Enhanced performance in the photocatalytic degradation of 2,4,5-Trichlorophenoxyacetic acid over Eu-doped Bi2WO6 under visible light irradiation

Highly Efficient Removal of 2,4,5-Trichlorophenoxyacetic Acid by Adsorption and Photocatalysis Using Nanomaterials with Surface Coating by the Cationic Surfactant

Extensive removal of 2,4,5-trichlorophenoxyacetic acid (2,4,5-T) using titania (TiO2) nanoparticles by adsorption and photocatalysis with a surface coating by cetyltrimethylammonium bromide (CTAB) is reported. The CTAB-coated TiO2 nanoparticles (CCTN) were characterized by FT-IR, zeta-potential measurements, and UV-vis diffuse reflectance spectroscopy (UV-vis-DRS). 2,4,5-T removal increased significantly after surface modification with CTAB compared with bare TiO2 nanoparticles. Optimal parameters affecting 2,4,5-T removal were found to be pH 4, CCTN dosage 10 mg/mL, and adsorption time 180 min. The maximum adsorptive removal of 2,4,5-T using CCTN reached 96.2% while highest adsorption capacity was 13.4 mg/g. CCTN was also found to be an excellent photocatalyst that achieved degradation efficiency of 99.2% with an initial concentration of 25 mg/L. The removal mechanisms of 2,4,5-T using CCTN by both adsorption and photocatalysis are discussed in detail based on changes in functional group vibrations and surface charge. Our results indicate that CCTN is an excellent material for 2,4,5-T removal in water by both adsorption and photocatalysis.

Outstanding photo-thermo synergy in aerobic oxidation of cyclohexane by bismuth tungstate-bismuth oxychloride high-low heterojunction

The difficulty of achieving both high conversion rate and high selectivity is a huge challenge in the catalytic aerobic oxidation of cyclohexane. In this paper, bismuth tungstate-bismuth oxychloride (Bi2WO6-BiOCl) nanoflower heterojunctions prepared via a one-step solvothermal process were applied in the photo-thermo synergetic catalytic oxidation of cyclohexane in the dried air. With the addition of little water at different reaction temperature, the ratio of bismuth to tungsten and the mass ratio of Bi2WO6 to BiOCl can be precisely tailored in the nanoflower sphere composites with thin nanosheets. Their microscopic morphology, elemental composition, crystal structure, and photoelectrochemical characteristics were explored by different characterization methods. The Bi2WO6-BiOCl composites possessed poor photocatalytic and thermal performances with the low conversion rates of 1.43% and 2.68%, respectively. However, through the photo-thermo catalytic oxidation process, an exceptional conversion rate of 13.32% was achieved with excellent selectivity of 99.22% for cyclohexanone and cyclohexanol (KA oil) using the same Bi2WO6-BiOCl composites. This superior performance outstrips Bi2WO6 flowers, BiOCl nanosheets and Bi2WO6-BiOCl composites with other compounding ratios. The creation of a high-low heterojunction in the Bi2WO6-BiOCl composite was confirmed by band energy analysis. The opto-electronic analysis, band energy analysis, sacrifice experiments, and active radical analysis were employed to elucidate the mechanism for the exceptional photo-thermo catalytic performance in detail. This work offers an exploratory solution to the challenges of high energy consumption and the difficulty in simultaneously achieving high selectivity and high conversion rates in cyclohexane oxidation, thus holding significant value.

Designing advanced S-scheme CdS QDs/La-Bi2WO6 photocatalysts for efficient degradation of RhB

Finding effective strategies to design efficient photocatalysts and decompose refractory organic compounds in wastewater is a challenging problem. Herein, by coupling element doping and constructing heterostructures, S-scheme CdS QDs/La-Bi2WO6 (CS/LBWO) photocatalysts are designed and synthesized by a simple hydrothermal method. As a result, the RhB degradation efficiency of the optimized 5% CS/LBWO reached 99% within 70 min of illumination with excellent stability and recyclability. CS/LBWO shows improvement in the adsorption range of visible light and promotes electron-hole pair generation/migration/separation, attributing the superior degradation performance. The degradation RhB mechanism is proposed by a free radical capture experiment, electron paramagnetic resonance, and high-performance liquid chromatography-mass spectrometry results, indicating that h+ and •O2 - play a significant role during four degradation processes: de-ethylation, chromophore cleavage, ring opening, and mineralization. Based on in situ irradiated X-ray photoelectron spectroscopy, Mulliken electronegativity theory, and the work function results, the S-scheme heterojunction of CS/LBWO promotes the transfer of photogenerated electron-hole pairs and promotes the generation of reactive radicals. This work not only reports that 5% CS/LBWO is a promising photocatalyst for degradation experiments but also provides an approach to design advanced photocatalysts by coupling element doping and constructing heterostructures.

Key Role of Corncob Based-Hydrochar (HC) in the Enhancement of Visible Light Photocatalytic Degradation of 2,4-Dichlorophenoxyacetic Acid Using a Derivative of ZnBi-Layered Double Hydroxides

A superior heterojunction of HC-ZnBi-LDO was synthesized in two steps, namely hydrothermal carbonization, followed by co-precipitation. The 2% HC-ZnBi-LDO heterojunction photocatalysts could degrade over 90.8% of 30 mg/L 2,4-dichlorophenoxyacetic acid (2,4-D) using 1.0 g/L of the catalyst after 135 min of visible light exposure at pH 4. The activity of 2% HC-ZnO-LDO was remarkably stable. Approximately 86.4-90.8% of 30 mg/L 2,4-D was degraded, and more than 79-86.4% of TOC was mineralized by 2% HC-ZnBi-LDO at pH 4 after 135 min of visible light exposure during four consecutive cycles. The rapid separation and migration of charge carriers at the interfaces between HC and ZnBi-LDO were achieved within 2% HC-ZnBi-LDO. Moreover, the electron acceptor characteristic of HC in 2% HC-ZnBi-LDO caused the recombination of charge carriers to decrease significantly, thus generating more reactive radicals, such as hydroxyl radicals (OH^●) and superoxide radicals (O₂^●-). These results demonstrate that the novel 2% HC-ZnBi-LDO is a superior photocatalyst for the remediation of hazardous organic pollutants.

Bismuth tungstate Bi2WO6: a review on structural, photophysical and photocatalytic properties

This review paper provides a comprehensive overview of the recent trends in bismuth tungstate (Bi₂WO₆) research, covering its structural, electrical, photoluminescent, and photocatalytic properties. The structural characteristics of bismuth tungstate are explored in detail, including its different allotropic crystal structures with respect to its isotypic materials. The electrical properties of bismuth tungstate, such as its conductivity and electron mobility, are also discussed, along with its photoluminescent properties. The photocatalytic activity of bismuth tungstate is a particular focus, with recent advances in doping and co-doping strategies with metals, rare earth and other elements summarized. The limitations and challenges of using bismuth tungstate as a photocatalyst are also examined, such as its low quantum efficiency and susceptibility to photodegradation. Finally, recommendations for future research directions are provided, including the need for further studies on the underlying mechanisms of photocatalytic activity, the development of more efficient and stable bismuth tungstate-based photocatalysts, and the exploration of new applications in fields such as water treatment and energy conversion.

Design of novel p-n heterojunction ZnBi2O4-ZnS photocatalysts with impressive photocatalytic and antibacterial activities under visible light

Heterojunction structures have attracted considerable attention for enhancing electron migration across interfaces. In this report, ZnBi₂O₄-ZnS(12%) heterojunction photocatalysts was found to be capable of degrading over 94% of indigo carmine in a 15 mg/L solution within 90 min of visible light irradiation at a catalytic dose of 1.0 g/L and pH 4. Furthermore, more than 82% of the total organic carbon (TOC) was removed, confirming the almost complete mineralization of the indigo carmine by ZnBi₂O₄-ZnS(12%). Moreover, the photocatalyst exhibited high stability and retained its photocatalytic activity up to the 5th cycle of operation without photocorrosion. The dramatic enhancement in the visible-light photocatalytic performance of the ZnBi₂O₄-ZnS heterojunctions over pristine ZnBi₂O₄ and ZnS was due to the formation of a superior heterojunction between the n-type semiconductor, ZnS, and the p-type semiconductor, ZnBi₂O₄. This heterojunction facilitated the separation and transfer of the photoinduced electron at the interfaces of the two semiconductors. Furthermore, the ZnBi₂O₄-ZnS(12%) exhibited an inhibition zone of 15 mm against fecal Escherichia coli (ATCC 8739), with a minimum inhibitory concentration (MIC) of 150 μg/mL. These results demonstrated that the novel ZnBi₂O₄-ZnS p-n-type heterojunction is a promising visible-light active photo-catalyst for the degradation of organic pollutants and inhibition of fecal E. coli.

1D/2D constructed Bi2S3/Bi2O2CO3 direct Z-Scheme heterojunction: A versatile photocatalytic material for boosted photodegradation, photoreduction and photoelectrochemical detection of water-based contaminants

In this work, two-dimensional Bi₂O₂CO₃ disk is synthesized, followed by the growth of Bi₂S₃ over Bi₂O₂CO₃ via topotactic transformation by controlling the amount of thiourea under hydrothermal conditions. The synthesized composite catalyst is investigated for photocatalytic oxidation and reduction of tetracycline hydrochloride and hexavalent chromium under visible light irradiation. High interfacial contact between the Bi₂O₂CO₃ disk0 and Bi₂S₃ fiber is confirmed via high-resolution microscopic imaging. Enhanced light absorption and increased charge carrier separation is observed after the formation of the Bi₂S₃/Bi₂O₂CO₃ composite. The Bi₂S₃/Bi₂O₂CO₃ composite grown using 1 mmol of thiourea shows approximately 98% degradation of tetracycline hydrochloride after 120 min and 99% Cr(VI) reduction after 90 min of photochemical reaction under visible light irradiation. The charge separation is due to the formed internal electric field at the interface, which upon light irradiation follows a z-scheme charge transfer hindering the recombination at the Bi₂S₃ and Bi₂O₂CO₃ interface, thereby contributing efficiently to the photochemical process. In addition, the mechanism of the photochemical reaction for the degradation of pollutants is supported using quencher and probe experiments. Furthermore, photoelectrochemical detection of antibiotic in aqueous solution is conducted to understand the sensing feasibility of the synthesized system.