Water reclamation during drinking water treatments using polyamide nanofiltration membranes on a pilot scale

Design of a new polyethersulfone nanofiltration membrane with anti-fouling properties using supported protic ionic liquid modification for dye/salt removal

Facile techniques to fabricate the nanofiltration membranes with ideal molecular sieving is one of the most interesting subjects in membrane separation technology. In this study, the application of modified graphene oxide (GO) with triethylenetetramine (TETA), CuFe₂ O₄ , and acetic acid (AC) (supported GO-TETA-CuFe₂ O₄ @AC) as a supported protic ionic liquid (PIL) modifier for polyethersulfone (PES) membrane was evaluated to approve the improvement of anti-fouling properties and wastewater rejection of the fabricated membranes. To enhance the key properties of graphene oxide, it was modified by hydrophilic nanomaterials (TETA-CuFe₂ O₄ ). High flux and promising flux recovery ratio (up to 95% compared to the unmodified membrane) can be observed in the modified membranes. The modified membranes by GO-TETA-CuFe₂ O₄ @AC were studied at optimum concentrations (0.5 wt.%) for salt rejection and different dyes. The obtained data indicated that the modified membranes by GO-TETA-CuFe₂ O₄ @AC indicated higher salt removal (up to 97% for BaCl₂ than the unmodified membrane), which was related to the efficient modification. The obtained pure water flux (PWF) for bare and optimal modified membrane from 13.11 to 27.87 kg/m² ·h, respectively. To exact evaluate the effect of membrane modification on performance examination, the modified membranes were evaluated for chlorine resistance testing. This study aimed to develop cost-effective nanofiltration (NF) membranes with high anti-fouling properties and to determine the maximum filtration capacity of in-time dyes and salts in effluents. PRACTITIONER POINTS: A GO-TETA-CuFe2O4 mixed matrix membrane was prepared for removal of salts and dyes. The effect of GO-TETA-CuFe2O4 enhanced the hydrophilicity and porosity. The membrane exhibited superior antifouling properties and ions rejection.

New Insights in factors affecting ground water quality with focus on health risk assessment and remediation techniques

Groundwater is considered as the primary source of water for the majority of the world's population. The preponderance of the nation's drinking water, as well as agricultural and industrial water, comes from groundwater. Groundwater level is becoming increasingly challenging to replenish due to climate change. Fertilizer application and improper processing of industrial waste are the two major anthropogenic drivers of groundwater pollution. Arsenic and cadmium are two of the principal heavy metal pollutants that have affected groundwater quality by human activity. When people are exposed to both non-carcinogenic and carcinogenic contaminants for an extended period, toxic effects might occur. It can have detrimental health effects from long-term exposure to contaminants, even in low amounts. As a result, metal contamination concentrations and fractions can be used to determine potential health concerns. At the same time, contaminants also need to be removed or converted to harmless products by groundwater remediation. Remediation of groundwater quality can be accomplished in several ways, including natural and artificial means. The purpose of this review is to explore a wide range of factors that affect groundwater quality, including their possible health effects. This communication provides state-of-the-art information about remediation approaches for groundwater contamination including hindrances and perspectives in this area of research. The in-depth information provided in different sections of this communication would expand the scope of interdisciplinary research.

Recent advances in thin film composites membranes for brackish groundwater treatment with critical focus on Saskatchewan water sources

Drinking water scarcity is an ever-increasing global concern. This issue appears as a greater threat to the countries with no access to sea water resources or rivers, since their potential water resources are only limited to ground waters only. There are serious concerns with the treatment of ground water resources, including landfill leachates, agricultural contaminations (pesticides, herbicides, and fertilizers), and rural contaminations. Membrane separation has been proved to be the governing technology in water and wastewater treatment plants, as these methods are responsible for more than half of the market share of the world's desalination capacity. This study intends to offer a holistic view of the groundwater contamination with specific focus on Saskatchewan province in Canada, and the recent efforts in the groundwater treatment using thin film composite membrane technology. This study begins with an introduction of the general aspects of ground water and membrane separation, polluting agents, and their sources. It is followed by a discussion of Saskatchewan's groundwater status and various issues. Furthermore, the recent research that became available since 2010 is reviewed in details and the results are summarized with respect to purification efficiency. Different affecting parameters in a groundwater-thin film composite system are synthesized and an in-depth overview is presented.

Study on the removal and transport and migration mechanism for As with activated sludge system

In this paper, the removal of As and the transport and migration of As at the process of activated sludge system was studied. The results showed that the activated sludge system has high removal efficiency for As, and the removal efficiency could be nearly 100%. The initial concentration of As has effect on the removal efficiency, and within the experimental scope, the increase of initial concentration of As improved the removal efficiency for As. The distribution of As in the surface and internal in activated sludge indicates that in the process of activated sludge, the As was first transferred from water to the surface of solid and was adsorbed by the surface and then transport to the interior of microbes and take part in some metabolisms of the microorganisms. The adsorption of As by activated sludge conforms to Freundlich adsorption isotherm, and the removal of As in activated sludge system follows to the pseudo second order reaction kinetics.

Technical feasibility study of a low-cost hybrid PAC-UF system for wastewater reclamation and reuse: a focus on feedwater production for low-pressure boilers

This study has applied the concept of the hybrid PAC-UF process in the treatment of the final effluent of the palm oil industry for reuse as feedwater for low-pressure boilers. In a bench-scale set-up, a low-cost empty fruit bunch-based powdered activated carbon (PAC) was employed for upstream adsorption of biotreated palm oil mill effluent (BPOME) with the process conditions: 60 g/L dose of PAC, 68 min of mixing time and 200 rpm of mixing speed, to reduce the feedwater strength, alleviate probable fouling of the membranes and thus improve the process flux (productivity). Three polyethersulfone ultrafiltration membranes of molecular weight cut-off (MWCO) of 1, 5 and 10 kDa were investigated in a cross-flow filtration mode, and under constant transmembrane pressures of 40, 80, and 120 kPa. The permeate qualities of the hybrid processes were evaluated, and it was found that the integrated process with the 1 kDa MWCO UF membrane yielded the best water quality that falls within the US EPA reuse standard for boiler-feed and cooling water. It was also observed that the permeate quality is fit for extended reuse as process water in the cement, petroleum and coal industries. In addition, the hybrid system's operation consumed 37.13 Wh m^-3 of energy at the highest applied pressure of 120 kPa, which is far lesser than the typical energy requirement range (0.8-1.0 kWh m^-3) for such wastewater reclamation.