Eliciting the Sensory Modalities of Fat Reformulated Yoghurt Ice Cream Using Oligosaccharides

Incorporation of Yogurt Acid Whey in Low-Lactose Yogurt Ice Cream

Yogurt acid whey (YAW), a by-product of strained yogurt production, is a strong environmental pollutant because of its high organic load. Hence, efforts are made for its utilization to minimize its disposal in the environment. This study deals with the incorporation of YAW in yogurt ice cream (YIC) by partial replacement of yogurt with simultaneous lactose hydrolysis (LH) of the formulated YIC mix. Six YIC mix formulations were made, two without YAW (non-LH- and LH-control samples, A and AH), two with 12.5% YAW (samples B and BH), and two with 18.75% YAW (samples C and CH). The results showed that the partial replacement of yogurt with YAW decreased significantly (p < 0.05) the total solids of B, BH, C, and CH products (31.72 ± 0.14%, 31.92 ± 0.21%, 30.94 ± 0.14%, and 31.27 ± 0.10%, respectively) compared to the total solids of control products A and AH (33.30 ± 0.36% and 33.74 ± 0.06%, respectively). In contrast, the overruns increased (51.50 ± 2.36%, 58.26 ± 0.09%, 56.86 ± 1.92%, and 65.52 ± 1.30% for the B, BH, C, and CH products, respectively) compared to control samples (42.02 ± 2.62% and 49.53 ± 2.12% for A and AH, respectively). LH significantly decreased the freezing point and the viscosity of the YIC mixes but increased the overruns of the products as shown previously. YAW significantly decreased the hardness of the B and C products (56.30 ± 2.11 N and 43.43 ± 3.91 N, respectively) compared to control A (81.14 ± 9.34 N), and LH decreased it even more, leading to a rather soft scoop YIC. AH, BH, and CH YICs exhibited better melting properties despite the lack of fat destabilization in all samples. After 60 days of storage, counts of yogurt starter microorganisms were still >107 cfu/g and DPPH radical scavenging activity had increased in all products. In the sensory evaluation test, lactose-hydrolyzed samples AH, BH, and CH had less intense sandiness and, as expected, more intense sweetness. In conclusion, in the framework of the circular economy, it is possible for the YAW to be used as a resource material at a ratio of 12.5% to produce a YIC product without leaving behind any new waste.

Characteristics of fish gelatin-anionic polysaccharide complexes and their applications in yoghurt: Rheology and tribology

In this study, the rheological and tribological properties of complex solutions comprising of fish gelatin (FG)-Arabic gum (AG), FG-xanthan gum (XG), and FG-κ-carrageenan (κC), respectively, were measured, as well as the effects of the complex on the physical properties of yoghurt. Results showed that with increased XG and κC concentrations, the viscosity of FG-XG and FG-κC complex solutions both increased. It was also found that the lubrication properties of FG-anionic polysaccharide (AP) solutions decreased with the increased AP contents. The applications of FG-AP complexes (FG:AP = 9:1) improved firmness, water holding capacity and viscosity of yoghurt by the formation of large aggregates, but gels were easily destroyed at high frequency. Moreover, compared with gelatin, FG-AP complexes made yoghurt better lubrication properties during low and medium sliding speed, especially for FG-XG complexes. Thus, FG-AP complexes have the potential to be applied in producing yoghurt with good quality.

Impact of High-Pressure Process on Probiotics: Viability Kinetics and Evaluation of the Quality Characteristics of Probiotic Yoghurt

The impact of high-pressure (HP) processing on the viability of two probiotic microorganisms (Bifidobacterium bifidum and Lactobacillus casei) at varying pressure (100−400 MPa), temperature (20−40 °C) and pH (6.5 vs. 4.8) conditions was investigated. Appropriate mathematical models were developed to describe the kinetics of the probiotics viability loss under the implemented HP conditions, aiming to the development of a predictive tool used in the design of HP-processed yoghurt-like dairy products. The validation of these models was conducted in plain and sweet cherry-flavored probiotic dairy beverage products pressurized at 100−400M Pa at ambient temperature for 10 min. The microbiological, rheological, physicochemical and sensory characteristics of the HP-treated probiotic dairy beverages were determined in two-week time intervals and for an overall 28 days of storage. Results showed that the application of HP in the range of 200−300 MPa had minimal impact on the probiotic strains viability throughout the entire storage period. In addition, the aforementioned HP processing conditions enhanced the rheological and sensory properties without affecting post-acidification compared to the untreated product analogues.