Removal of sulfamethoxazole, sulfadiazine, and sulfamethazine by UV radiation and HO• and SO4•- radicals using a response surface model and DFT calculations

Utilizing sulfa drugs' pH-dependent spectral modifications for designing molecular logic gates

In this study, the absorption and fluorescence characteristics of sulfa drugs, specifically Sulfadiazine (SDZ), Sulfamerazine (SMZ), and Sulfamethazine (STZ), were examined across a pH range of 1-14. The absorption and fluorescence spectra of these sulfa drugs showed significant changes depending on the pH value. Analysis of their pH-dependent absorption and fluorescence properties indicated that these sulfa drugs could used to design molecular logic gates. The absorption and fluorescence behaviors at various wavelength maxima were utilized to design IMPLICATION and Improved-INHIBIT (I-INHIBIT) molecular logic gates.

Efficient removal of triclosan from water through activated carbon adsorption and photodegradation processes

This study investigated the application of adsorption with activated carbons (ACs) and photodegradation to reduce the concentration of triclosan (TCS) in aqueous solutions. Concerning adsorption, ACs (Darco, Norit, and F400) were characterised and batch experiments were performed to elucidate the effect of pH on equilibrium. The results showed that at pH = 7, the maximum adsorption capacity of TCS onto the ACs was 18.5 mg g-1 for Darco, 16.0 mg g-1 for Norit, and 15.5 mg g-1 for F400. The diffusional kinetic model allowed an adequate interpretation of the experimental data. The effective diffusivity varied and increased with the amount of TCS adsorbed, from 1.06 to 1.68 × 10-8 cm2 s-1. In the case of photodegradation, it was possible to ensure that the triclosan molecule was sensitive to UV light of 254 nm because the removal was over 80 % using UV light. The removal of TCS increased in the presence of sulfate radicals. It was possible to identify 2,4-dichlorophenol as one of the photolytic degradation products of triclosan, which does not represent an environmental hazard at low concentrations of triclosan in water. These results confirm that the use of AC Darco, Norit, and F400 and that photodegradation processes with UV light and persulfate radicals are effective in removing TCS from water, reaching concentration levels that do not constitute a risk to human health or environmental hazard. Both methods effectively eliminate pollutants with relatively easy techniques to implement.

Application of artificial intelligence for the optimization of advanced oxidation processes to improve the water quality polluted with pharmaceutical compounds

Sulfamethoxazole and metronidazole are emerging pollutants commonly found in surface water and wastewater. These compounds have a significant environmental impact, being necessary in the design of technologies for their removal. Recently, the advanced oxidation process has been proven successful in the elimination of this kind of compounds. In this sense, the present work discusses the application of UV/H2O2 and ozonation for the degradation of both molecules in single and binary systems. Experimental kinetic data from O3 and UV/H2O2 process were adequately described by a first and second kinetic model, respectively. From the ANOVA analysis, it was determined that the most statistically significant variables were the initial concentration of the drugs (0.03 mmol L-1) and the pH = 8 for UV/H2O2 system, and only the pH (optimal value of 6) was significant for degradation with O3. Results showed that both molecules were eliminated with high degradation efficiencies (88-94% for UV/H2O2 and 79-98% for O3) in short reaction times (around 30-90 min). The modeling was performed using a quadratic regression model through response surface methodology representing adequately 90 % of the experimental data. On the other hand, an artificial neural network was used to evaluate a non-linear multi-variable system, a 98% of fit between the model and experimental data was obtained. The identification of degradation byproducts was performed by high-performance liquid chromatography coupled to a time mass detector. After each process, at least four to five stable byproducts were found in the treated water, reducing the mineralization percentage to 20% for both molecules.

Pd/MIL-100(Fe) as hydrogen activator for FeIII/FeII cycle: Fenton removal of sulfamethazine

Masses of iron sludge generated from engineering practice of classic Fenton reaction constraints its further promotion. Accelerating the FeIII/FeII cycle may be conducive to reducing the initial ferrous slat dosage and the final iron sludge. Based on the reduction of Pd/MIL-100(Fe)-activated hydrogen, an improved Fenton system named MHACF-MIL-100(Fe) was developed at ambient temperature and pressure. 97.8% of sulfamethazine, the target pollutant in this work, could be degraded in 5 min under the conditions of 20 mM H2O2, 25 μM ferrous chloride, initial pH 3.0, 2 g·L-1 composite catalyst Pd/MIL-100(Fe) and hydrogen gas 60 mL·min-1. Combining density functional theory (DFT) calculation and intermediate detection, the degradation of this antibiotic was inferred to start from the cleavage of N-S bond. The catalytic of Pd/MIL-100(Fe), demonstrated by the removal efficiency of SMT and the catalyst morphology, remained intact after six reaction cycles. The present study provides an insight into the promotion of Fenton reaction.

Hydrothermal synthesis of a photocatalyst based on Byrsonima crassifolia and TiO2 for degradation of crystal violet by UV and visible radiation

This work presents a one-step synthesis methodology for preparing a hydrochar (HC) doped with TiO2 (HC-TiO2) for its application on the degradation of crystal violet (CV) using UV and visible radiation. Byrsonima crassifolia stones were used as precursors along with TiO2 particles. The HC-TiO2 sample was synthesized at 210 °C for 9 h using autogenous pressure. The photocatalyst was characterized to evaluate the TiO2 dispersion, specific surface area, graphitization degree, and band-gap value. Finally, the degradation of CV was investigated by varying the operating conditions of the system, the reuse of the catalyst, and the degradation mechanism. The physicochemical characterization of the HC-TiO2 composite showed good dispersion of TiO2 in the carbonaceous particle. The presence of TiO2 on the hydrochar surface yields a bandgap value of 1.17 eV, enhancing photocatalyst activation with visible radiation. The degradation results evidenced a synergistic effect with both types of radiation due to the hybridized π electrons in the sp2-hybridized structures in the HC surface. The degradation percentages were on average 20% higher using UV radiation than visible radiation under the following conditions: [CV] = 20 mg/L, 1 g/L of photocatalyst load, and pH = 7.0. The reusability experiments demonstrated the feasibility of reusing the HC-TiO2 material up to 5 times with a similar photodegradation percentage. Finally, the results indicated that the HC-TiO2 composite could be considered an efficient material for the photocatalytic treatment of water contaminated with CV.

Formation and structural features of micelles formed by surfactin homologues

Surfactin, a group of cyclic lipopeptides produced by Bacillus subtilis, possesses surfactant properties and is a promising natural and biologically active compound. In this study, we present a comprehensive characterization of surfactin, including its production, chromatographic separation into pure homologues (C₁₂, C₁₃, C₁₄, C₁₅), and investigation of their physicochemical properties. We determined adsorption isotherms and interpreted them using the Gibbs adsorption equation, revealing that the C₁₅ homologue exhibited the strongest surface tension reduction (27.5 mN/m), while surface activity decreased with decreasing carbon chain length (32.2 mN/m for C₁₂). Critical micelle concentration (CMC) were also determined, showing a decrease in CMC values from 0.35 mM for C₁₂ to 0.08 mM for C₁₅. We employed dynamic light scattering (DLS), transmission electron microscopy (TEM), and density functional theory (DFT) calculations to estimate the size of micellar aggregates, which increased with longer carbon chains, ranging from 4.7 nm for C₁₂ to 5.7 nm for C₁₅. Furthermore, aggregation numbers were determined, revealing the number of molecules in a micelle. Contact angles and emulsification indexes (E₂₄) were measured to assess the functional properties of the homologues, showing that wettability increased with chain length up to C₁₄, which is intriguing as C₁₄ is the most abundant homologue. Our findings highlight the relationship between the structure and properties of surfactin, providing valuable insights for understanding its biological significance and potential applications in various industries. Moreover, the methodology developed in this study can be readily applied to other cyclic lipopeptides, facilitating a better understanding of their structure-properties relationship.

A kinetic study of the photolysis of sulfamethoxazole with special emphasis on the photoisomer

Abstract

The previously not studied photochemical degradation of sulfamethoxazole (SMX) to the isomer of SMX (ISO) was measured via a polychromatic (Xe) and a monochromatic (Hg) light source and accompanied by quantum chemical DFT calculations. In addition to the $$\mathrm{p}K_\mathrm{a} = \;7.0 \pm 0.1$$ p K a = 7.0 ± 0.1 of ISO, tautomer-dependent properties such as the $$K_\mathrm{OW}$$ K OW were measured and theoretically confirmed by DFT. The kinetics in solutions below and above the $$\mathrm{p}K_\mathrm{a} = 5.6$$ p K a = 5.6 of SMX were studied for the available and quantifiable products SMX, ISO, 3-amino-5-methylisoxazole (AMI), 2-amino-5-methyloxazole (AMO), and sulfanilic acid (SUA). The quantum yields of the neutral ($$\Phi _\mathrm{N}$$ Φ N ) and anionic $$\Phi _\mathrm{A}$$ Φ A ) forms of SMX ($$\Phi _\mathrm{A} = 0.03 \pm 0.001$$ Φ A = 0.03 ± 0.001 , $$\Phi _\mathrm{N} = 0.15 \pm 0.01$$ Φ N = 0.15 ± 0.01 ) and ISO ($$\Phi _\mathrm{A} = 0.05 \pm 0.01$$ Φ A = 0.05 ± 0.01 and $$\Phi _\mathrm{N} = 0.06 \pm 0.02$$ Φ N = 0.06 ± 0.02 ) were found to be wavelength-independent. In a competitive reaction to the formation of ISO from SMX, the degradation product TP271 is formed. Various proposed structures for TP271 described in the literature have been studied quantum mechanically and can be excluded for thermodynamic reasons. In real samples in a northern German surface water in summer 2021 mean concentrations of SMX were found in the range of 120 ng/L. In agreement with the pH-dependent yields, concentrations of ISO were low in the range of 8 ng/L.

Graphical abstract

Occurrence and ecotoxicity of sulfonamides in the aquatic environment: A review

Rapid population growth and increasing demand for animal protein food have led to a continuous increase in global utilization of antibiotic. Sulfonamides (SAs) are ubiquitous in aquatic environments and pose an ecological risk owing to their large consumption and strong environmental persistence. Hence, this review focuses on the recent publications on 12 different SAs and provides a detailed summary of selected antibiotic concentrations in various water systems. We evaluated the ecotoxicity of SAs on organisms at different trophic level organisms and the environmental risks regarding aquatic systems. The results indicated that SA antibiotics were ubiquitous in aquatic environments at concentrations ranging from ng/L to μg/L. According to the data using standard ecotoxicity bioassays, algae were the most susceptible aquatic organisms for selected antibiotics, followed by crustaceans and fish. The risk data suggested that some antibiotics, such as sulfadiazine (SDZ), sulfamethoxazole (SMX), and sulfamethazine (SMZ) pose a great risk to the aquatic system. Based on the present review, it is necessary to strengthen the research into their ecotoxicity to marine systems and the chronic toxicity of antibiotic mixtures.