Improvement of bioavailability of water insoluble drugs: Estimation of intrinsic bioavailability (Short Communication)

Enhancing Dissolution and Oral Bioavailability of Ursodeoxycholic Acid with a Spray-Dried pH-Modified Extended Release Formulation

Ursodeoxycholate (UDCA) has low oral bioavailability and pH-dependent solubility and permeability. Thus, we developed a pH-modified extended-release formulation of UDCA using Na₂CO₃ as the alkalizing agent and hydroxypropyl methylcellulose (HPMC) as the release-modifying agent. The optimized pH-modified controlled-release UDCA formulation, with the UDCA:HPMC:Na₂CO₃ ratio of 200:600:150 (w/w/w), was prepared using a spray-drying method. Then, the formulation’s solubility, dissolution, and pharmacokinetic properties were characterized. In a pH-modified extended-release formulation of UDCA, the solubility of UDCA was increased to 8 mg/mL with a sustained dissolution for 12 h. Additionally, the spray-dried formulation exhibited amorphous states without molecular interaction among UDCA, Na₂CO₃, and HPMC. Moreover, the plasma UDCA concentration of the formulation maintained a higher UDCA concentration for up to 48 h than that of UDCA itself or the non-extended-release UDCA formulation. Consequently, the formulation significantly increased the AUC compared to UDCA or the non-extended-release UDCA formulation in rats. In conclusion, we have improved UDCA’s solubility and dissolution profile by preparing a pH-modified extended-release formulation with the UDCA:HPMC:Na₂CO₃ ratio of 200:600:150 (w/w/w), which effectively increased the oral bioavailability of UDCA by 251% in rats.

Preparation and characterization of fast dissolving pullulan films containing BCS class II drug nanoparticles for bioavailability enhancement

The aim of this study is to assess pullulan as a novel steric stabilizer during the wet-stirred media milling (WSMM) of griseofulvin, a model poorly water-soluble drug, and as a film-former in the preparation of strip films via casting-drying the wet-milled drug suspensions for dissolution and bioavailability enhancement. To this end, pullulan films, with xanthan gum (XG) as thickening agent and glycerin as plasticizer, were loaded with griseofulvin nanoparticles prepared by WSMM using pullulan in combination with sodium dodecyl sulfate (SDS) as an ionic stabilizer. The effects of drug loading and milling time on the particle size and suspension stability were investigated, as well as XG concentration and casting thickness on film properties and dissolution rate. The nanosuspensions prepared with pullulan-SDS combination were relatively stable over 7 days; hence, this combination was used for the film preparation. All pullulan-based strip films exhibited excellent content uniformity (most <3% RSD) despite containing only 0.3-1.3 mg drug, which was ensured by the use of precursor suspensions with >5000 cP viscosity. USP IV dissolution tests revealed fast/immediate drug release (t80 < 30 min) from films <120 μm thick. Thinner films, films with lower XG loading, or smaller drug particles led to faster drug dissolution, while drug loading had no discernible effect. Overall, these results suggest that pullulan may serve as an acceptable stabilizer for media milling in combination with surfactant as well as a fast-dissolving film former for the fast release of poorly water-soluble drug nanoparticles.

Studies on chitosan: 6. Relationship between N-acetyl group distribution pattern and chitinase digestibility of partially N-acetylated chitosans

The digestibility of partially N-acetylated chitosans by microbial chitinases was investigated in view of the distribution pattern of N-acetyl groups along the polysaccharide chain. Partially N-acetylated chitosans are classified into two groups; moderately N-deacetylated chitosans (MDC) with 10-30% acetyl content obtained by heterogeneous N-deacetylation of chitin and partially N-acetylated chitosans (PAC-H) with 20-70% acetyl content prepared by homogeneous N-acetylation of highly N-deacetylated chitosans (HDC). MDC have some blocks of N-acetyl-D-glucosamine (GlcNAc) sequences but PAC-H are random-type copolymers of GlcNAc and D-glucosamine. The apparent Km values of Streptomyces griseus chitinase were 0.14 g l-1 for 30% N-acetylated MDC and 0.16 g l-1 for 30% N-acetylated PAC-H. The Km values decreased with increased N-acetylation but the values for both MDC and PAC-H with similar acetyl content were almost the same. The chitinase from S. griseus could not distinguish the difference between block and random distributions of GlcNAc. The chitinases from Bacillus sp. and Bacillus sp. PI-7S also hydrolysed MDC and PAC-H in the same manner. From these results we conclude that sequences of GlcNAc are not necessary for recognition by these chitinases in contrast to lysozyme.