Effect of TiO2 on PVDF/PMMA composite films prepared by thermal casting

Atypical methods for characterization of used photovoltaic panels during their pre- and Post-Thermal treatment assessment

The study presents an innovative approach to the analysis of waste silicon photovoltaic panels prior and after thermal treatment. Using laser-induced breakdown spectroscopy (LIBS), the elemental composition of multilayered panel backsheets was determined, identifying a TiO2-containing coating laminate, a polyvinylidene fluoride (PVDF) layer, and an ethylene vinyl acetate (EVA) encapsulant, while also estimating their thickness. Identifying the fluorine-containing layers allowed their selective removal and safe processing of the used panels. Thermal processing parameters such as temperature (400-550 °C), time (5 - 60 min) and orientation of the busbar relative to the heat source were optimized based on contact angle measurements and CIELAB color space analysis, techniques used to detect organic residues in recovered glass and silicone. The decomposition process was examined by thermal analysis coupled with mass spectroscopy, which revealed that there were no volatile fluorine compounds in the gases released, although fluorine was detected on the recovered glass surface by SEM - EDS examination. After the PVDF layer was removed, fluorine compounds were not found in volatile gases or on the surface of recovered inorganic materials. The study indicated that the orientation of the busbars facilitates the decomposition of organic matter. Methods for reusing recovered secondary materials were also provided, suggesting the potential applications and benefits of recycling components from silicon photovoltaic panels.

Electroconductive Composites from Polystyrene Block Copolymers and Cu-Alumina Filler

Technological advancements and development of new materials may lead to the manufacture of sustainable energy-conducting devices used in the energy sector. This research attempts to fabricate novel electroconductive and mechanically stable nanocomposites via an electroless deposition (ELD) technique using electrically insulating materials. Metallic Cu is coated onto Al₂O₃ by ELD, and the prepared filler is then integrated (2–14 wt %) into a matrix of polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene-graft-maleic anhydride (PS-b-(PE-r-B)-b-PS-g-MA). Considerable variations in composite phases with filler inclusion exist. The Cu crystallite growth onto Al₂O₃ was evaluated by X-ray diffraction (XRD) analysis and energy dispersive spectrometry (EDS). Scanning electron microscopy (SEM) depicts a uniform Cu coating on Al₂O₃, while homogeneous filler dispersion is exhibited in the case of composites. The electrical behavior of composites is enhanced drastically (7.7 × 10⁻⁵ S/cm) upon incorporation of Cu–Al₂O₃ into an insulating polymer matrix (4.4 × 10⁻¹⁶ S/cm). Moreover, mechanical (Young’s modulus, tensile strength and % elongation at break) and thermal (thermogravimetric analysis (TGA), derivative thermogravimetry (DTG), and differential scanning calorimetry (DSC)) properties of the nanocomposites also improve substantially. These composites are likely to meet the demands of modern high-strength electroconductive devices.