Microencapsulation of curcumin by spray drying: Characterization and fortification of milk

Encapsulation of Lactiplantibacillus plantarum CRD7 in sub-micron pullulan fibres by spray drying: Maximizing viability with prebiotic and thermal protectants

Pullulan was used as the wall material for microencapsulation of L. plantarum CRD7 by spray drying, while isomalto-oligosaccharides (IMO) was used as prebiotic. Also, the effect of different thermal protectants on survival rate during microencapsulation was evaluated. Taguchi orthogonal array design showed that pullulan at 14 % concentration, IMO at 30 % concentration and whey protein isolate at 20 % rate were the optimized wall material, prebiotic and thermal protectant, respectively for microencapsulation of L. plantarum. FESEM images revealed that the spray-dried encapsulates were fibrous similar to those produce by electrospinning, while fluorescence microscopy ascertained that most of the probiotic cells were alive and intact after microencapsulation. The adsorption-desorption isotherm was of Type II and the encapsulate had specific surface area of 1.92 m2/g and mean pore diameter of 15.12 nm. The typical amide II and III bands of the bacterial proteins were absent in the FTIR spectra, suggestive of adequate encapsulation. DSC thermogram showed shifting of melting peaks to wider temperature range due to interactions between the probiotic and wall materials. IMO at 30 % (w/w) along with WPI at 20 % concentration provided the highest storage stability and the lowest rate of cell death of L. plantarum after microencapsulation. Acid and bile salt tolerance results confirmed that microencapsulated L. plantarum could sustain the harsh GI conditions with >7.5 log CFU/g viability. After microencapsulation, L. plantarum also possessed the ability to ferment milk into curd with pH of 4.62.

Porous corn starch granules as effective host matrices for encapsulation and sustained release of curcumin and resveratrol

Type 2 Diabetes Mellitus (T2DM) is a carbohydrate-rich diet-regulated ailment with carbohydrates digested and absorbed rapidly. Hence, modulating carbohydrate digestion is warranted; to this end, polyphenols from plant sources are handy. However, polyphenols' instability and low bioavailability limit their wholesome use, and thus, encapsulating them into an inexpensive and suitable wall material would be the best strategy. Herein, the potential of porous starch granules is demonstrated. Curcumin and resveratrol were chosen as the test polyphenols due to their proven health benefits, and porous corn starch granules were chosen as the wall material. Porous corn starch granules were prepared through enzymatic modification with 11, 22, and 33 units of amyloglucosidase at three reaction times of 2, 4, and 6 h. The polyphenols were loaded at 100, 200, and 500 mg concentrations in 1 g of starch for 21 days and were characterized through Scanning Electron Microscope (SEM) and Fourier Transform Infrared spectroscopy (FTIR) analyses. The encapsulation efficiency was determined, the rate of starch digestion was calculated through the Englyst test, and polyphenols' in vitro release behavior in gastric and intestinal fluids was measured. Results suggest that 33 enzyme units for a 2 h reaction time were optimal for forming spherical-oval pores on corn starch granules with the maximum encapsulation efficiency of 80.16 % and 88.33 % for curcumin and resveratrol, respectively. The FTIR results suggest the entrapment of polyphenols inside the starch matrix. The inclusion significantly reduced starch digestion and increased the percentage of resistant starch up to 41.11 % and 66.36 % with curcumin and resveratrol, respectively. The in vitro release behavior demonstrated good stability in the simulated gastric fluids and sustained release in simulated intestinal fluids. The encapsulated polyphenols showed a complex Fickian type of diffusion mechanism. Overall, the results suggest that porous corn starch granules could be a potential delivery system for curcumin and resveratrol and will aid in developing novel functional foods to address the T2DM concerns.

Irreversible colorimetric bio-based curcumin bilayer membranes for smart food packaging temperature control applications

Research into innovative food safety technologies has led to the development of smart packaging with embedded chemical sensors that can monitor food quality throughout the supply chain. Thermochromic materials (TM), which are able to dynamically change colour in response to temperature fluctuations, have proven to be reliable indicators of food quality in certain environments. Natural colourants such as curcumin are becoming increasingly popular for smart packaging due to their low toxicity, environmental friendliness and ability to change colour. The innovation in this research lies in the production of a bio-based bilayer membrane specifically designed for irreversible temperature monitoring. Membrane A was prepared by dissolving cellulose acetate and curcumin in acetone at room temperature, with glycerol serving as a plasticiser. At the same time, membrane B was carefully formulated by dissolving cellulose acetate and triethanolamine in acetone, with sorbitol as plasticiser. The preparation of these different membranes revealed a remarkable event: a gradual and irreversible colour transition from an initial yellow to a brick-red hue after 24 hours of storage at 25 °C. The chemical structure and morphological analyses of the membranes were performed using several techniques, including FTIR, DSC and SEM. The membrane labels were adhered to aluminium cans and their colorimetric response was observed over a period of 10 days. Minimal colour variations were observed, confirming the reproducibility and stability of the curcumin-based membranes as temperature sensors.

Application of electro-spraying technique and mathematical modelling for nanoencapsulation of curcumin

Electro-spraying Process (ESP) was used to coat extracted curcumin (CUR) with milk protein isolate (MPI) at equal concentration. The variables were applied voltage (AV), pumps flow rate ratio (PFRR) for coating (CUR with MPI), travelling distance (TD for coating and dehydration), ESE and MPI concentrations. They changed respectively from 7.5 to 27.5 kV, 2-10 times, and 5-25 cm, and 1.5-3.5% (w/w). When the MPI concentration, TD, PFRR, and AV of ESE reached respectively to 2.56 %, 16.64 cm, 6.77 times, and 19.06 kV; the resulting nanoparticle diameter and encapsulation efficiency of CUR coated (with MPI) became 232 nm (minimum) and 80.7% (maximum) values. The scanning electron microscopy (SEM) and Fourier-transform infrared spectroscopy (FTIR) analysis confirmed that the produced nanoparticles were bead-free, homogeneous, smooth surfaces, and >50% uniformity. While the nanoparticles of CUR had >70% heat resistance (up to 10 min at 120 °C against degradation), it had more than 100% antioxidant capacity in aqueous solution than its free form (because of its appropriate and intact coating). In-vitro studies showed that the nano encapsulated particles released >80% of CUR into the intestinal tract without significant release in simulated gastric fluid.

Characterization of Spray-Dried Microcapsules of Paprika Oleoresin Induced by Ultrasound and High-Pressure Homogenization: Physicochemical Properties and Storage Stability

As an indispensable process in the microencapsulation of active substances, emulsion preparation has a significant impact on microencapsulated products. In this study, five primary emulsions of paprika oleoresin (PO, the natural colourant extracted from the fruit peel of Capsicum annuum L.) with different particle sizes (255-901.7 nm) were prepared using three industrialized pulverization-inducing techniques (stirring, ultrasound induction, and high-pressure homogenization). Subsequently, the PO emulsion was microencapsulated via spray drying. The effects of the different induction methods on the physicochemical properties, digestive behaviour, antioxidant activity, and storage stability of PO microencapsulated powder were investigated. The results showed that ultrasound and high-pressure homogenization induction could improve the encapsulation efficiency, solubility, and rehydration capacity of the microcapsules. In vitro digestion studies showed that ultrasound and high-pressure homogenization induction significantly increased the apparent solubility and dissolution of the microcapsules. High-pressure homogenization induction significantly improved the antioxidant capacity of the microcapsules, while high-intensity ultrasound (600 W) induction slowed down the degradation of the microcapsule fats and oils under short-term UV and long-term natural light exposure. Our study showed that ultrasound and high-pressure homogenization equipment could successfully be used to prepare emulsions containing nanoscale capsicum oil resin particles, improve their functional properties, and enhance the oral bioavailability of this bioactive product.

Research progress on drug delivery systems for curcumin in the treatment of gastrointestinal tumors

Curcumin is a natural compound with a diketone structure, which can control the growth, metastasis, recurrence, neovascularization, invasion, and drug resistance of gastrointestinal tumors by inhibiting nuclear factor κB, overexpression of tumor cells, vascular endothelial growth factor, etc. However, due to the low bioavailability of curcumin formulation, it did not fully exert its pharmacological effects, and its application and development in the treatment of various malignant tumors are still limited. This review summarizes the research on drug delivery systems of curcumin combating digestive tract tumors in order to further reduce the toxic side effects of curcumin-containing drugs and fully exert their pharmacological activities, and improve their bioavailability and clinical value.

Physicochemical and Functional Properties and Storage Stability of Chitosan-Starch Films Containing Micellar Nano/Microstructures with Turmeric and Hibiscus Extracts

The dynamic development of the food industry and the growing interest of consumers in innovative solutions that increase the comfort and quality of life push the industry towards seeking pioneering solutions in the field of food packaging. Intelligent and active packaging, which affects the quality and durability of food products and allows one to determine their freshness, is still a modern concept. The aim of our study was to obtain two types of films based on chitosan and starch with micellar nanostructures containing extracts from turmeric rhizomes and hibiscus flowers. The presence of spherical nanostructures was confirmed using a scanning electron microscope. The structural and optical properties of the obtained composites were characterised by Fourier-transform infrared (FTIR), UltraViolet-Visible (UV-VIS), and photoluminescence (PL) spectroscopy. Scanning electron microscopy (SEM) analysis confirmed the presence of spherical micellar structures with a size of about 800 nm in the obtained biocomposites. The presence of nano-/microstructures containing extracts affected the mechanical properties of the composites: it weakened the strength of the films and improved their elongation at break (EAB). Films with nano-/microparticles were characterised by a higher water content compared to the control sample and lower solubility, and they showed stronger hydrophilic properties. Preliminary storage tests showed that the obtained biocomposites are sensitive to changes occurring during the storage of products such as cheese or fish. In addition, it was found that the film with the addition of turmeric extract inhibited the growth of microorganisms during storage. The results suggest that the obtained bionanocomposites can be used as active and/or intelligent materials.

Ultrasound-Assisted Encapsulation of Citronella Oil in Alginate/Carrageenan Beads: Characterization and Kinetic Models

The objective of this research was to investigate the effect of ultrasonication on citronella oil encapsulation using alginate/carrageenan (Alg/Carr) in the presence of sodium dodecyl sulfate (SDS). The functional groups of microparticles were characterized using Fourier transform infrared spectroscopy (FTIR), and the beads’ morphologies were observed using a scanning electron microscope (SEM). The FTIR results showed that the ultrasonication process caused the C-H bonds (1426 cm−1) to break down, resulting in polymer degradation. The SEM results showed that the ultrasonication caused the presence of cavities or pores in the cracked wall and a decrease in the beads’ size. In this study, the use of ultrasound during the encapsulation of citronella oil in Alg/Carr enhanced the encapsulation efficiency up to 95–97%. The kinetic evaluation of the oil release of the beads treated with ultrasound (UTS) showed a higher k1 value of the Ritger–Peppas model than that without ultrasonication (non-UTS), indicating that the oil release rate from the beads was faster. The R/F value from the Peppas–Sahlin model of the beads treated with UTS was smaller than that of the non-UTS model, revealing that the release of bioactive compounds from the UTS-treated beads was diffusion-controlled rather than due to a relaxation mechanism. This study suggests the potential utilization of UTS for controlling the bioactive compound release rate.

Encapsulation of Functional Plant Oil by Spray Drying: Physicochemical Characterization and Enhanced Anti-Colitis Activity

In this study, an encapsulation system was developed for functional plant oil delivery. Through a series of orthogonal experiments and single factor experiments, the raw material compositions, emulsification conditions, and spray drying conditions for the preparation of flaxseed oil and safflower seed oil powders were optimized, and the final encapsulation efficiency was as high as 99% with approximately 50% oil loading. The storage stability experiments showed that oil powder’s stability could maintain its physicochemical properties over six months. Oral supplementation of the spray-dried flaxseed oil powder exhibited a significant and better effect than flaxseed oil on alleviating colitis in C57BL/6J mice. It suppressed the pro-inflammatory cell factors, including IL-6 and TNF-α, and repaired gut microbial dysbiosis by increasing the microbial diversity and promoting the proliferation of probiotic taxa such as Allobaculum. This work suggests that spray-dried flaxseed oil powder has great potential as a nutraceutical food, with spray drying being a good alternative technique to improve its bioactivity.