Novel imaging method to quantify stratum corneum in dermatopharmacokinetic studies

An LC-MS Method for Determination of Betamethasone in Tissue Engineering Skin and Application to Dermatopharmacokinetic Study

Background and Objectives:

Tissue engineering skin is a three-dimensional skin substitute cultured in the gas-liquid interface using the immortalized keratinocytes (HaCaT cells). In this study, the preliminary metabolism of betamethasone dipropionate by tissue engineering skin was studied and the pharmacokinetics methodology was established using betamethasone dipropionate gel as the target drug.

Methods:

The betamethasone dipropionate gel was applied on the tissue engineering skin after the skin was cultured. Then the medium (receiving liquid) and skin were taken on 0.25, 0.75, 1.75, 3, 5, 8, 12, 24, 36, 48 h time points. The betamethasone concentration in the medium and skin was determinated by the LC-MS method. Chromatographic analysis was conducted using isocratic elution on a C18 column (150 mm × 2.0 mm, 5 µm) in mobile phase consisting of methanol and water (70 : 30, v/v). The mobile phase was pumped at a flow rate of 0.2 mL/min.

Results:

This method exhibited linearity within the concentration range of 0. 1 to 50 µg /mL of betamethasone. The LLOQ was 0. 1 µg /mL. The intra- and inter-day precisions of betamethasone in the blank medium were all less than 10.69 % (RSD, %), while in the blank, skin homogenates were all less than 13.96 % (RSD, %). As a result, the betamethasone concentration in the medium and skin could both be detected, which suggested that betamethasone dipropionate could be metabolized to betamethasone through the tissue engineering skin.

Conclusion:

It was feasible to use tissue engineering skin as a model to study the dermatopharmacokinetics of topical betamethasone dipropionate gel. The research could build a foundation for the dermato-pharmacokinetic study approach.

Sampling the stratum corneum for toxic chemicals

Dermal exposure is an important pathway in environmental health. Exposure comes from contaminated water, soil, treated surfaces, textiles, aerosolized chemicals, and agricultural products. It can occur in homes, schools, play areas, and work settings in the form of industrial sources, consumer products, or hazardous wastes. Dermal exposure is most likely to occur through contact with liquids, water, soil, sediment, and contaminated surfaces. The ability to detect and measure exposure to toxic materials on the skin is an important environmental health issue. The stratum corneum is the skin's first and principal barrier layer of protection from the outside world. It has a complex structure that can effectively protect against a wide variety of physical, chemical, and biological contaminants. However, there are a variety of chemical agents that can damage the stratum corneum and the underlying epidermis, dermis and subcutis, and/or enter systemic circulation through the skin. There are numerous ways of sampling the stratum corneum for these toxic materials like abrasion techniques, biopsy, suction blistering, imaging, washing, wipe sampling, tape stripping, and spot testing. Selecting a method likely depends on the particular needs of the situation. Hence, there is a need to review practical considerations for their use in sampling the stratum corneum for toxins.

In vivo methods for the analysis of the penetration of topically applied substances in and through the skin barrier

The efficacy of a drug is characterized by its action mechanism and its ability to pass the skin barrier. In this article, different methods are discussed, which permit this penetration process to be analysed non-invasively. Providing qualitative and quantitative information, tape stripping is one of the oldest procedures for penetration studies. Although single cell layers of corneocytes are removed from the skin surface, this procedure is considered as non-invasive and is applicable exclusively to the stratum corneum. Recently, optical and spectroscopic methods have been used to investigate the penetration process. Fluorescence-labelled drugs can be easily detected in the skin by laser scanning microscopy. This method has the disadvantage that the dye labelling changes the molecular structures of the drug and consequently might influence the penetration properties. The penetration process of non-fluorescent substances can be analysed by Raman spectroscopy, electron paramagnetic resonance, CARS and multiphoton microscopic measurements. Using these methods, the concentration of the topically applied formulations in different depths of the stratum corneum can be detected by moving the laser focus from the skin surface deeper into the stratum corneum. The advantages and disadvantages of these methods will be discussed in this article.

Novel imaging method to quantify stratum corneum in dermatopharmacokinetic studies: proof-of-concept with acyclovir formulations

PURPOSE

Tape-stripping the stratum corneum (SC) is used in the assessment of dermatopharmacokinetics (DPK). The amount of SC per tape can be determined gravimetrically, but a novel imaging method offers advantages in terms of sensitivity, reproducibility, precision, stability and speed. High-resolution images, acquired under controlled conditions, are analysed in terms of pixel greyscale values and distributions, and their usefulness in DPK studies is demonstrated in this study using acyclovir.

METHODS

At all tape-stripped sites, the SC amount per tape was measured gravimetrically and by imaging. In a first series of experiments, untreated sites were stripped to determine total SC thickness. Subsequently, post-application of two acyclovir creams, drug-permeation profiles were constructed.

RESULTS

The greyscale values from the imaging data can be used directly to estimate total SC thickness and DPK parameters. The results compared favourably with the traditional weighing method. The concentration of drug on each tape, as a function of the relative position within the SC, permitted diffusivity and partitioning parameters characterising the penetration of acyclovir to be derived.

CONCLUSION

The new imaging approach offers a sensitive, reproducible, precise, and rapid technique to quantify the relative SC amount removed on tape-strips, and facilitates the acquisition of DPK data.