Application of immobilized tannase from Aspergillus niger for the removal of tannin from myrobalan juice

Characterization and application of tannase and gallic acid produced by co-fungi of Aspergillus niger and Trichoderma viride utilizing agro-residues substrates

Bioconversion using fungi, as natural factory of many applicable bioactive compounds, as enzymes utilizing agro-residue substrates as a solid, abundant, low-cost growth and enzyme production media. This study characterized and applied a tannase enzyme (308 U/mg) from Aspergillus niger A8 + Trichoderma viride co-cultures utilizing pomegranate peels. The partially purified enzyme showed maximal relative activity at 37-65 °C for 10 min and kinetics of thermal inactivation energy at a high point at 60 °C for 0.040/min. The half-life was 37 °C for 58.6 min, temperature coefficient Q10 of tannase was maximal for 1.38 between 40 and 50 °C, and the activation energy was 17.42 kJ/mol. The enzyme activity peaked in the pH range of 4-8, and the maximum relative activity (100.6%) for tannase was achieved at pH 6. The Km and Vmax values for purified enzymes using tannic acid were 7.3 mg/mL and 3333.33 U/mL, respectively. The enzyme reduced the total tannin content in all tannin-rich substrates after 12h. The gallic acid (GA) had total phenols of 77.75 ppm and antioxidant activity of 82.91%. It was observed that the GA as antimicrobial influencer exhibited the largest inhibitory zone diameter (IZD) of 31 ± 1.0 mm against Pseudomonas aeruginosa ATCC27853. The GA minimum inhibitory concentration value was ranged from 7770.0-121.41 µg/mL. The obtained GA showed a bactericidal effect against all bacterial strains except Shigella sonnei DSM5570 and Salmonella typhi DSM17058, which showed bacteriostatic behavior.

An overview of microalgae biomass as a sustainable aquaculture feed ingredient: food security and circular economy

Sustainable management of natural resources is critical to food security. The shrimp feed and fishery sector is expanding rapidly, necessitating the development of alternative sustainable components. Several factors necessitate the exploration of a new source of environmentally friendly and nutrient-rich fish feed ingredients. Microalgal biomass has the potential to support the growth of fish and shrimp aquaculture for global food security in the bio-economy. Algal biorefineries must valorize the whole crop to develop a viable microalgae-based economy. Microalgae have the potential to replace fish meal and fish oil in aquaculture and ensure sustainability standards. Microalgae biomasses provide essential amino acids, valuable triglycerides such as lipids, vitamins, and pigments, making them suitable as nutritional supplements in livestock feed formulations. Fish and microalgae have similar nutritional profiles, and digestibility is a critical aspect of the aquafeed formulation. A highly digestible feed reduces production costs, feed waste, and the risk of eutrophication. Due to low input costs, low carbon footprint, wastewater treatment benefits, and carbon credits from industrial CO₂ conversion, microalgae-based fish and shrimp feeds have the potential to provide significant economic benefits. However, several challenges must be addressed before microalgal biomass and bioproducts may be used as fish feeds, including heavy metal bioaccumulation, poor algal biomass digestion, and antinutrient effects. Knowledge of biochemical composition is limited and diverse, and information on nutritional value is scattered or contradictory. This review article presents alternative approaches that could be used in aquaculture to make microalgal biomass a viable alternative to fish meal.

A comprehensive review on tannase: Microbes associated production of tannase exploiting tannin rich agro-industrial wastes with special reference to its potential environmental and industrial applications

Microorganisms have been used for the production of various enzymes, including inducible tannase for various industrial and environmental applications. Tannases have lot of potential to convert hydrolysable tannins to gallic acid, which is one of the important industrial and therapeutic significant molecules whose demand is over 10000 tons per year. Tannins invariably occur in angiosperms, gymnosperms and pteridophytes, and predominantly present in various parts of plants such as, leaves, roots, bark and fruit. Furthermore, tannery effluents are frequently loaded with significant levels of tannic acid. Tannase can be effectively used to decrease tannin load in the toxic tannery effluent thus providing the opportunity to minimize the operational cost. Over the past three decades, tannase from microbial sources has been proposed for the degradation of natural tannins. The availability of various agro-industrial residues paves a way for maximum utilization of tannase production for the degradation of tannin and eventually the production of gallic acid. In this review, an illustrative and comprehensive account on tannase from microbial source for current day applications is presented. The present review emphasises on up-to-date microbial sources of tannases, biochemical properties, optimization of tannase production in solid state and submerged fermentation and its industrial and environmental applications.

Preparation and characterization of tannase immobilized onto carboxyl-functionalized superparamagnetic ferroferric oxide nanoparticles

Tannase from Aspergillus tubingensis was immobilized onto carboxyl-functionalized Fe3O4 nanoparticles (CMNPs), and conditions affecting tannase immobilization were investigated. Successful binding between CMNPs and tannase was confirmed by Fourier transform infrared spectroscopy and thermogravimetric analysis. Vibrating sample magnetometry and X-ray diffraction showed that the CMNPs and immobilized tannase exhibit distinct magnetic responses and superparamagnetic properties. Free and immobilized tannase exhibited identical optimal temperatures of 50°C and differing pH optima at 6 and 7, respectively. The thermal, pH, and storage stabilities of the immobilized tannase were superior to those of free tannase. After six cycles of catalytic hydrolysis of propyl gallate, the immobilized tannase maintained over 60% of its initial activity. The Michaelis constant (Km) of the immobilized enzyme indicated its higher affinity for substrate binding than the free enzyme.

Production, Characterization and Application of a Thermostable Tannase from Pestalotiopsis guepinii URM 7114

Tannase (EC 3.1.1.20) is an enzyme that hydrolyzes the ester and depside bonds of tannic acid to gallic acid and glucose. In the production of foods and beverages, it contributes to the removal of the undesirable effects of tannins. The aim of this study is to investigate the potential of endophytic fungi isolated from jamun (Syzygium cumini (L.) Skeels) leaves, and identified as Pestalotiopsis guepinii, in the production of tannase. Tannase was produced extracellularly by P. guepinii under submerged, slurry-state and solid-state fermentations. The submerged fermentation was found to be the most promising (98.6 U/mL). Response surface methodology was employed to evaluate the effect of variables (pH and temperature), and the results showed that the best conditions for tannase activity were pH=6.9 and 30 °C. Km was found to be 7.18·10-4 mol/L and vmax =250.00 U/mL. The tannase activity was the highest in the presence of Ca2+ at a concentration of 5·10-3 mol/L. Moreover, the enzyme was not inhibited by the tested chelators and detergents. The stability of the enzyme was also studied, and crude enzyme was evaluated in simulation of gastrointestinal digestion of monogastric animals. The crude enzyme was highly stable under simulated conditions; it retained 87.3% of its original activity after 6 h. The study contributes to the identification of microbial species that produce tannase, with potential application in biotechnology.

Novel strategies for upstream and downstream processing of tannin acyl hydrolase

Tannin acyl hydrolase also referred as tannase is an enzyme with important applications in several science and technology fields. Due to its hydrolytic and synthetic properties, tannase could be used to reduce the negative effects of tannins in beverages, food, feed, and tannery effluents, for the production of gallic acid from tannin-rich materials, the elucidation of tannin structure, and the synthesis of gallic acid esters in nonaqueous media. However, industrial applications of tannase are still very limited due to its high production cost. Thus, there is a growing interest in the production, recovery, and purification of this enzyme. Recently, there have been published a number of papers on the improvement of upstream and downstream processing of the enzyme. These papers dealt with the search for new tannase producing microorganisms, the application of novel fermentation systems, optimization of culture conditions, the production of the enzyme by recombinant microorganism, and the design of efficient protocols for tannase recovery and purification. The present work reviews the state of the art of basic and biotechnological aspects of tannin acyl hydrolase, focusing on the recent advances in the upstream and downstream processing of the enzyme.

Catalytical Properties of Free and Immobilized Aspergillus niger Tannase

A fungal tannase was produced, recovered, and immobilized by entrapment in calcium alginate beads. Catalytical properties of the immobilized enzyme were compared with those of the free one. Tannase was produced intracellularly by the xerophilic fungus Aspergillus niger GH1 in a submerged fermentation system. Enzyme was recovered by cell disruption and the crude extract was partially purified. The catalytical properties of free and immobilized tannase were evaluated using tannic acid and methyl gallate as substrates. K_M and V_max values for free enzyme were very similar for both substrates. But, after immobilization, K_M and V_max values increased drastically using tannic acid as substrate. These results indicated that immobilized tannase is a better biocatalyst than free enzyme for applications on liquid systems with high tannin content, such as bioremediation of tannery or olive-mill wastewater.