Halloysite nanotubes: an eco-friendly adsorbent for the adsorption of Th(IV)/U(VI) ions from aqueous solution

Polyaniline-modified halloysite nanotubes as high-efficiency adsorbents for removing of naproxen in the presence of different heavy metals

In this work, novel adsorbent polyaniline-modified halloysite nanotubes (HNT@PA-2) were synthesized successfully by in situ polymerization to increase active adsorption sites. With the increase of the amount of aniline, the adsorption capacity of naproxen becomes higher. The optimal ratio of halloysite nanotubes to aniline was 1 : 2. The effects of adsorption conditions such as pH, mass of HNT@PA-2, time and initial concentration of naproxen were systematically researched. The optimum adsorption for naproxen was pH 9, mass 10 mg and contact time 4 h. The adsorption of naproxen conformed to the pseudo-first-order kinetic model, and the maximum adsorption capacity was 242.58 mg g-1 at 318 K. In addition, the effects of ionic strength and different heavy metals also were studied. Higher ionic strength of the system could influence the adsorption of naproxen. The effects of Al3+, Pb2+, Zn2+ and Co2+ ions on the adsorption of naproxen could be ignored, while Cu2+ and Fe3+ ions inhibited the process. The mechanisms for naproxen adsorbed by the HNT@PA-2 were π-π interaction, hydrogen bonding and hydrophobic reaction. Therefore, the HNT@PA-2 could be used for the treatment of medical wastewater for removing naproxen.

Activation of persulfate by heterogeneous nano zero-valent iron/halloysite nanotubes: reaction behavior, mechanism, and implication for tetracycline hydrochloride degradation

A novel composite (nZVI/HNTs) was prepared via incorporating nano zero-valent iron (nZVI) on halloysite nanotubes (HNTs) for degrading tetracycline hydrochloride (TCH) with existence of persulfate (PS). The adsorption process of nZVI/HNTs to TCH conformed to the Freundlich isotherm model and pseudo-second-order kinetic model, and its maximum adsorption capacity was 76.62 mg·g-1. Furthermore, the nZVI/HNTs + PS system exhibited satisfactory degradation efficiency (84.21%) for TCH, and stable nZVI/HNTs (Fe leaching < 0.001 mg·L-1) could be reused. When nZVI/HNTs dosage, PS dosage and temperature increased, TCH degradation could be enhanced. After four cycling, nZVI/HNTs + PS system had still 65.8% degradation for TCH. The quenching tests and EPR analysis evidenced that SO4•- was predominant instead of •OH in such system. Three possible pathways of TCH degradation were provided through the liquid chromatograph-mass spectrometer (LC-MS) determination. Meanwhile, the biological toxicity prediction analysis indicated that the nZVI/HNTs + PS system would be an environment friendly treatment method toward TCH pollution.

Selective separation and purification of cerium (III) from concentrate liquor associated with monazite processing by cationic exchange resin as adsorbent

The present study is directed to find the optimal conditions required for efficient separation and purification of Ce3+ as an analog for lanthanides from Fe3+, Th4+, and Zr4+ (interfering ions) using Amberlite IR120H (AIR120H) resin as a strongly cationic exchange adsorbent. The main factors affecting the separation processes had been investigated and optimized. Ce3+ (Ln3+) as an admixture with Fe3+, Th4+, and Zr4+ was successfully separated by batch and column techniques. The sorption efficiency (S, %) from different acidic media was in this order: HCl > HNO3 > H2SO4. In a quaternary mixture with Fe3+ and Th4+, the maximum separation factor between Ce3+ and Zr4+ was ~ 13 after 90 min of equilibration, and the sorption capacity of AIR120H resin for Ce3+ was 8.2 mg/g. The rate of adsorption was found to follow a pseudo-second-order kinetic model. Separation of the absorbed ions was achieved by desorption processes. Firstly, 98 ± 2% of loaded Ce3+ is fully desorbed by 1 M sodium acetate solution without interfering ions. Moreover, ~ 95% of Zr4+ is desorbed by 1 M citric acid solution. Finally, 85% of loaded Fe3+ and Th4+ ions are desorbed with 8 M HCl solution. The batch technique was applied to separate and purify Ln3+-concentrate in chloride liquor (LnCl3), coming from the caustic digestion of Egyptian high-grade monazite. However, the enhanced radioactivity in LnCl3 due to radium -isotopes (228Ra2+, 226Ra2+, 224Ra2+, 223Ra2+) and radio-lead (210Pb2+) is initially reduced by a factor of 92% (i.e., safe limit) by pH-adjustment. As result, it can be recommended that the sorption process by AIR120H resin is efficient and promising for exploring pure lanthanides from its minerals.

Synthesis of thickness-controllable polydopamine modified halloysite nanotubes (HNTs@PDA) for uranium (VI) removal

Halloysite nanotubes (HNTs) are considered structurally promising adsorption materials, but their application is limited due to their poor native adsorption properties. Improving the adsorption capacity of HNTs for radioactive U(VI) is of great significance. By controlling the mass ratio of HNTs and dopamine (DA), composite adsorbents (HNTs@PDA) with different polydopamine (PDA) layer thicknesses were synthesized. Characterization of HNTs@PDA demonstrated that the original structure of the HNTs was maintained. Adsorption experiments verified that the adsorption capacity of HNTs@PDA for U(VI) was significantly improved. The effects of solution pH, temperature, and coexisting ions on the adsorption process were investigated. The removal efficiency was observed to be 75% after five repeated uses. The adsorption mechanism of U(VI) by HNTs@PDA can be explained by considering electrostatic interactions and the complexation of C-O, -NH- and C-N/CN in the PDA layer. This study provides some basic information for the application of HNTs for U(VI) removal.