure. Among all humeral head tapers, 89% exhibited material degradation. Different overlapping wear mechanisms were identified such as plastic deformation, adhesive material transfer, microploughing, and fretting damage. Only CoCrMo cast alloy heads showed a susceptibility to electrochemically dominated fretting in comparison to CoCrMo wrought alloy. Moreover, corundum blasted stem tapers show a significantly increased incidence rate for microploughing. To date, this is the most comprehensive study on the damage types of modular taper junctions of anatomical shoulder arthroplasty proving the existence of fretting even on less weight-bearing implants. This study revealed critical fretting factors, such as the surface finish and the alloy type that are essential for the development of countermeasures that avoid any taper corrosion.

Precipitates in Biomedical Co-Cr-Mo-C-Si-Mn Alloys

The phase and dissolution behavior of precipitates in biomedical ASTM F75 Co-Cr-Mo-C-Si-Mn alloys were investigated. Alloys of five different compositions, Co-28Cr-6Mo-0.25C-1Si, Co-28Cr-6Mo-0.25C-1Mn, Co-28Cr-6Mo-0.25C-1Si-1Mn, Co-28Cr-6Mo-0.15C-1Si, and Co-28Cr-6Mo-0.35C-1Si, were heat-treated from 1448 to 1548 K. The precipitates observed in the as-cast and heat-treated alloys were carbides (M23C6type, h-phase, and p-phase) and an intermetallic compound (c-phase). The main precipitates observed after heat treatment at high temperatures such as 1548 K were p-phase and M23C6type carbide. At these high temperatures, two types of starlike precipitates—dense and stripe-patterned—were observed. The starlike-dense precipitate was the p-phase, and the starlike precipitate with a stripe pattern was identified as the M23C6type carbide and metallic fcc g-phase. In the alloys heat-treated at 1448 to 1498 K, blocky-dense M23C6type carbide was primarily observed. c-phase was detected in the Co-28Cr-6Mo-0.15C-1Si alloy under as-cast condition and after heat treatment at 1448–1523 K for a short holding time. The addition of Si seemed to increase the holding time for complete precipitate dissolution because of the effects of Si on the promotion of p-phase formation at high temperatures and the increased carbon activity in the metallic matrix.